Question about 1996 Toyota Tacoma

Open Question

Location of speed sensor/1996 toyota tacoma - 1996 Toyota Tacoma

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
short shadey
  • 421 Answers

SOURCE: location of the speed sensor on 1996 town & country

they are on the front drivers side of the transmisson and have two wires coming off them, there are two one is an input shaft sensor and the other is an output shaft sensor unless you have a 4 cyl van then there is only one sensor please rate -jeff

Posted on Sep 04, 2008

Ad
  • 1 Answer

SOURCE: toyota tacoma speedometer, odometer, tachometer not working

It is definitely the speed sensor assembly which hangs outside the transmission underneath the truck. Usually runs a little over $110

Posted on Jan 20, 2009

APACHEPARTS
  • 1 Answer

SOURCE: 1996 Toyota Tacoma wont start when the engine is hot and sits a few minutes

I RAN INTO A PROMBLEM MUCH LIKE THIS ONE ON A 98 S10 PU I OWNED. WHEN I DID A FUEL PRESSURE TEST IT WAS WITHIN SPECS BUT I DIDN'T DO A FUEL VOLUME TEST. WHEN YOU FIRST HIT THE KEY THE FUEL PUMP KICKS ON AND GAVE ME PROPER FUEL PRESSURE BUT WHEN I PULLED THE LINE AND HIT THE KEY IT BARELY SPIT OUT A 1/4 CUP OF GAS. I TRACED THE PROBLEM BACK TO BEING AN ELECTRICAL SHORT IN THE POWER SUPPLY TO THE PUMP.

OH AND BY THE WAY I AM FACING THE SAME EXACT PROBLEM ON OUR 96 TACOMA DELIVERY TRUCK. I'M GOING TO BE DOING THIS TEST HERE SHORTLY AND I WILL LET YOU GUYS KNOW WHAT I FIND OUT.

Posted on Oct 10, 2008

  • 7353 Answers

SOURCE: have p0130 and p0133 codes 98 toyota tacoma

I would check the O2 sensor, and if it checks bad, replace it, and clear the trouble codes. If the light comes back on, you may need to check further. .

Posted on Oct 28, 2009

  • 435 Answers

SOURCE: I need the location of the coolant temerature sensor on a 99 taco

Its at the rear of the engine, close to the firewall. Look at the intake part of the engine block for 2 wires that connect into the sensor plug. It is installed vertically.

Posted on Dec 06, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How do you replace the oxygen sensor on a 1996 Toyota Tacoma 4WD V6


Under vehicle, passenger side, below seating area, front of catalytic converter, mounted in exhaust pipe
Application:
Number one Buy what they call a special long socket made for removing oxygen sensors. It it only around 10 bucks and well worth it.

Apr 16, 2015 | 1996 Toyota Tacoma

1 Answer

Where is iat sensor on 2006 toyota tacoma 4.ol 4door located ?


This is the 2001-2012 Toyota Tacoma wiring diagram, Toyota Tacoma IAT (Intake Air Temperature) Sensor Location and the Toyota Tacoma MAF (Mass Air Flow) Sensor Location, also included is a pinout of the sensor. You are likely installing a performance chip or a cold air intake kit for increased HP (Horsepower). You will want to be sure to disconnect the car battery before adding performance products.




Here is the Toyota Tacoma's Iat sensor diagram:




ab0b7213-0c7f-459c-b26e-77a685236e74.jpg

Apr 14, 2015 | 2006 Toyota Tacoma

1 Answer

Where is the camshaft position sensor on a 1996 toyota tacoma 2.7 located.


Camshaft Position Sensor

1996 Toyota Truck Tacoma 2WD 2.4L EFI DOHC 4cyl

The Camshaft Position Sensor is located: Under hood, passenger side, front engine area, below valve cover, mounted in distributor

Oct 14, 2014 | 1996 Toyota Tacoma

2 Answers

My speedometer stop working what can i do to fix it


Causes...............

Faulty Vehicle Speed Sensor
- Vehicle speed sensor harness or connectors is open or shorted
- Vehicle speed sensor circuit poor electrical connection
- Faulty Engine Control Module (ECM)




The P0500 code is very common on the Toyota Tacoma, Toyota Yaris, Toyota Camry, Toyota Tundra, Toyota RAV-4. Before replacing the sensor you should try cleaning the sensor gear and erasing the code. If the light comes back you may have to replace the sensor.

Mar 12, 2014 | 1996 Toyota RAV4

1 Answer

97 tacoma vehicle speed sensor location check engine light p0500


On the early Tacoma, the speed sensor is located in the cluster and is driven by a cable attached to the transmission.
Later models moved the sensor to the transmission tailshaft or transfer case and eliminated the cable.
If you do not have a speedometer cable, your sensor is on the transmission.

Sep 13, 2013 | 1997 Toyota Tacoma

1 Answer

How to replace a speed sensor in a 2000 Toyota Tacoma


The speed sensor is located on the outside of the transmission case, it has a wire connector going to it. There are other sensors called turbine speed sensors and they are located inside the transmission. It all depends on what problem you have.

Jun 06, 2012 | 2000 Toyota Tacoma PreRunner

1 Answer

Toyota cavalier 1996 the abs light, how?


Toyota cavalier??? Chevy tacoma???
You might have a wheel sensor issue (part of the wheel bearing assembly) It tell the abs computer the wheel speed, and if one is bad, it will error the abs, and turn the light on. You can get this checked with an abs scanner hooked up, or ohm out all of your speed sensors with a meter.

Jun 23, 2011 | 1996 Chevrolet Cavalier

2 Answers

1996 Toyota Tacoma wont start when the engine is hot and sits a few minutes


Found this solution and it worked for me on my 1996 Toyota Tacoma and fixed the problem you described...!!! Here it is --------"I Hope You All Appreciate This FAST and EASY Inexpensive Repair That Even The Toyota Dealers Dont Seem To Know How To Fix !!! The Problem Is The Air filter temp sensor. Look On The Left Side Of the Air Filter Housing and Disconnect The Plug Thats Attached To The Spark Plug Like Plastic Sensor Mounted on The Side Of the Air Filter Housing, Now Go Start Your Truck !!! Your Truck Will Start And RUN Fine Now ! Replace The Sensor Approx $59 at Autozone... This Should Fix 90% Of Your Problems If your In the other 10% and it does not Fix it , Email Me and Ill See If I Can Help ! People Have Spent Hundreds and into The Thousand Dollar Area Trying to Resolve This Intermittant Problem At Inept Shops with Illiterate Mechanics ! If Your Happy With This Fix, BE Generouse ! I Do Accept Donations at Paypal Send to donsgirl89@yahoo.com Thank You JOE Mechaniac"
The answer (above) came from this link and was posted by joe the mechanic on this thread
http://www.fixya.com/cars/t890232-1996_toyota_tacoma_wont_start_when

Jan 12, 2009 | 1997 Toyota Tacoma

1 Answer

Toyota tacoma speedometer, odometer, tachometer not working


It is definitely the speed sensor assembly which hangs outside the transmission underneath the truck. Usually runs a little over $110

Jan 11, 2009 | 1998 Toyota Tacoma

Not finding what you are looking for?
1996 Toyota Tacoma Logo

Related Topics:

657 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8557 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...