Question about 2001 Volkswagen Beetle

Open Question

2001 vw beetle check engine light is on. code reads 16795 replacedcontrol solenoid valve--light still on. 2nd time repaired vacumn leak--light still on. 3rd time told me it was probably porous hose lines--light still on. $300 wasted so far. what next? ggorman@bresnan.net

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 345 Answers

SOURCE: 9 CODES

GIVE ME YOUR ENGINE CODE THEN I MIGHT BE ADLE TO HELP

Posted on Oct 10, 2008

  • 27 Answers

SOURCE: 1997 VW Passat trouble code

bring it to local garage

Posted on Nov 07, 2008

  • 4 Answers

SOURCE: 98 VW Beetle 2.0L, Check engine light with OBD Code PO118

BTW - if you have less than 100,000miles you might be able to have your cat replaced under warranty by the dealer. In Canada it's 160,000km.

Posted on Mar 16, 2009

  • 131 Answers

SOURCE: Reset check engine light after repairs. Which fuse? 99 New Beetle

goto a sears automotive center,walmart,pepboys or some place like that, they sell OBD 2 code readers for the car, you connect it up to the computer and it will tell you what the code is that is setting the light off on the dash, if it is what you fixed, then you click on the the button to reset the light and you are done... the OBD2 readers can be anywhere from $20 to $40 or so dollars from those places. just get a cheap one cause that will save you a lot of money. but atleast then if the light ever comes on again you can connect the reader up read the code and fix the problem that is causing the check engine light to come on...hope this helps and saves you money

Posted on Jun 01, 2009

canbruce75
  • 1776 Answers

SOURCE: my check engine light came on. the code was po102.


Trouble Code: P0102


MAF Sensor Circuit Low Input
Possible Causes:



Check for leaks between MAF sensor and throttle valve control module Voltage supply faulty. Sensor power circuit open from fuel pump relay to MAF sensor Sensor signal circuit open (may be disconnected) from ECM and MAF Faulty ground cable resistance between connector terminal 1 and Ground MAF Sensor malfunction Sure hope this helped you and good luck.

Posted on Jul 20, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Fault code 01652 shift solenoid E intermittent P0674 Intermittent


VW automatics are plagued with valve body problems, check with the dealer for a recall. i cam currently changing all of the solenoids on my 2000 beetle 1.8T.

Oct 08, 2012 | 2007 Volkswagen Passat 2.0T

1 Answer

2001 Volkswagen Beetle Failed Emissions


Dear Sir:

EGR Ehaust Gas Recirculation system.the basic component is vacuum-operated control valve that recirculates the exhaut gases through the engine the engine intake manifld and cylinders where they recombine with the incoming air/fuel mixture.The check need special equipment, to some workshop.
sincerely. God bless you.

ernesto cuadra
managua, nicaragua. c.a

see the diagram for details.
3_29_2012_8_23_30_pm.jpg

Mar 29, 2012 | 2001 Volkswagen Beetle

1 Answer

My 2001 vw beetle 1.8t automatic transmission just run on 1st and 2nd gear


Scan vehicle and check for codes in the transmission controller. if bad shift solenoid replace

If nothing in the computer you will need to take it to a specialty euro shop to have the transmission fluid level checked

Jan 27, 2011 | 2001 Volkswagen Beetle

1 Answer

FAILED EMISSIONS TEST P0401&P0420 CHECK ENGINE LIGHT RESETED MANY TIMES WHEN CUT OFF ENGINE LIGHT COMES BACK ON AFTER 5-6 MILES. I HAVE REPLACED EGR VALVE .STILL WA\ONT PASS INSPECTION. WHATS NEXT?


P0401 indicates that the Exhaust Gas Recirculation Flow Insufficient Detected. This can be because EGR is faulty . As you have replaced this then the problem must be with the vacuum line . EGR valve vacuum line which can be broken or blocked. The vacumn ine must bbe checked for leaks or any blocks using an vacumn pump connected the line.

P0420 indicates that the down stream oxygen sensor reading is not steady and it is connected with the code P0401.

Jan 05, 2011 | 2001 Toyota Camry

1 Answer

I have a 42re trans (4x2). My previous trans would always pull out in 2nd gear shifting regular thru the rest. Rarely did it pull out in 1st gear. Eventually the trans went while on the highway. Vehicle...


2001 grand cherokee?
nor years of all parts swapped.
swaps are super complex topics, endless possibles.

dont expect magic from any TCM.
they cant tell you ever possible way things can be wrong
it will fail to shift right if things are wrong,
the trans TCM can go to limphome mode, read the service manual chapter 21 yet its free, posted here 300 times.
forget the silly engine , light (CEL) use only a scan tool one that can read all factory codes not some $20 tool.
CEL lamp is for failing smog. only. never trust it, if out.

i say bad shift solinoids.
the TCM can see late shift error.s but maybe not all.
stick in 1st is a hard failure.
all inputs to the TCM must be correct for the shift to 2nd happens.
check all inputs.
if those are then see if the TCM did shift to 2nd, but the solenoids ignored the logic inputs to the solenoids.
solenoids have many failure mods
dead. (stuck closed)
stuck open, valve open.
or leaking. (leaking can cause stuck in 1st and confuse any TCM)

leaking means breached, valve leaks where it must not. ever.

Mar 08, 2017 | 2001 Jeep Grand Cherokee

2 Answers

Check Engine lite comes on Code PO440


16824/P0440/001088 - EVAP Emission Control Sys: Malfunction Possible Symptoms
  • Malfunction Indicator Light (MIL) active
Possible Causes
  • Evaporative Emission (EVAP) System leaking
  • Evaporative Emission (EVAP) Canister Purge Regulator Valve (N80) faulty
  • Evaporative Emission (EVAP) Canister Purge Solenoid Valve (N115) faulty
Possible Solutions
  • Check Evaporative Emission (EVAP) System Sealing
  • Check Evaporative Emission (EVAP) Canister Purge Regulator Valve (N80)
  • Check Evaporative Emission (EVAP) Canister Purge Solenoid Valve (N115)

Jun 17, 2010 | 2000 Volkswagen Beetle

1 Answer

Have a 2001 vw beetle and a check engine code is t1582


17990/P1582/005506 - Idle Adaptation Limit Reached Possible Solutions
  • Check Fuel Pressure
  • Check Intake System for Leaks (False Air)
  • Check Fuel Injector(s)
  • Check Evaporative Emission (EVAP) Canister Purge Regulator Valve (N80)
  • Check Exhaust System for Leaks
  • Check Secondary Air Injection (AIR) for Leaks
  • Check Vacuum Lines for Leaks
  • Check Throttle Body
Special Notes
  • It may be necessary to remove and clean the Throttle Body and perform a Throttle Body Alignment (TBA)
  • When this fault is stored in the early VW models with the 2.8L VR6 (AAA) and the 2.0L (ABA), it may be necessary to drive the vehicle for a few days for the idle to return to normal after removing and cleaning the Throttle Body.

Jun 10, 2010 | 2001 Volkswagen Beetle

2 Answers

Car is choking out and dying. Reads P 0411 code. How do I know if its the motor or just the solenoid valve? How can I check to narrow down what actually is causing the problem? It's on a 2000 VW jetta VR6


16795/P0411/001041


if (window.showTocToggle) { var tocShowText = "show"; var tocHideText = "hide"; showTocToggle(); } 16795/P0411/001041 - Secondary Air Injection System: Incorrect Flow Detected Possible Symptoms
  • Malfunction Indicator Light (MIL) ON
Possible Causes
  • Fuel Pump Relay (J17) faulty
  • Hoses/Pipes to/between Components faulty/clogged
  • Secondary Air Injection Pump (V101) faulty
  • Secondary Air Injection Pump Relay (J299) faulty
  • Secondary Air Injection Solenoid Valve (N112) faulty
Possible Solutions
  • Check Fuel Pump Relay (J17)
  • Check Hoses/Pipes to/between Components
    • Check Secondary Air Injection Hoses/Pipes for Carbonization
  • Check Secondary Air Injection Pump (V101)
  • Check Secondary Air Injection Pump Relay (J299)
  • Check Secondary Air Injection Solenoid Valve (N112)

Apr 28, 2010 | 2000 Volkswagen Jetta TDI

2 Answers

2001 VW Golf 2.0 throwing error codes P0103 & P0172


Vacuum leak somewhere.
Possibly could be the O2 sensor (the one before the cat up front).
I'd search for a vacuum leak since you may have rattled something loose.

Jul 14, 2009 | 2001 Volkswagen Golf

1 Answer

Cannot read codes


Try disconnecting the battery again then hook it back up and see if it resets. We will go from there.

Dec 24, 2008 | 2001 Volkswagen Beetle

Not finding what you are looking for?
2001 Volkswagen Beetle Logo

Related Topics:

150 people viewed this question

Ask a Question

Usually answered in minutes!

Top Volkswagen Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

yadayada
yadayada

Level 3 Expert

74945 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7697 Answers

Are you a Volkswagen Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...