Question about 1988 Subaru XT6

1 Answer

My subaru is overheating

I put a new thermostat and still overheats shop said it looks and sounds ok but it overheats

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 2 Answers

Check for any air locks,bleed cooling system,also check cooling fan cutting in,if not check fuse and relay for fan and fan motor,if system is pressurising suspect head gasket blown.

Posted on Aug 02, 2008

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

3 Answers

What might the issue be with my 2002 dodge caravan overheating?


Hi, No you did not break anything. It just happened by coinsident.
You need to replace the thermostat and put new fluid in. Not just water. If it happens again do a radiator flush and check if fan is working properly. Good luck.

Jan 07, 2015 | 2002 Dodge Caravan

1 Answer

Overheating


Possible sticking thermostat (probable) but you could have a fan thermostat going bad also if it has an electric fan, next time it starts over heating look under hood and see if the fan on the radiator is spinning, if not it or the thermostat for it could be bad

Feb 17, 2012 | 1997 Subaru Legacy

2 Answers

1990 subaru legacy- overheats, I"ve


Most likely you put the thesmostat in upsid down. Good luck

Aug 17, 2011 | 1990 Subaru Legacy

2 Answers

My 1997 subaru impreza overheats


Could be a couple of things, did they check to make sure the fans were bad before changing them? (trial and error is very expensive if you pay a shop for it). Your thermostat could be bad (not opening) your water pump too (would make this a last thing due to cost to replace). And possibly even your fan relays/relay sensor. When your needle gets high does the cooling fan(s) come on? They should. If they are not coming on then check those little things first. You may have replaced fans that were good. i would also try another shop for diagnosis. Those are small things your shop should have checked first.

Aug 09, 2009 | 1997 Subaru Legacy

3 Answers

90 subaru legacy overheats, wheres the thrmostat


When a car overheats it's rarely the thermostat. They just don't go bad that often. If it overheats when you idle a lot, it's the fan and with electric fans, it's almost always the fan motor. But to find the thermostat, follow the top radiator hose to the engine and there it is.

Aug 01, 2009 | 1990 Subaru Legacy

1 Answer

'90 Subaru Legacy overheating....


cool air and overheating point to low coolant level. Do you have a bleeder valve near the thermostat? You may have air trapped in the system. If no air trapped, the radiator may be plugged up not allowing proper circulation of coolant.

Mar 24, 2009 | 1997 Subaru Legacy

1 Answer

Troubleshooting overheating problems in 1997 Toyota Corolla?


Ok first check the water pump and if that is ok sounds like the head gasket blown, look for water in the oi, thisl will be like a milky colour

Dec 01, 2008 | 1997 Toyota Camry

1 Answer

1990 Subaru Liberty Overheats


Hi,

I had the same problem with my 1993 Liberty LX. Remove the thermostat (located inside bottom radiator hose engine connection - take the connection off and thermostat is inside). Reassemble (minus thermostat), reconnect bottom hose. Slowly (very, very slowly) refill the radiator and remove the bleed plug ( located beside the top hose connection to the radiator - a black square plug with a phillips head cross in the middle). When the radiator is full and clear water (no air bubbles) is coming out of the bleed point, replace the bleed plug and then the radiator cap.

Run the engine for five minutes (approx) or until normal engine temperature is reached. Allow the engine to cool down and recheck the water level - fill if necessary ensuring that the bleed plug is open and clear water is coming out of that point. Replace Bleed plug and then radiator cap. Run engine for five minutes (approx) and then test dive. If the engine overheats keep filling the radiator until there are no air bubbles coming from out of the bleed point.

This fixed my overheating problem. Good luck and safe motoring.

Aug 06, 2008 | 1993 Subaru Legacy

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

433 people viewed this question

Ask a Question

Usually answered in minutes!

Top Subaru Experts

yadayada
yadayada

Level 3 Expert

70365 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22041 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6878 Answers

Are you a Subaru Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...