Question about 1999 Ford Super Duty F 450

1 Answer

I think i ran my 1999 ford e450 out of fuel, how do i prime it and or test the pump

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Expert
  • 130 Answers

Remove fuel filter fill it with fuel there is a bleeder there have som eone crank engine press bleeder until air bubbles are gone and just fuel comes out

Posted on Mar 19, 2011

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

1999 Pontiac Grand Am wont start. Fuel pump gets power for a second and then no power. What shuts off the power to the fuel pump?


you have to know that the fuel pump is power by the fuel pump relay
first when key on pcm prime a ground to the fuel pump relay and then the pcm need to know if engine is turning to stay on . make your test at the relay.

Dec 21, 2013 | 1999 Pontiac Grand Am GT

1 Answer

Fuel pump ford e450


if its a gas engine it is located in the tank. if its a diesel its located on the drivers side frame rail

Mar 11, 2013 | Ford Cars & Trucks

2 Answers

1999 blazer only starts when primed and then wont start after sitting


Black smoke is usually extra fuel, but you say you are priming it to start so that could be why.
Have you checked fuel pump pressure before and after cranking ?

Mar 04, 2013 | 1996 Chevrolet Blazer

1 Answer

Im thinking my fuel pump but not sure it only turns over when i prime it once the prime is gone it dies and i dont hear the pump when i climb under tank its a 1999 crown vic w/ intercepter 4.6l also a...


first check the fuse and relay for fuel pump. heres how to check the pump. get under car and put hand on bottom of fuel tank, then have a person turn key to on . if pump is ok. you will feel a vibration in tank. you may have to do this a few times because a fuel pump only runs a few seconds to get fuel pressure to engine then shuts off. but when vehicle is running its on all the time to supply fuel to engine.

Oct 06, 2011 | 1999 Ford Crown Victoria

1 Answer

I think i ran my mustang gt out of gas,i just got this car today from a good friend.It was idling in the drive way and then died without warning so i think it ran out of gas according to the guage!I put...


You need to make sure you put in AT LEAST 2 gallons of gas, more if the car is not level. It might take a few cycles of the key to get the fuel line primed again. A full cycle is Off-On-Start. When you turn the key to on, listen for the fuel pump. It should run for a few seconds and then shut off, turn the key to start for a few seconds and then back to off... This will have to be repeated several times. You should be able to hear the fuel pump from the drivers seat. I will be a faint hum or hiss coming from the back seats.

Sep 27, 2010 | 1995 Ford Mustang

2 Answers

1996 ford contour 4 cylinder- I ran out of gas and I went and put some more but car dose not start anymore. I replaced the fuel filter and that did not solve the issue, yes the fuel pump is working. What...


Try turning the key on,for 2 seconds,then off,for 2 seconds.Over and over,about 10 times,if this does not work,then the fuel pump is bad.Turning the key on ,and off,will prime the fuel system,and the try and start the vehicle.

Dec 05, 2009 | 1996 Ford Contour

2 Answers

Ran out of gas and not getting gas to carberator after adding gas


Hello there:
If you have tried priming the fuel pump by turning on the key and listening for the fuel pump to be running if it is it may just need to be primed with a hand priming pump untill you get fuel
but if you still dont get any fuel i would check out the fuel filter to see if it is clogged and needs to be replaced
to locate the fuel pump and filter go under the drivers side and look at the frame of the vehical not quite half way back and you will see the fuel filter and just in front of this about 10 inches towards the engine will be the fuel pump ok>
best regards michael

Nov 05, 2009 | 1984 Ford Econoline

1 Answer

How to prime fuel line on 85 Ford Diesel Van


Sometimes you will have to put fuel into the intake to start the motor, then once started the motor will **** the fuel through the lines

Jul 04, 2009 | 1991 Ford Explorer

1 Answer

Fuel intake problem


who changed the fuel pump? no injectors on that i don't think

Apr 11, 2009 | 1986 Ford Ranger 2WD

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

269 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

75807 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22133 Answers

fordexpert

Level 3 Expert

5495 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...