Question about 2004 Jaguar X-Type

1 Answer

Gearbox default - 2004 Jaguar X-Type

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

What happened to your gearbox..?

Posted on Mar 19, 2011

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Can someone show me limp mode ln a Ford falcon gearbox


the limp mode is a program that the ECM defaults to when there is a dangerous situation occurring in either the engine or transmission
it is not a sensor or any tangible object that can be replaced
you have to have the fault codes read to determine the sensor , servo,solenoid or condition that put the ECM in limp mode

Apr 06, 2017 | Ford Cars & Trucks

1 Answer

Steps to removing a transmission from a GMC ENVOY 2004 V6, 4WD.


Park the vehicle in a clean dry well lit place. Work with safety in mind. Its always good to take pictures as you strip the/ a assembly. Refer back to pictures if you get stuck. Dis-connect the battery. Remove the gear linkages and speedo-drive and power cables from the gearbox. Remove the starter motor. Loosen the propshaft. Mark the yokes of the propshaft- for upon installation to avoid an unbalanced propshaft. Loosen the centre bearing. Remove the propshaft. Remove the cross member underneath the gearbox if there is one. Loosen bolts around the gearbox to cylinder block. Use a gearbox jack to support the gearbox. Take the bolts out from the gearbox to cylinder block. Pull gearbox backwards. Lower the gearbox. This is pretty much the standard way of removing gearbox. Note, there might be a transfer box, normally with 2 propshafts. Mark the yokes. Remove propshafts, transfer box and then gearbox. Remember to always work safe.

Dec 19, 2014 | Cars & Trucks

1 Answer

F-150 2005 trans default light on.. ck fluid pour some and gears wont shift


check the gearbox fluid level ,i'd change the fluid if you do not know for sure when this was last changed

May 06, 2014 | Cars & Trucks

1 Answer

Mercedes sprinter 216 manual gearbox sound when not presing cluch pedal, goes away when you press the cluch pedal.


it seems that the clutch is not aligned or not setup right to it's correct default mode. when you lift the foot off the clutch it goes into default and away from the gears. this could be an early sign off needing a new clutch and pressure plate. good luck.

May 07, 2010 | 1999 Mercedes-Benz E-Class

2 Answers

Gearbox interchange between cars


406 comes normally with a gearbox model BE3 of 5 speed (as limited were with 6 speed). As late models of 405 and 306 are using the same gearboxes. Mazda 2.0i zx was sharing the same gearbox (i don't know exactly the model year).
Anyway, you need the exact gearbox model to find out which car model else were built with these types of gearboxes. Manual gearboxes with same models can be exchanged from any car or van and have nothing to do with car ECUs.

Jan 01, 2010 | 2005 Peugeot 405

1 Answer

Cruise control not available,gearbox default, codes will appear and then i disconnect battery and codes go away for about one day and then reappear when codes are on car does not drive. when codes are not...


i pulled the battery and had it tested, they said it was fine so i changed the air filter. under the battery i pulled the rubber plug and the allen plug and filled the transmission with 6 quarts of transmission fluid while the car was running like you guys said. gearbox ,cruise not avilable, and engine light went away drove for ten miles and everything seemed great

Dec 27, 2009 | 2002 Jaguar X-Type

1 Answer

Getting error that says "Default Gear Box". What does this mean?


means that you have a gearbox problem and most probably you are in limp mode. You need to have it checked by a proffessional

Jun 26, 2009 | 2001 Jaguar S-Type

1 Answer

Vibration


Solution in problem with the occasional when dash kick it and restart in Safe Mode - make use your car on I-BUS RESET. What vibration with gearbox covers, I do not think it will be bad gearbox mountings. I suggest to the transmission delete the current adaptation, what it learned the transmission unit - to factory defaults, this is the "0" value adaptation! Use a longer test road and the new adaptation have to loaded! Unfortunately, this operation is only diagnostic tools possible. It's a job for a professional garage

Jan 29, 2009 | 2003 BMW 7 Series

Not finding what you are looking for?
2004 Jaguar X-Type Logo

Related Topics:

69 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jaguar Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

yadayada
yadayada

Level 3 Expert

75744 Answers

SPEEDY CAR WORK SHOP...

Level 2 Expert

489 Answers

Are you a Jaguar Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...