Question about 1998 Isuzu Rodeo

2 Answers

Brake light works sometimes and sometimes it doesn't.

Posted by on

2 Answers

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 2 Answers

Is it your ABS light? I have a 1998 Rodeo, and there was a recall on it. I took it in; they did the work, and now the ABS light has remained off.

Posted on Aug 08, 2008

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 124 Answers

There is a switch mounted just above brake pedal, check that it is not sticking when you press pedal.

Posted on Aug 03, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

1998 dodge Dakota Ok so I just got this truck and when I got it the abs light and brake light were on plus the speedo doesn't work sometimes I replaced the rear speed sense on the diff but the lights...


If the red brake light and the ABS light are both lit up on the dashboard, do NOT drive the vehicle. It indicates a major malfuntion with the brake system. The red light indicates low brake fluid or the parking brake engaged. The yellow ABS without the red light, indicates a problem the computer found and it disables the ABS system while still having conventional brakes. Since both are lit, it needs the brake system repaired. What you replaced on the rear diff was probably the rear ABS sensor. The vehicle speed sensor for the speedometer should be located on the rear of your transfer case if you have 4WD, or on the rear of the trans if you have 2WD.

Oct 11, 2012 | Cars & Trucks

1 Answer

Left brake light works right brake light does not


take a test light and make certain your getting power to the socket. could be a bad socket

Aug 02, 2012 | Buick Century Cars & Trucks

1 Answer

I have a 2006 is250 lexus push button start and it only starts sometimes....radio, lights, nav everything works but it won't crank....takes 3-4 times before it cranks and it doesn't happen eve


The first thing you want to check for is the brake signal,without this signal it will not crank,this is the easy one make sure you get brake light,the second is to have the starter tested by a direct method,this gives the indication of the health of the starter

Mar 22, 2012 | Lexus IS 250 Cars & Trucks

2 Answers

Why would the break light in my car be coming on? It doesn't do it all the time. My breaks are working fine. No grinding or anything. It will just beep and come on sometimes while Im driving. I have a...


The warning brake light has a dual purpose. Check your brake fluid and check your brake light bulbs. If it is low on fluid, it will trigger the light. If the bulb is lose or weak, it will also trigger the light. Good luck!

Aug 30, 2011 | 2002 Dodge Stratus

1 Answer

Suddenly, No tail lights, brake lights, turns signal or back up lights At 83000 miles, 6 months ago, replaced head gaskets. 1 week later, service engine soon light came on. Tech said it was an oxygen...


just look for the blackened/burned pin on the rear light plastic connector and sand it down to re-establish a good electrical connection and save yourself $800 big ones on replacing the multiswitch.

Jun 26, 2011 | 1999 Chevrolet Venture

1 Answer

6 months ago, replaced head gaskets. 1 week later, service engine soon light came on. Tech said it was an oxygen sensor. Cleared code. 3 weeks ago, got oil change, replaced headlights and replaced...


CHECK TURN SIGNAL FUSE.IT COULD BE BLOWED OR YOU HAVE FAULTY TURN SIGNAL SWITCH.BECAUSE BACK LIGHTS AND TAIL LIGHTS SHARE SAME CIRCUIT WITH TURN SIGNAL SWITCH.

Jun 26, 2011 | 1999 Chevrolet Venture

1 Answer

After having my 2006 santa fe serviced at 60000 miles, my cruise control doesn't work. I had it lubed, radiator flush, oil change, brakes checked, timing belt replaced, water pump replaced.


Try checking all of your rear brake lights to see if they are working.If you have a burned out bulb the control cannot complete the circuit and the cruise will not work. Dont forget the third brake light sometimes have more than one bulb in them so check closely to make sure that all bulbs are good.

Jun 11, 2011 | 2006 Hyundai Santa Fe

1 Answer

I own a 2001 dodge dakota 4x4, my brake lights wont work, I have park lights, turn signals, back up lights, even 4 way flashers, I replaced the brake unit on the brake pedal, and checked all fuses, they...


Hi,

When you say you checked the fuse, was this just a visual check....or did you try replacing the fuse the a new one? Sometimes a visual check doesn't show minute breaks in the fuse wire, which gives a false appearance that the fuse is fine.

When the fuse is ok, this problem normally relates to the brake switch (mounted to the brake pedal). When this switch is replaced, you should always use a multimeter and check the switch is operating correctly when touching the brake pedal.

If the switch is ok, then suspect a faulty relay (if applicable to the Dakota).


Cheers,

May 14, 2011 | Dodge Dakota Cars & Trucks

Not finding what you are looking for?
1998 Isuzu Rodeo Logo

Related Topics:

259 people viewed this question

Ask a Question

Usually answered in minutes!

Top Isuzu Experts

yadayada
yadayada

Level 3 Expert

60769 Answers

Steve Hurc
Steve Hurc

Level 3 Expert

450 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Are you an Isuzu Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...