Question about 2007 Honda Pilot
Posted by Anonymous on
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
SOURCE: honda pilot blower motor stops
When you removed your motor, did you check in the area where the motor mounted to see if there was an obstruction? It could be a bit of insulation or paper... just a thought.
Posted on Aug 31, 2009
the honda pilots are all whee drive so there is nothing to lock in the trans mission does it on it's own. it uses sensors on the wheel to tell it when and whitch tire to put the power to.
Posted on Nov 12, 2009
This solution pertains to a 2008 Honda Pilot...To replace the cabin air filter which is located on the passenger side of the vehicle behind the glove box: Open glove box and remove stored items...while sitting in the passenger seat, pull towards you on each of the two clips on the left and right side of the glove box...this will cause them to become loose and the glove box will tip out completely exposing the inside of the dashboard. (Alternately...carefully pull towards you on the top center of the glove box which will cause the left and right side stops to pull away from the edges and allow the glove box to tip out) Here it gets tricky...the box holding the cartridge for the cabin air filter is the large black box on the left side behind the glove box The filter fits in a removable tray vertically inside that box. A pressure clip at the top of the box allows the vertical cover to be removed exposing the tray with the Cabin air filter... BUT!!! There is a plastic bar an inch or so high which has been placed there by the manufacturer to prevent most from changing the filter without the service department being involved. This bar must be cut with a sharp sheetrock knife or hacksaw and discarded, (it will not be reinstalled). Then there is a flat metal bar behind the plastic bar that can be removed using an 8mm socket and a phillips screwdriver. There are 2 8mm screws and one phillips head screw on each side that must be removed in order to remove the metal bar. THEN you can remove the cover to the cabin air filter box, pull out the tray with the filter (note how the filter is in the box so the new one can be placed the same way) reinsert the tray with the new filter and replace the tray cover. All other steps to finish the job are obvious as everything is the reverse. Actually the whole process is a lot of trouble and unless you are determined to change the filter I would recommend not doing it.
Posted on Apr 01, 2010
Tips for a great answer:
Sep 13, 2011 | 2004 Honda CR-V
Aug 28, 2011 | 2007 Honda Pilot
Feb 17, 2011 | 2006 Honda Pilot
Sep 30, 2009 | 2004 Honda Pilot
Aug 17, 2009 | 1999 Chevrolet K1500
Apr 06, 2009 | 2004 Honda Pilot
275 people viewed this question
Usually answered in minutes!