Question about 1992 Chevrolet C1500

2 Answers

1992 Chevrolet W/T 1500 Pickup Heater A/C module dead need complete ( clear) schematics, how is the module fused I jumpered the lo-pressure A/C switch accdently shorted it.

Posted by on

  • 1 more comment 
  • Richard Robson Mar 19, 2011

    I have the manual ( no A/C schematics ) I'm an EE am mad that a simple solution is not available I know the connector number (230) but no piin out of it
    I have seen many requests for the same problem I have

  • Richard Robson Mar 19, 2011

    I have seen on your site alone many questions about the same problem, all I need is the pin out for connector (230) along with a schematic of the Heater A/C module.
    I have the manual and there is nothing in it about the A/C system
    Thanks Rich

  • Richard Robson Mar 19, 2011

    Tired of waiting
    The site and many others have the same question
    I accidently shorted out the Lo-Pressure sensor and popped a fuse-link maybe, I have the Chilton manual it has no schematics of the A/C system, Have checked the fuse panel and need a pin out of the connector (230) for the Heater A/C controller. I would like a techinical awnser to my question I am a EE

×

Ad

2 Answers

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Top Expert:

    An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

  • Chevrolet Master
  • 76,070 Answers

We do not have any diagrams here at fixya, you can obtain those at a site called www.alldatadiy.com

Posted on Mar 20, 2011

Ad
  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Master
  • 2,382 Answers

Hi, the best way to get a schematics for your truck is to buy a Haynes manual (about $25) for your truck at the auto part store. It'll give you a lot more than just the schematic.

Posted on Mar 19, 2011

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

1992 gmc 1500 where is the power door lock module located


This is a TSB on your vehicle.
Power Door Lock Actuators May Fail on Chevrolet/GMC 1500 Pickup Problem Description and Possible Solution The power door lock actuators may become slow to operate or stop working completely and require replacement

Jun 23, 2016 | GMC Cars & Trucks

1 Answer

1991 chevy pickup not shifting


b85f3b28-0a87-431e-bab0-3cb80e429a6c.jpgT.C.M. MODULE & WIRING HARNESS. GMC. $ 147.49 Chevrolet C1500 2WD PICKUP, 1991, 1992, 1993. Chevrolet ,you can see clearly what you need!
Watch out because not necessarily is the TCM,If you put more details may be we are able to help you out!

May 29, 2013 | 1991 Chevrolet C1500

1 Answer

My 1990 1500 chev with throttle body injection system has no power to the fuel pump fuse or relay is the circuit completed through the oil pressure switch and if so where is the switch located


On the v-6 engines the oil pressure switch feeds the fuel pump. I'm not sure about your 1500. You didn't say what engine you have, so I will assume it is a v8. The oil pressure switch should be behind the distributor, near the firewall. You can use a paperclip as a jumper in the electrical connector that goes to the oil pressure switch. If it's the switch or low oil pressure, the jumper should complete the circuit and energize the fuel pump.

Jan 09, 2011 | 1991 Chevrolet Silverado 2500

1 Answer

Sparkplug firing order 1992 1500 pickup


1992 Chevrolet K 1500 P/U 4WD 4.3 liter V-6 VIN "Z"

496b8b6.gif


1992 Chevrolet K 1500 P/U 4WD 5.7 liter V-8 VIN "K"
and
1992 Chevrolet K 1500 P/U 4WD 5.0 liter V-8 VIN "H"

5c43dee.gif


Hope helps (remember rated this).

Aug 04, 2010 | 1992 Chevrolet K1500

1 Answer

Not getting fire from coil 1992 1500 pickup z71


bad ignition control module,which is held by 2 screws under the distributor. when the di electric grease dries out on these,they cause a no spark condition. replacements cost around 35 bucks at auto zone,and take less than 5 min ti install.

Apr 30, 2010 | 1992 Chevrolet K1500

1 Answer

How to install a 1992 chevy pickup camshaft sensor 1992 chevy pickup 1500 z71 and where is it located? i have no spark coming from my coil so this is my next task? any other answers?


There isn't a camshaft sensor. The distributor has a control module and a pick up coil inside of it, 1 or both could be bad, it's usually best to replace both. Some parts stores can test them. The is also an Electronic Spark Control Module. I would check the pick up coil and control module.

Apr 30, 2010 | 1992 Chevrolet K1500

2 Answers

How to set timing on 1992 toyota pickup 4 cyl.


OK THE SETTING IS 5 DEG BEFORE TOP DEAD CENTER BUT YOU HAVE TO JUMP OVER TE1 AND E-1 IN FUSE BOX IN ENGINE COMPARTMENT THIS GROUNDS IGN SYSTEM. TAKE BACK OFF AFTER AJUSTMENTS COMPLETED

Feb 11, 2010 | 1992 Toyota Pickup

1 Answer

A diagram of how to install a heater fan in a 1992 pickup


well its an easy replacment unhook the power and ground wires on the motor remove the bolts and remove the motor install the new one

Jan 11, 2009 | 1991 Chevrolet K1500

1 Answer

2000 silverado pickup


I would need more information to really help you. There are many possibilities. could have bad injector shutting down computer to keep from burning up the drive in it. May have bad module that controls spark. Need to know if there is spark at the plugs. Does it have injector pulse. Is fuel pump working do you have pressure and how much!

Nov 01, 2008 | 2000 Chevrolet Silverado 1500

3 Answers

2004 Chevrolet Silverado Heater/AC Blower on without Ignition ON


there is no relay for the heater fan it's a 15 amp fuse and is on the accessories circuit. the reostat is responsible for all 3 speeds .with the key off there should be no voltage to the blower motor whether the fans speed fan switch is on or off. the fuse will be located in the fuse paneleither on the drivers left side in the dash or underneath the dash in the fuse block. you have a short in the harness that is under the dash and most likely it's a bad plug on the harness. your going to have to do some searching but that's where the problem short is... please rate

Oct 03, 2008 | 2004 Chevrolet Silverado 1500 Crew Cab

Not finding what you are looking for?
1992 Chevrolet C1500 Logo

Related Topics:

190 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

76070 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8266 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...