Question about Dodge Stratus

Open Question

Where is the starter relay located on a 2004 dodge stratus

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
keemo68
  • 1263 Answers

SOURCE: 2004 Dodge Stratus A/C Fan Relay Switch

ok first the fan relay should be located inside the elecrical box. this is usually located on the drivers side under the hood. next even you have only one speed when you turn the switch it's because the reostat is bad it is located in the fan motor housing. hope this helps.

Posted on Aug 28, 2008

Ad
  • 1 Answer

SOURCE: Location of starter on Dodge Stratus R/T

the starter is on the right hand side toward the grill looks hard to get to from the top i am going to try and get it out today from underneath. (more so in th middle just so you know)

Posted on Sep 11, 2008

emissionwiz
  • 76846 Answers

SOURCE: 2004 Dodge Stratus 2.7 thermostat location

Finding the thermostat: Follow the LOWER radiator hose to where it meets the engine. It's in there. Most cars that I've worked on have the thermostat at the end of the upper radiator hose, but not this car. Replacing the thermostat: You need to remove the thermostat housing. (It's the piece that the lower radiator hose connects to.) - You do not need to remove the radiator hose from the housing. - First remove the bolt that is holding a bracket. This bracket just holds some wires in place. - Now remove the three bolts that hold the housing to the engine block. These bolts can be fairly hard to turn, but just keep trying. - Gently pry the housing away from the engine block. You can use a flat-head screwdriver to help pry, but do not scratch the mating surfaces of the housing and the block. - Pull out the thermostat, noting that the spring end goes into the engine. - When you put the new thermostat in, you probably want to use a new black rubber gasket, but you might be able to use the old one if you have no choice. Also, I didn't add any permatex or anything and it seems fine. - I tightened the bolts to 22foot pounds, but this might be a little high. Whatever you do, DO NOT overtighten the bolts. Couple other notes: I first removed the air cleaner cover and tubes to get a little more working room. I also unplugged one wiring harness to make more room. Otherwise, I was able to get my big hands in there. A new thermostat did not fix my problem. Here is a description of the problem I was having and the solution: Problem: The temperature gauge was spiking occasionally, all the way into the red. It would spike up and come back to normal. It would spike usually while in idle, but sometimes while driving. Usually about once every twenty minutes. Things I checked first: - The plastic reservior for the radiator was full to the top. - The electric fans were running, and running on high speed. - The car had working heat. - Replaced the thermostat. Did nothing to help the problem. Problem Found: - Vapor lock. Even though the reservior was full of fluid, it had previously gotten too low and the system sucked in some air. Once that happens, it doesn't matter if the reservior is full, the cooling system will not draw in the coolant. This is because filling the plastic reservior does not pour coolant directly into the cooling system. The coolant is sucked into the cooling system through a tube, like drinking soda through a straw. So the reservior, where they tell you to add coolant, was full but the cooling system (radiator, engine, pump, etc.) was almost out of coolant and wasn't able to draw in any more. Solution: When the engine is cool, open the metal radiator cap that's sticking right up out of the engine. It can be found by following the upper radiator hose to the engine. There is a tall metal tube with a metal cap on it. Pull that cap off (when it not hot) and fill it up with radiator fluid. (I use radiator fluid that's pre-diluted and designed for all makes and models of cars). Idle the car, in park, for about thirty seconds. Stop the engine and put the cap back on. If you're lucky, all the air bubbles are out of the system and you're all set.

Posted on Dec 02, 2008

polarcycle
  • 1392 Answers

SOURCE: 2004 DODGE STRATUS 2.7L, Location of Crankshaft Position Sensor?

it is located on the right side of the motor, in the trans area. Actually in the bell housing.

Posted on Jun 23, 2009

morse008
  • 1111 Answers

SOURCE: where is the starter located on 2004 dodge stratus

under the vehicle follow the positive cable down to the starter itself

Posted on Sep 06, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have an 03 dodge stratus. When I try to turn it


I know you want cheapest way to start my dodge did the same but I was able to get it started by clicking key 2-3 times by holding key in the start position and rapidly turning key , if it starts it not the relay its the starter selonoid in the starter (non replaceable)

Oct 13, 2014 | 2003 Dodge Stratus

1 Answer

Where is the fuel pump relay switch located on a 2004 dodge stratus


On most cars they are usually located in the trunk, behind the liner and not always marked....

May 13, 2012 | 2004 Dodge Stratus

2 Answers

Where is the crankshaft sensor in the 2004 dodge stratus 2.4l


Hi Crystal: It is on the front of the motor, under the starter...

2_4_2012_12_06_11_am.gif

Hope this helps; also keep in mind that your feedback is important and I`ll appreciate your time and consideration if you leave some testimonial comment about this answer.

Thank you for using FixYa, have a nice day.

Feb 03, 2012 | 2004 Dodge Stratus

1 Answer

Have a 2004 Dodge Stratus 2.7 just replaced the starter with a new one and still wont start. All the lights and everything lights up on dash but the Car wont crank up! All wires are hooked up to the...


I'm guessing that it isn't even turning over. There are a couple of things you can check. Both are in the power distribution box under the hood of the vehicle (see picture below). Also below is a picture of the fuse and relay layout. There is one fuse directly related to the starter relay (number 8 marked with a red arrow) and also the starter relay itself (also marked with a red arrow). I hope this helps.

11_14_2011_11_16_10_pm.jpg

11_14_2011_11_16_35_pm.jpg

Nov 14, 2011 | 2004 Dodge Stratus

1 Answer

Where is the distribution center in a 2004 dodge stratus?


  • Hi, the relay/distribution panel is under the hood, drivers side, about midway back. See the diagram below for a visual. If you remove the lid and look on the underside you will see a legend indicating where all the relays and fuses are located.


11_4_2011_4_42_14_am.jpg

  • Hope this helps.

Nov 04, 2011 | 2004 Dodge Stratus

2 Answers

Fuel pump location dodge stratus 2004 also is there a reset switch?


Fuel pump in the gas tank....relay under hood in junction box..

Jun 04, 2011 | 2004 Dodge Stratus

1 Answer

Where is the starter located on 2004 dodge stratus 3.0


under the vehicle follow the positive cable down to the starter itself

Aug 04, 2009 | 2004 Dodge Stratus

1 Answer

Where is the starter located on a 2004 dodge stratus with 2.7 eng


Hello
Check the battery cables and battery before replacing the battery
starter is located down by the oil pan on the engine on the radiator side
RD

Jan 14, 2009 | 2004 Dodge Stratus

1 Answer

2004 Dodge Stratus A/C Fan Relay Switch


ok first the fan relay should be located inside the elecrical box. this is usually located on the drivers side under the hood. next even you have only one speed when you turn the switch it's because the reostat is bad it is located in the fan motor housing. hope this helps.

Aug 28, 2008 | 2004 Dodge Stratus

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

145 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...