Question about 2004 Ford Freestar

1 Answer

Windsheild wipers donot turn on at all - 2004 Ford Freestar

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Ford Master
  • 3,018 Answers

You might want to check the fuse in the fuse panel box under the dash on the drivers side. That is usually the culprit.

Posted on Mar 19, 2011

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Chevy Venture 1999 Turn on the windsheild wipers nothing happens nothing even tries to happen except the radio goes off. Use the cruise control radio goes off but cruise works. Replaced the windsheild...


Learn how to test electrical circuits ! Find a wiring diagram so you know which wires to test . Free wiring diagrams here http://www.bbbind.com/free_tsb.html Enter vehicle info. year , make , model and engine size . Under system click on body & accessories , then under subsystem click on wipers / washers .Check B+ voltage and ground circuits .
Wiper Motor Switch Troubleshooting
Windshield Wiper Motor Wiring Tutorial

Aug 22, 2017 | 1999 Chevrolet Venture

1 Answer

Windsheild Wipers will not move, the arm seems to be slipping on the motor shaft,


It sounds like you live in a climate were snow and ice occurs. If so a lot of people leave their wipers on upon shutting off their cars. If you happen to do that and the windsheild had moister on it or if the snow starter falling while your vehicle was still warm it will freeze. The larger the snow amount the stronger the force will be if you start your vehicle up the next morning with your wipers buried in frozen ice & snow. Since the wipers were not shut off the wiper motor will run and the wiper blades will not. This will strip the linkage the wiper arms press onto leaving you with out working windsheild wipers

Jan 27, 2010 | 2003 Chevrolet Tahoe

1 Answer

Windshild wipers stop intermittingly seems to


your windsheild wiper problem is the wiper module. replace the windsheild wiper module and you'll fix this problem.

Jan 21, 2010 | 1997 Chevrolet S-10 Pickup

1 Answer

Cold weather wiper problem


Dear joelgoodison,

Could be the Fuse!
Could be the Wiper Motor Burn't Out if Blades were frozen to windshield when turned on
Until you fix the problem you can buy RainX Wipe-On Glass Solution or Windsheild Washer Fluid which as unbelievable as it sounds will allow you to drive in the all but the worst downpours of rain without wipers!
I love the RainX Windsheild Washer Fluid and rarely use my wipers.
Check the fuses and try RainX and get back to me!
Hope this Helps!
jack
0c34737.jpg

Feb 06, 2009 | 1996 Volkswagen Golf

2 Answers

Windsheild wipers


take off the end caps of the wipers loosen the bolts and put them where they should be tighten back up try your wipers again should be good as new/ Pleasr rate my response thank you vvery much

Jan 08, 2009 | 1997 Buick Century

1 Answer

1991 chrysler lebaron windsheild wipers will not shut off


i think the switch could have got jamed to the on position u may have to replace it to git them to turn off for now there should be a fuse for them pull it

Jan 05, 2009 | 1991 Chrysler LeBaron

1 Answer

Wiper arm assembly mechanism


I THINK YOU SHOULD TURN OFF WIPERS TAKE WIPER ASSEMBLY OFF PUT BOTH ON AT LOWEST POINT ON WINDSHEILD, TRY THAT.

Sep 05, 2008 | 2001 Hyundai Sonata

1 Answer

Wipers


You have two problems. The first is the wipers turn off and stay in the upright position and do not close. The motor is fine. There is a steal 'close' tab that has been bent out of position. You just need to push the steal tab back into position. You can use a chisel or screwdriver to pound it back into the 90 degree position.

The windsheild washer motor probably needs to be replaced

Jul 07, 2008 | 2001 Pontiac Grand Prix

Not finding what you are looking for?
2004 Ford Freestar Logo

Related Topics:

93 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

75817 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

fordexpert

Level 3 Expert

5495 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...