Question about 2002 Dodge Caravan

1 Answer

Blow motor ac only run high thanks for your

Blow motor ac only run high thanks for your help.

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Sergeant:

    An expert that has over 500 points.

  • Expert
  • 252 Answers

This is commonly the Blower motor resistor...You will need a test light to check it but it is probably the problem..It is located on passenger side up under dash...You may have to remove glove box to see it...Held by 2 screws normally with 4 or 5 wires in the connector that plugs into the resistor...the resistor plugs into the (black) HVAC system at blower motor area.Check wires for power as you switch from low to high,,,If you have power to at least 3 wires it is bad...If only one has power it should be the switch.........hope this helps........Metalpoet

Posted on Mar 19, 2011

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a 1999 Subaru Forester. I recently had the ac/heater blower motor replaced. It was only blowing on high so I replaced the resistor. Now it is blowing the fuses. Any suggestions??? Thanks


check that the wires for the motor are on correctly and that the loom has not jammed and cut when replacing the motor. There is a dead short in the wires after re-assembly of the system

Oct 06, 2014 | 1999 Subaru Forester

1 Answer

I have a 2002 dodge ram 1500 4.7L engine. Air conditioning only blows cold air when vehicle is moving; warm air when idling... please help. Thanks!


Start by checking the condensor fan to make sure it is running while you have the ac on. If it is not blowing check the condensor fan motor fuse that is located in the totally integrated power module. If the fuse is bad it is most likely that the condensor fan motor is bad and is drawing too much amperage and will need to be replaced. Now I am assuming it has an electric condensor fan motor. Make sure that the condensor is free of debris, a dirty condensor will cause high discharge pressures that will cause poor or insufficient cooling at idle.

Aug 26, 2013 | Cars & Trucks

1 Answer

Overheating


May have an air pocket if running a bit warmer then usual. I believe this make has a bleed of screw in front of the engine. Try cracking it when warm to get rid of air, close when no more air is present. . If that doesn't help you may have to get a scan tool go to live data and see actual temp of motor.

Aug 26, 2013 | 2005 Chevrolet Malibu

1 Answer

I have a 96 Ford Explorer that keeps blowing a relay for the fan motor after it runs on high for a few minutes


Assuming it is your AC/Heater fan.....does it sound like it is running at full speed/noisy ? If it is dragging....likely to blow fuse or burn relay contacts. Otherwise, wiring short to ground from relay to motor switch is possible cause.

Sep 06, 2010 | 1996 Ford Explorer

2 Answers

Ac fan speed


Replace the blower motor resister,this is the speeds for the blower motor,it is located very near the blower motor,and is mounted on the blower box,and it actually goes inside the box,to keep it cool.The reason for it`s failure is the blower motor,even though the blower motor sounds,and runs good,it is drawing too many amps.If this was at all helpful,please rate,thank you.

Jul 27, 2010 | 2001 Ford Expedition

2 Answers

Heat/ac fan only blows on high


Check the heater control switch,,,,,and the number of wires at the heater motor....Some motors have more than one winding...in which case there will be three or more wires going into motor..there can be burnout in those windings and will require a new motor....check the plug which attaches to the motor....can be bad connection...or at the switch.....but if there is only two wires....then the heater switch uses resistors to slow down the different speeds...and direct connection for high speed....and the problem is definitely the switch...

Apr 27, 2010 | 1996 Lincoln Town Car

1 Answer

On third compressor. Had the temperature sensor


With the AC on, the fan will come on to help the ac codensor. Why your compressor keeps crapping out is definately something to look into. If your AC is overcharged the head pressures can get pretty high and if the oil is low, that would not help either.. Good Luck.

Aug 03, 2009 | 2006 Chevrolet Equinox

1 Answer

1997 dodge intrepid heater/ac fuse keeps blowing


I have a 96 Intrepid, and none of the signal lights work. I tried replacing the fuse, but this did not remedy the problem. Could this be a loose connection?

Feb 11, 2009 | 1997 Dodge Intrepid

Not finding what you are looking for?
2002 Dodge Caravan Logo

87 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

75797 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8140 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...