Question about 2004 Ford Expedition

1 Answer

Blower motor/switch my blower motor lost the 3rd speed, when it it switched to that speed, it continues at the 2nd speed

Posted by on

1 Answer

Reastate is usually the problem

Posted on Aug 03, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

2012 jeep libery blower motor control processor location


Processor? This system consists of a control unit ( switch/selectors ) a blower motor resistor and a blower relay. If the blower fan is not working on all speeds, suspect a resistor ( common problem ). If the fan is inoperable, possible fan motor,fuse,relay,wiring and in some cases the resistor as well. The resistor is located under the passenger side dash area close to the heater motor. The wiring coming from the heater motor will plug into the resistor

Dec 26, 2015 | Jeep Cars & Trucks

1 Answer

Heater switch replacment


Hello! it's my job to make things as easy for the customer as possible...Therefore I must ask why you want to replace the heater switch? Is it because you have lost one or two of the switch speeds? Your vehicle is noted for loss of the Blower Motor Resistor...
Changing the Heater switch means removal of the Climate Control Assembly which is not the easiest of jobs...I've included the process...But are you sure the blower resistor is OK? If you have lost 1,2, or all blower motor speeds it's more than likely the Resistor pack. And a lot easier to change...
Guru...saailer


Remove climate control:





12_26_2011_2_15_09_am.gif
  1. Remove the instrument cluster finish panel...
  1. Remove the 3 climate control assembly screws...
  1. Disconnect the climate control assembly vacuum connector...
  1. Disconnect the 5 climate control assembly electrical connectors...
  1. Remove the climate control assembly..
Removal of blower motor Switch:
  1. Remove the climate control assembly.
  1. Remove the blower motor switch knob.
  1. Remove the blower motor switch.
    1. Remove the screw.
    1. Remove the blower motor switch.

Removal of blower motor Resistor:


12_26_2011_2_22_49_am.gif
Blower Resistor is under the battery tray...

MOTORCRAFT Part # YH1698 ...cost $25

12_26_2011_2_28_50_am.jpg

Guru...saailer

Dec 22, 2011 | 2007 Ford Econoline

1 Answer

My air conditioning will go in and out when used during the summer. The same thing happens when the heater is used during the winter. I have had it looked at by the dealer and spent $$$ to fix it, yet it...


1st check the control switch on dash,it maybe defaulting-2nd check out blower motor fuse-3rd check the blower motor itself it located underneath glove box-hope that helps,good luck!

Nov 05, 2010 | 2003 Jeep Grand Cherokee

2 Answers

Heater bower won't blow


There is a blower motor relay,near the motor i think,check it.

Apr 12, 2010 | 1998 Ford Contour

2 Answers

Last week the heater blower motor stopped working on intermediate speeds and would only work on high. Today after working for a little while on high I lost all speeds of the blower motor. Is it the switch...


resistor for sure, the switch would have caused all speeds to fail as it only has one moving contact but the tapped wirewound resistor is a common part for this fault.

Jan 13, 2010 | 1995 Chevrolet C1500

1 Answer

My air cond ic box not function well and i can only use switch 4 for the air cond cooling coil fan speed. switch 1, 2 and 3 recently cannot function at all. before this switch 2 and 3 works like switch 1...


You need an new blower motor resistor. I guarentee it. Ive seen this a 100 times. It is located under the dash on pass side by the blower motor. one big plug going to it.

Dec 02, 2009 | 1989 Toyota Camry

1 Answer

Heater controls


SOUND LIKE THE BLOWER MOTOR RESISTOR IS BAD.OR THE BLOWER CONTROL SWITCH COULD BE ALSO BAD.

Sep 17, 2009 | 2003 GMC Safari

2 Answers

Inside fan switch has 4 speeds only high works,


I have great news!It is not that bad!Look near the blower motor in the blower case housing ther is a blower resistor.It will have a multi-wire plug in.Unplug this ,and remove the two screws that retain the resistor in the box.Pull the resistor out ward,it will be out.The part store will have it or can get it for you.This is your speeds for your blower motor.If the blower is making any kind of racket,or seems to be slow when it is on high selection,replace it also,cause this is the cause if the resistor going out.

Aug 21, 2009 | Dodge Dakota Cars & Trucks

1 Answer

05 chev 2500, blower motor 3rd speed was not working and now it only works on 5?


This is due to the fan switch or blower switch, the one in the dash not functioning properly. You need to replace this switch.

Jul 29, 2009 | 2005 Chevrolet Silverado 1500HD

Not finding what you are looking for?
2004 Ford Expedition Logo

Related Topics:

76 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

60541 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21927 Answers

Fordexpert

Level 3 Expert

5331 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...