Question about 2007 Mitsubishi Montero Limited

1 Answer

My strada glx was locked i can't even move d key when i insert, what should i do?

Posted by on


1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.


    An expert who has answered 1,000 questions.

  • Expert
  • 1,114 Answers

Spray some graphite in the ignition switch, then insert the key.

Posted on Mar 19, 2011


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Why would coolant still be flowing after i turn my vehicle off?

does you model have accessory water heat pump. this would keep the flow of water moving if the engine is turned off. its controlled but the heater control panel

Jun 05, 2017 | Volkswagen Cars & Trucks

1 Answer

Door locks cycling and windows open

dear .if you use key to open ,then you hold key it will open all doors locks and windows ,so , insert key again then move little try to close and hold ,check if key is move smoothly, this case need to replace driver door key cylinder

Dec 18, 2013 | Skoda Fabia Cars & Trucks

1 Answer


Spray lock with wd-40. Gently rock key up and down (without pulling). Repeat this process until key moves. Pull key slowly.

Nov 11, 2013 | 2001 Chevrolet Monte Carlo

1 Answer

When replacing an exterior right hand door handle for a 1996 Hyundai Excel GLX do you need to have a new key to open

Did it come with the lock assembly ? It should just be the handle. If it is your existing lock will be used and your key will still fit.

Jan 08, 2013 | Hyundai Excel Cars & Trucks

1 Answer

Door keys will not insert all the way

if you use the central locking all the time the lockes get clogged you need to spray loads and loads off wd40 or other brands in the key hole to flush out the lockes. and then the pins will move so the key will go in.

Jul 13, 2017 | 1990 Lexus ES 250

1 Answer

My steering wheel on my 1999 saturn sl wont move and the key will not turn


I thing following happened: when the steering wheel is moved just a little bit with NO key inserted, it will lock itself (that's some common anti-theft measure).
In order to get it unlocked, you have to insert the key and gently push to rotate it while you also gently move the steering wheel left and right untill the lock is released.

Aug 08, 2011 | 1999 Saturn SL

1 Answer

I just bought a 2002 registered peugeot 406 estate glx - I am not sure whetehr ther is an alarm and imobiliser and how it works as my remote key entry is not working. Can you help.

The alarm is set when you either lock the car with the door locks or using the key and ofcourse the fob, there is usually a red light that comes on when the alarm is set, somewhere on teh dash

Jun 13, 2010 | Cars & Trucks

1 Answer

Trunk latch is switched to locked and won't open on a 95 chrysler

If you are talking about where the key goes, try inserting a small pin or paper clip(straightened) to hold open the little door where the key goes while spraying a bit of WD40 or CRC-56 into the lock. It won't hurt the paint. After spraying, insert the key in and out a number of times. Spray again, this time with the key inserted. Move the key up and down while sliding in and out. This should free up any stuck tumblers. If she still wont open, repeat the process. Still no luck? May need a new tumbler.

Nov 12, 2009 | 1995 Chrysler LeBaron

1 Answer

Key won't turn in ignition! Help needed fast!

get somegraffite at autozone and squeezed it to the ignion hole

Mar 08, 2009 | 1994 Buick Skylark

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

55 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mitsubishi Experts


Level 3 Expert

80637 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8841 Answers

Are you a Mitsubishi Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides