Question about 1998 Chevrolet Suburban

1 Answer

At a complete stop and start to take off and the rear of truck makes a medum size bang sound

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 161 Answers

Sounds to me like it may be a bad u-joint have it reeplaced imediately.they wreck alot if they failand driveshaft drop....

Posted on Mar 19, 2011

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Why does my car not move from a stop until I rev it up and then it kicks in like being rear ended?


Failed Transmission

That happens frequently, when you do not change trans
fluid every 3 years,power steering will fail next,(No Fluid Flushing)

I would have it checked for electronic issues before anything else

Since you continue to use it & it neutrals out & bangs into gear,you
ruined any chance to escape a complete rebuild, from my experience as a former trans shop owner

May 15, 2014 | 2004 Buick Rendezvous

1 Answer

Banging or thumping noise on right hand rear side near tailgate


check the top runner on the tailgate on the outside to see if damaged. if not that then check the molds around the gate

Mar 04, 2014 | GMC Envoy Cars & Trucks

1 Answer

Tried to start car and it was starting to crank over then started getting this clicking noise. thought it was the battery connection, I cleaned the cables and posts and still got clicking noise when...


celunoid ?? SOLENOID ! Could be starter , test ! VOLTAGE DROP TESTING .

Starter Voltage Drop

What size engine ???
Starter Motor, 4.6L C1020
Lower right side of engine
Starter Motor, 5.4L C1020
Lower right side of engine


Starter Motor Relay, 4.6L C166
Right rear of engine compartment
C167
Right rear of engine compartment
Starter Motor Relay, 5.4L C166
Right rear of engine compartment
C167
Right rear of engine compartment

Jun 23, 2017 | 1999 Lincoln Navigator

1 Answer

Chevy tahoe rear wiper starts when brake applied


It sounds like a ground issue like the insulation is warn and making contact some ware more than likely around the back door

Feb 04, 2013 | Chevrolet Cars & Trucks

1 Answer

2002 ram 1500 5,9 4x4 hesitates and makes a banging noise when it finally switches back into 2 wheel drive


While the driveshaft and u-joint suggestions all sound like good places to start, because of the way you describe, I have a few questions. Is the truck stock? Height, tire size, did you change hubs etc...? Do you take the truck off road? In mud, sand trails...? Do you ploiw or tow? Do you maintain the driveline according to the useage?Is the hesitation due to it getting stuck in neutral (in the transfer case)? Does the truck make the same noises shifting into neutral or 4 whl hi to low? Are you moving when you shift it? If you come top a complete stop, shift trans to neutral, shift from 4x4 to 4x2, does that change anything? Any other info would be helpful to try and narrow the issue.

Jan 16, 2012 | Cars & Trucks

2 Answers

I have done shocks bilsteins front sway bar eibach brakes diff gasket and cover performance stering stablizer all tie rods all 4 bALLJOINTS NEW 20 INCH RIMS AND BRAND NEW TIRES FUTERA GOODYEARS 3 DIF...


I can think of two things not easily seen that can cause a banging when hitting small bumps;
The sway bar end links could be loose or broken.
The rear shock bolts, the lower bolt that holds the shock onto the rear axle, I've seen that mounting hole down there get enlarged, allowing the shock bolt to move about when hitting small bumps, causing a banging sound.
Check those two things out.

Sep 09, 2011 | Jeep Grand Cherokee Cars & Trucks

1 Answer

We have a Golf TDI 2005 - bought in New Zealand. The car has had two episodes of having a loud 'spronging' noise start, then stop. It sounds like like something repeatedly banging on a hollow pipe while...


think you have a shock absorber problem ,they can break inside well not exactly break but a valve sticks causing the vehicle to bounce more which you didnt notice but no doubt it happened then when bounced on the level crossing it freed itself again .Very rare but i have seen it before ,took ages to diagnose

Jan 04, 2011 | Volkswagen Golf Cars & Trucks

1 Answer

When coming to a full stop in my tahoe i hear a banging from tran


The trans have issues. If it is a 4 speed automatic. I have seen dozens over the years with failing gear sets making clunks and noises.

Take it in soon.

Apr 06, 2009 | 2007 Chevrolet Tahoe

Not finding what you are looking for?
1998 Chevrolet Suburban Logo

Related Topics:

31 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

77201 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22265 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...