Question about Cadillac Allante

1 Answer

Will not release when put in gear - Allante Cadillac Cars & Trucks

Posted by on

  • Marvin
    Marvin Mar 19, 2011

    What will not release?



1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points


    An expert who has answered 20 questions.


    An expert that hasĀ over 10 points.


    An expert whose answer gotĀ voted for 2 times.

  • Expert
  • 44 Answers

Remove the valve body, under the valve body there are channels , and then u test the boxes in tranmission by air, if all is ok change the valve body

Posted on Mar 19, 2011


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

2017 saturn ion clutch i can put car in gear and go if i do it while car is off after its started it will not go into gear

My best guess is that the release fingers on the pressure plate are bent, i had a geo metro that a dampner spring came out of its pearch and held the fingers from being able to release thuse not be able to put vehicle in gear while stopped unless engine shut off.

Dec 19, 2017 | Saturn Cars & Trucks

1 Answer

I have a E-ZGo -2five SUV and the automatic emergency brake has locked up. How do you unlock it. Jerome

try rocking it back ,and fourth .That may release it does it release when you put it in gear normally, or do you release it manually? If manual, look for springs that pull cable back when you release it, if it releases when put into gear look where lever releases cable. If unit has sat for awhile rust may have frozen brake parts...rocking may release it.

May 14, 2017 | Cars & Trucks

1 Answer

Kia grandsportage


Oct 05, 2017 | Ford Cars & Trucks

1 Answer

Can put into gear when running but when i release clutch and give gas truck dont move but i haer a low clunk sound, could it be my pressure plate or gears in my transmission?

if you can put it into gear release the clutch , no movement its more than likely the clutch assembly broken spring in the pressure plate , have you tried all gears also reverse if it goes into all gears no movement or if the sound get worse or goes away in different gear then I would say input shaft bearing , my bet is clutch assembly

Jan 04, 2014 | 1988 Ford Bronco

1 Answer

2006 chevy cobalt LT. the key is stuck

Have you tried shifting the gears completely through and then putting the car in park. It sounds like the car isn't able to be put completely in park to release the key. Try putting the car in N and removing the key. Even thought the car may not completely be in park to release the key, The gear most likely is in park but not enough to make the switch/sensor to release.

Jul 16, 2010 | 2006 Chevrolet Cobalt

1 Answer

1999 Buick Regal GS gear shift knob button is stuck to release

Check in your fuse panel. The top first row and the first fuse. I took that fuse out and had the same problem. My gear shift button was stuck. I put the fuse back in and it worked.

Mar 31, 2010 | 1999 Buick Regal

1 Answer

My 97 blazer wont go in gear

the trans receives a signal from a censer that tells it you have applied the break, which allows it to shift. do your break lights turn on when you push on the break?

Feb 21, 2010 | 1997 Chevrolet Blazer

1 Answer

Started the engine put car in gear, and released

First, try rocking the vehicle a little. If it still doesn't help, I know this sounds backwoods, but hit it in the center of the hub with a good sized hammer, and the brakes will release. This is common with mechanical handbrakes. (rear wheels only)

Feb 09, 2010 | 2005 Volvo XC90

1 Answer

Gear shift wont release when the brake is pushed

See if your brake lights are working you may have a blown stop fuse.
you can remove the small acsess panel by the shifter and put a somthing in the hole to manually release the shifter.

Sep 19, 2009 | 1993 Toyota Camry V6

1 Answer

Can't release handbrake cable

you eather put your foot on the brake and put it in gear and it pops out or you have a handle that releases it under the dash.

Aug 26, 2009 | 1996 Ford Escort 4 Door

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

23 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cadillac Experts


Level 3 Expert

81400 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Cadillac Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides