Question about Ford Fusion

1 Answer

Rough tickover ford mondeo 1.8 hunting. - Fusion Ford Cars & Trucks

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

Temp sensor maybe

Posted on Nov 27, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Engine has rough engine at 1250 revs, tickover is fine and over that is ok too, sometimes cuts out at junctions


Start with cleaning the throttle body, idle air control motor, and MAF sensor. After that, tune up.

Sep 24, 2016 | 2003 Ford Focus

1 Answer

Black smoke when going up hill


blac smoke means valve guides or rings are worn-u wud need a rebuild in time--but 1st try sae straight 40wt oil or some additive like lucas or othr thickener----also a tuneup w new plugs/cables--distributr/coil may help or some professional injector cleanin

Apr 01, 2014 | 2003 Ford Mondeo

1 Answer

2014 Ford Focus ST rough idle


Hi, You need to clean out the Throttle body with cleaner. Also the idle air control.
Check also for vacuum leaks. Good luck

Mar 21, 2014 | 2014 Ford Focus ST

1 Answer

90 f150 rough idle in park and neutral. drive fine.


Hi, Seems like a possible inlet air leak or to low engine revs, tickover rpm to low.outside chance engine oil to thick, try lower vicousity engine oil. this sometimes works with a rebuilt motor. Could be engine is just still tight from rebuild,1-2000 miles running in should cure this. if still low mileage.

Jan 23, 2012 | Ford Cars & Trucks

1 Answer

I wish to adjust the idle tickover speed a wee bit on a 2007 Ford Transit 2.2 Duratorq engine. It is currenlty ticking over at approx 800 rpm and is hunting at this rev. If I could raise it a wee as I do...


First ensure that the throttle interior is really clean, a surface layer of grime can upset the ECU's ability to meter and govern the air entering the engine. If the throttle body interior is found to be really oily and dirty check on the idle air control valve and make sure that it too is cleaned up. Next put the ignition switch in position 2 (on, but no start) and depress the accelerator fully and release. If there is an issue with the throttle position sensor this procedure can help the ECU relocate the throttle plate position. Start the engine and if it is still hunting locate the air mass meter (AMM) on the air ducting immediately next to the air filter and disconnect the electrical connection. Does this remove the hunting aspect?... the rev speed might change but for the moment concentrate on the evenness of the tick-over. If the idle is even when the AMM is disconnected but hunts when connected then look at replacing your AMM. Try spraying the AMM with no residue electrical cleaning spray to see if this improves matters.

Dec 02, 2010 | Ford Transit Connect Cars & Trucks

6 Answers

I NEED A RADIO CODE FOR A FORD MONDEO


I HEED A RADIO CODE FOR A FORD MONDEO
Pulled wrong fuse out, now I need a radio code for my Ford Mondeo serial number
M 320656
Many Thanks.

Nov 19, 2009 | 2000 Ford Focus

1 Answer

Ford Taurus: rough idle in drive and reverse


it could be that the tick over is two slow in brive,,,
set it up to tickover at 850,,950 rpm (in drive)
or it could be a gear box fult like the drive plate has a crack in it,,,letting the torque converter slap about,,,
chech tick over first,,, bont adjust tick over in gear unless the brakes are held hard on,,,

Oct 31, 2009 | Ford Taurus Cars & Trucks

1 Answer

Revs ''hunt'' on tickover, sometimes revs drop so low car cuts out


Thanks to some advice I have fixed the problem with my Granada. The pipe work from the exhaust manifold to the inlet manifold has a short piece of plastic pipe which needed replacing. This seems to have done the trick.

I would like to thank you for running this site. Without it I would still be re-starting my car each time I stop at a red light!

Jan 16, 2009 | 1978 Ford Granada

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

332 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

60769 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Fordexpert

Level 3 Expert

5331 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...