Question about 2003 Chevrolet S-10

2 Answers

What are codes p0101 & p1153 - 2003 Chevrolet S-10

Posted by on

2 Answers

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    President:

    An expert whose answer got voted for 500 times.

  • Master
  • 749 Answers

  • P0101 - Mass Air Flow (MAF) Sensor Performance
  • P1153 - Heated Oxygen Sensor (HO2S) Insufficient Switching Bank 2 Sensor 1
  • Posted on Mar 20, 2011

    • Level 2:

      An expert who has achieved level 2 by getting 100 points

      MVP:

      An expert that got 5 achievements.

      Governor:

      An expert whose answer got voted for 20 times.

      Hot-Shot:

      An expert who has answered 20 questions.

    • Expert
    • 50 Answers

    P0101 CODE =MASS OR VOLUME AIR FLOW CIRCUIT RANGE
    p1153 code =
    h02 insufficient switching bank 2 sensor 1

    Posted on Mar 20, 2011

    • Kevin Berta Mar 20, 2011

      * Inspect for the following conditions:
      An incorrectly routed harness--Inspect the harness of the MAF sensor in order to verify that it is not routed too close to the following components:
      - The secondary ignition wires or coils
      - Any solenoids
      - Any relays
      - Any motors
      * A low minimum air rate through the sensor bore may cause this DTC to set at idle or during deceleration. Inspect for any vacuum leaks downstream of the MAF sensor.
      * A wide open throttle (WOT) acceleration from a stop should cause the MAF sensor g/s display on the scan tool to increase rapidly. This increase should be from 6-12 g/s at idle to 230 g/s or more at the time of the 1-2 shift. If the increase is not observed, inspect for a restriction in the induction system or the exhaust system.
      * The barometric pressure (BARO) that is used in order to calculate the predicted MAF value is initially based on the MAP sensor at key ON.
      * When the engine is running the MAP sensor value is continually updated near WOT. A skewed MAP sensor will cause the calculated MAF value to be inaccurate. The value shown for the MAP sensor display varies with the altitude. With the ignition ON and the engine OFF, 103 kPa is the approximate value near sea level. This value will decrease by approximately 3 kPa for every 305 meters (1,000 feet) of altitude.
      * A high resistance on the ground circuit of the MAP sensor can cause this DTC to set.
      * Any loss of vacuum to the MAP sensor can cause this DTC to set.

    ×

    1 Suggested Answer

    6ya6ya
    • 2 Answers

    SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

    Hi,
    a 6ya expert can help you resolve that issue over the phone in a minute or two.
    best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
    the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
    click here to download the app (for users in the US for now) and get all the help you need.
    goodluck!

    Posted on Jan 02, 2017

    Add Your Answer

    Uploading: 0%

    my-video-file.mp4

    Complete. Click "Add" to insert your video. Add

    ×

    Loading...
    Loading...

    Related Questions:

    4 Answers

    Code p0153..p1153


    Rowland, Code p0153 Faulty oxygen sensor.
    http://www.obd-codes.com/p0153
    Code p1153 Probale faulty oxygen sensor.
    PCM detect less than 55 lean to rich or rich to lean switches
    P1153 OBD Trouble Code

    Check the attached links,instruction and guides, Good luck
    "I hope this helped you out, if so let me know by pressing the helpful button. Check out some of my other posts if you need more tips and info."

    Mar 21, 2016 | GMC Cars & Trucks

    2 Answers

    My 2006 chevy malibu doesn't want to shift gears codes P0121 & P0101 & P0420 transmission place said it's not the transmission.


    P0101....Mass or Volume Air Flow Circuit Range/Performance Problem
    P0121 - Throttle Position Sensor/Switch A Circuit Range/Performance Problem.
    P0420 - Catalyst System Low Efficiency
    there is criteria that enable trans shift
    solve codes problems then transmission will shift normaly

    Dec 14, 2014 | 2006 Chevrolet Malibu

    1 Answer

    1998 Chevrolet 1500 v6 code p1153 & p0327


    P1153 = Bank 2 Fuel Control Shifted Lean
    P0327 = Knock Sensor 1 Circuit Low Input (Bank 1 or Single
    Sensor)

    Info obtained on: http://www.troublecodes.net/OBD2/Pcodes/

    Mar 19, 2014 | Cars & Trucks

    1 Answer

    Code p1153


    P1153 OBD Trouble Code.P1153 - Acura
    Cause. Exhaust system, wiring, HO2S, ECM
    P1153 - GM
    Location, Bank 2 Sensor 1. Cause. No ECT, EGR, EVAP, Fuel

    Aug 18, 2013 | Cars & Trucks

    1 Answer

    Code p0068 & p0101


    both codes are for maf sensor is it plugged in

    Dec 07, 2012 | 2006 Pontiac Grand Prix

    1 Answer

    Error codes 1133 & 1153 1998 chevy blazer


    code P1133 is for a problem with 02 sensor bank one sensor one. this is the left 02 sensor in front of the cat. converter. code P1153 is for a problem with 02 sensor bank 2 sensor 1, which is located on the right side of engine in front of the cat. converter

    Jul 07, 2011 | Chevrolet Blazer Cars & Trucks

    1 Answer

    P1153 insufficient switching p0700 1996 tahoe


    P0700 - Transmission Control System Malfunction, clear the code and see if it comes back, all this code is, is the TCM (trans control module)
    telling the check engine light to come on for a possible trans fault, many times it is a false code and means nothing is wrong unless it has another trans code stored with it like a shift solenoid for instance.

    P1153 - Heated Oxygen Sensor (HO2S) Insufficient Switching Bank 2 Sensor 1, You would be pretty safe to assume the O2 sensor for cylinder bank 2 ahead of Cat converter is defective.Bank 2 is the side opposite the bank that #1 cylinder is located in.

    Apr 13, 2009 | 1997 Chevrolet Tahoe

    1 Answer

    Diagnostic codes 97 tahoe 4d 4wd 5.7


    p1460 cooling fan circuit,p1153 ho2s insufficient switching bank 2 sensor 1,p1133 insuf. swit. sen. 1 or bank 1 sen. 1,p420 catalyst system efficiency below threshold bank 1,p152 o2sen. circuit high volt. bank 2 sen.1

    Feb 24, 2009 | 1997 Chevrolet Tahoe

    Not finding what you are looking for?
    2003 Chevrolet S-10 Logo

    1,701 people viewed this question

    Ask a Question

    Usually answered in minutes!

    Top Chevrolet Experts

    yadayada
    yadayada

    Level 3 Expert

    75744 Answers

    Colin Stickland
    Colin Stickland

    Level 3 Expert

    22114 Answers

    Jeff Turcotte
    Jeff Turcotte

    Level 3 Expert

    8123 Answers

    Are you a Chevrolet Expert? Answer questions, earn points and help others

    Answer questions

    Manuals & User Guides

    Loading...