Question about 2004 Kia Sorento

Open Question

My 2004 Kia Sorento is hard to start.It cranks and cranks then finally starts, and getting terrible gas mileage.Someone suggested it might be the fuel pressure regulator.

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 3 Answers

SOURCE: 2003 Kia sorento starts and then won't start

There is a black rubber button reset switch right next to the air box, press it sounds like the problem i had its a fuel pump reset (just in case of a wreck it kills the car) but there is a tiny ball in there and if it is rattled a little too much it will fall and you need to press the black looking button to reset it....took me like 4 months to figure it out

Posted on Apr 19, 2009

Ad
  • 4 Answers

SOURCE: crankshaft sensor for 2004 kia sorento

The above information about the sensor being located at the top of the motor to the passenger side of center is bogus. That is only the pig tail plug in. The actual sensor pig tail continues down below, underneath the plastic lower timing belt cover, on the front of the motor, just above the crankshaft timing gear.

It is a very involved process of removing and replacing. You will have to remove all of the belts, the front timing belt covers, (upper and lower). You will also have to remove the front bracket that is mounted to the front of the block, which serves as the mount for the power steering pump, the alternator and the A/C compressor.You will also have to remove the crankshaft pulley. You cannot remove the plastic lower timing belt cover unless you remove all of these things first. The sensor is located underneath the lower cover. It has two bolts that hold it in place. You will have to remove these two bolts.

The crankshaft pulling bolt is a right handed thread and loosens by turning counter clockwise. The pulley will slip off but is a very tight fit. Do not try to turn it while removing it as there is a small pin that keeps it aligned to one position. Use a small ball pine hammer to tap it loose.

It is also a good idea to remove the electric cooling fan shroud that is mounted to the inside side of the radiator and the radiator hoses to give yourself more room to work. It has only two bolts at the top holding it in place. And then slips into two retaining clips at the bottom. Lifting it will pull it out of these retaining clips.

When you remove the small bypass hose located at the top of the radiator , to the passenger side, be careful not to break off the small nipple protruding out of the radiator tank. It is plastic and will break easily if you try to pull the rubber bypass hose from it. This will have to be taken to a radiator shop to have repaired if you accidentally break this off. Be sure to carefully loosen the hose from this nipple before trying to pull it off.

And one more thing, if you go to that much trouble to replace this sensor, it is a good idea to go ahead and replace the timing belt as well. It is a maintenance item and you will have to go through the same process to replace it as well. Do it once and do it all.

I hope this helps.

Posted on Nov 15, 2008

aref_bilal
  • 13 Answers

SOURCE: I am changing the spark plugs on my 2004 Kia sorento

Be careful there.. If you remove the Throttle Position Sensor TPS or the throttle Cable, the engine light will come on because there is a certain setting that needs to be done to ensure accurate emission control.

Posted on Apr 14, 2009

  • 1 Answer

SOURCE: kia sorento, 2004. clock and airbag warning light

You may have a fuse problem.

Posted on Jun 02, 2009

  • 51 Answers

SOURCE: reset check engine light in a 2004 Kia Sorento

usually you can reset a check engine light buy disconnecting the battery for about 30 minutes.

Posted on Jun 02, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My 2004 Diesel Kia Sorento takes 18 seconds to cold start. OK when hot. I have changed glow plugs and checked them. Injectors seem to get to pressure. Computer shows no errors. Battery is new and turn


is the air intake clear , new filter nothing squashing the intake pipe, how long does it take for the glow plug light to go out once you've turned ignition on ?

Oct 23, 2014 | 2004 Kia Sorento

1 Answer

Crank sensor kia sorento


double check timing because they are easy to time 180 degrees gff if engine not at top dead center

Mar 19, 2014 | 2006 Kia Sorento

1 Answer

Ran out of gas and now will not start... put gas in, primed and used starting fluid. fired one time than nothing..


here are no fuel in your fuel system you neet to crank your engine till the feul gets to your injectors or blow air into your fuel filler plug to help on the fuel, if still nothing check your fuel pump

Aug 06, 2013 | 2004 Kia Sorento

1 Answer

My 2004 Kia Sorento's Crankshaft sensor code


My advice to u is get a second opinion (I know its a pain in the ,,,,,,,,) MAKE SURE THE WORK COMES W A WARANTEE. Its very unusual for 2 sensors to go out at the same time, it may be an electrical problem. GET THAT WARANTEE. Codes don't mean a sensor is bad

Jul 16, 2017 | 2004 Kia Sorento

1 Answer

2004 kia sorento fuel pump replacement


I had the same problem, had the crank sensor replaced and problem went away.

Oct 24, 2011 | 2004 Kia Sorento

1 Answer

2005 kia sorento crank shaft position sensor where is it located?


I HAVE A 2005 KIA SORENTO V-6. MY PROBLEM STARTED WHEN I WOULD DRIVE ON TO THE HWY IT WOULD PUTTER LIKE IF I WAS LOSING POWER. THE HOLE TIME THIS WAS GOING ON MY GAS GAGE WOULD NOT WORK. SO I WENT OUT TO AUTO ZONE HERE IN MADERA CA AND BOUGHT A DIAGNOSTIC TESTER AND THE CODE NUMBER P0338 WHICH MEANS CRANK SHAFT CENSER IS GONE. SO WHEN YOUR GAS GAGE STOP WORKING GET YOUR CAR TESTED OR THE BEST WAY TO GO IS TO INVEST IN A DIAGNOSTIC TESTER. IT WILL SAVE YOU A LOT OF MONEY

Feb 20, 2010 | 2005 Kia Sorento

2 Answers

2004 KIA SORENTO LIFTER TAPPING


it is common for the oil pump to go bad after changing the timing belt.

the pump is located in the oil pan, and nothing drives it, it works as a sucking action....

Nov 26, 2008 | 2004 Kia Sorento

1 Answer

2004 KIA SORENTO, i HAVE JUST HAD THE TIMING BELT WATER PUMP AND THE CRANK SENSOR REPLACED. NOW WHEN IT IDLES AND JUST START TO WARM UP IT SOUNDS LIKE A LIFTER STARTS TO TAP AND THE OIL LIGHT COMES ON....


i paid $1200 to do timing belt & waterpump .i could of done work myself but warranty requires licensed shop to do it to comply. if funds are low go to a shop and apply for credit. firestone,midas ect.they are rip offs but if approved a payment plan helps the pain

Nov 26, 2008 | 2003 Kia Sorento

Not finding what you are looking for?
2004 Kia Sorento Logo

Related Topics:

867 people viewed this question

Ask a Question

Usually answered in minutes!

Top Kia Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

yadayada
yadayada

Level 3 Expert

76846 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Kia Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...