Question about 2006 Lexus RX400h Used Cars

Open Question

Bought a stolen recovered lexus rx400h. Broken o/s front bumper - broken windscreen and n/s front door glass. No power steering No power to 3 windows or sunroof. Had a fault diagnosis done and it came up with - c1568 dc-dc converter. Heard from lexus that there is other codes in this module that pin points probs. But thought I would ask here first. Main fault = NO POWER STEERING & NO POWER TO WINDOWS. Can anyone help please

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 1 Answer

SOURCE: Power steering

There is a loud squeak on the front of my 1991 ls 400. The squeak is near the alternator. Any one no what it is?

Posted on Jan 29, 2009

Ad
  • 7 Answers

SOURCE: 1999 Lexus ES300 Steering wheel make groaning noise

Hi
If the groaning sound is still happening, you are probably low on power steering fluid. I suggest starting there. Remove the cap and check the dipstick attached to the cap. The reason the sound would go away at high speeds is that you don't turn the wheel as sharply at higher speeds so the pump is not trying to pump air ( that's the groaning sound ).
If you are low on PS fluid, fill it but check for leaks for a while. Look under the car in the morning for fluid. If you spot a leak, take it back to whomever replaced the hose and have them fix it.

As far as the engine light goes, first make sure the gas cap is on properly, meaning all the way. Turn it till you hear it click several times. If that is all it was, the light should go off after 20-30 miles or so. If it stays on, try changing the gas cap. That is probably one of the cheapest routes to go.
Good luck

Posted on Apr 12, 2009

  • 41 Answers

SOURCE: need to know what type of power steering fluid to add

almost a personal choice all fluids have to meet a certain standard

Posted on Apr 25, 2009

  • 10865 Answers

SOURCE: lexus gs300 dash lights ,sunroof,gear lever,windows, not working

hello freddy - the good news is that your lexus has a self diagnosis system built into it. this is what you need to do.

drive to an auto zone or similar autoparts store and have them put your lexus on their computer to scan for trouble codes. they offer this as a free service. with a little luck this scan will isolate the problem and the fix will be quick and easy.

if this doesnt fix it for you get back and let me know what codes popped up.

here is a link to the lexus trouble codes so you will have added insight. good luck.

http://www.troublecodes.net/Lexus/

Posted on Aug 22, 2009

  • 81 Answers

SOURCE: 1992 lexus sc300 repair: Power Steering pump

replace the power steering pump. make sure you get crush rings for the hoses too. dont use stop leak stuff either because it WILL clog the filter in the power steering rack and then youll have to replace that too.

Posted on Aug 23, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Hi we are having a debate about vin numbers on the 2010 nissan maxima. Would you be able to tell us how many are there and the locations?


Almost all vehicles are similar.
There are typically 3 locations:
1) On the dash in front of the driver. Read by looking through the bottom of the windshield.
2) On a plate on the drivers side door frame. Visible when door is open.
2) On the registration documents that are supposed to be kept in the vehicle with proof of insurance.

Oct 27, 2015 | Nissan Maxima Cars & Trucks

1 Answer

How to replace rear door window on 93 pathfinder


If you can see the edge of the glass (not stuck inside a rubber mould) then the glass will be glued to the body. The quickest and easiest way for you to get a water proof job without the mess is to have a windscreen shop fit it for you. Believe me you do not want the hassle.

Dec 12, 2013 | 1993 Nissan Pathfinder

1 Answer

THE WINDOW IS JUST BROKE


Glass forms an integral part of the cabin strength so if it is a windscreen/ rear window have awindscreen shop do the job as they are mostly glued in. If it is a door glass you can do it your self but the time taken will not warrent the expense Take ti to a panel shop

Jan 26, 2013 | Cars & Trucks

2 Answers

Lexus rx400h 2006 - won't start "shift to park to start"


Hey Guys, The problem is that the 12V battery is low or dead. Having the battery replaced will fix this issue. (I have the same vehicle, had the same problem, and this was the fix)

Oct 05, 2009 | 2006 Lexus RX400h Used Cars

1 Answer

My drivers side mirror was bumped and now does not line up?


if the glass is broken or need it replaced. You need to remove the door panel approx. five phillips head screws, remove the triangular plastic cover in the corner or the window. Remove the 3 ten mm bolts, if electrical mirror then disconnect and replace. The screws to remove the door are behind the handle, you need to pop uo the window control panel in the door and then search for the other screws. There are many clips along the door panel so some slight pulling is needed.

Sep 30, 2009 | 2004 Lexus LS 430

2 Answers

Well a 99 lexus gs 400. car got broken into. they cut the little glass out in the back passenger side. how can i fix or wherer to get fixed


bro check with dealer or wreckers for the parts and most properly you have to go to windscreen man o some wreckers do fix it with some extra laborer cost

Aug 26, 2009 | 1992 Lexus Ls 400

2 Answers

The passenger side front and rear power windows 2005 Lexus ES


IT CAN BE BROKEN WINDOW MOTOR YOU NEED TO REMOVE THE PANEL TO SEE IF YOU GOT POWER OR GROUND GOING TO THE MOTOR BUT BEFORE THAT I WOULD CHECK IF THERE NO BROKEN WIRE IN THE DOOR WHEN YOU OPEN THE THE DOOR WIRE MOVE AND AFTER TIME DOES WIRE CRACK AND BREAK THANKS PIERRE

Jul 30, 2009 | 2003 Lexus ES 300

1 Answer

Power window problem. engauges then disenguages


Section 01-11: Glass, Frames and Mechanisms 1997 Windstar Workshop Manual REMOVAL AND INSTALLATION Door Glass and Regulator, Power Windows Removal
svw~us~en~file=ani_caut.gif~gen~ref.gif WARNING: IF THE REGULATOR COUNTERBALANCE SPRING MUST BE REMOVED OR REPLACED FOR ANY REASON, MAKE SURE THAT THE REGULATOR ARMS ARE IN A FIXED POSITION PRIOR TO REMOVAL TO PREVENT POSSIBLE INJURY DURING C-SPRING UNWIND.
  1. Remove front door trim panel (23942) and front door inside panel sound insulator (20394). Refer to Section 01-05 .
  1. Remove inside door belt weatherstrip.
  1. Remove front door window glass (21410) as described in this section.
  1. Remove two nut and washer assemblies attaching the window regulator equalizer arm bracket (23230).
  1. Remove four rivets retaining the front door window regulator base plate to door inner panel.
  1. Remove front door window regulator (23200) and front door window channel bracket (23288) from vehicle.
  1. Working on a bench, carefully bend tab flat to remove front door window regulator arm slides from front door window channel bracket.
  1. NOTE: Use care not to break tab; if tab is cracked or broken, replace front door window channel bracket. Make sure rubber bumper is installed properly on new front door window channel bracket, if replacement is made.

    Install new front door window regulator arm plastic guides into front door window channel bracket and bend tab back to 90 degrees.


    a9ef3ee.gif

Installation
NOTE: The front door window channel bracket and window regulator electric drive (23394) are installed into the vehicle as one assembly. The front door window channel bracket may be disassembled from the window regulator electric drive as described in Door Glass and Regulator, Power Windows .

  1. Install window regulator electric drive with preassembled front door window channel bracket into vehicle. Set the regulator base plate to door inner panel using base plate locator tab as a guide.
  1. NOTE: Two 1/4-20 x 1 inch bolts and two 1/4-20 nut and washer assemblies may be used as alternates for glass retention. However, torque must not exceed 4-7 Nm (35-44 lb-in). Equivalent metric retainers may be used.

    Install four rivets to retain front door window regulator to door inner panel.
  1. Install window regulator equalizer arm bracket.
  1. Lower front door window regulator arms to access holes in door inner panel. Install front door window glass as outlined.
  1. Install inside door belt weatherstrip.
  1. Adjust front door window glass to make sure it is properly aligned with glass run. Check window for smooth operation.
  1. Install front door trim panel and front door inside panel sound insulator. Refer to Section 01-05 .


    Door Glass and Regulator
ac1dac5.gif

Item Part Number Description 1 21410 Front Door Window Glass 2 23288 Front Door Window Channel Bracket 3 23394 Window Regulator Electric Drive 4 23230 Window Regulator Equalizer Arm Bracket 5 222A00 Front Door Glass Run Latch Side Retainer 6 N621906-S36 Nut and Washer 7 N800510-S36 Screw 8 23200 Front Door Window Regulator 9 W525172-S Rivet 10 W525175-S Rivet 11 — Wire Connector (Part of 14630 Wire Assembly) A — Tighten to 7-10 Nm (62-89 Lb-In)

Apr 13, 2009 | 1997 Ford Windstar

1 Answer

Replace a window regulator in a 1994 ford explorer


wow, a lot of work to do.

Window Regulator, Front Door, Explorer Removal
srk~us~en~file=ani_caut.gif~gen~ref.gif WARNING: IF THE REGULATOR COUNTERBALANCE SPRING MUST BE REMOVED OR REPLACED FOR ANY REASON, MAKE SURE THAT THE REGULATOR ARMS ARE IN A FIXED POSITION PRIOR TO REMOVAL TO PREVENT POSSIBLE INJURY DURING C-SPRING UNWIND.
  1. Remove front door trim panel and front door trim shield . Refer to Section 01-05B .
  1. Remove inside door belt weatherstrip and glass stabilizer.
  1. Remove front door window glass as described in this section.
  1. Remove two nut and washer assemblies attaching the equalizer bracket.
  1. Remove three rivets (manual) or four rivets (power) attaching the regulator base plate to front door trim panel finish panel (23712) .
  1. Remove window regulator electric drive and front door window channel bracket from vehicle.
  1. Working on a bench, carefully bend tab flat to remove arm slides from front door window channel bracket .
  1. Install new window regulator electric drive arm plastic guides into front door window channel bracket and bend tab back to 90 degrees. Use care not to break tab; if tab is cracked or broken, replace front door window channel bracket . Make sure rubber bumper is installed properly on new front door window channel bracket , if replacement is made.

    4a5a8fb.gif

Installation
NOTE: The front door window channel bracket and window regulator electric drive are installed into the vehicle as one assembly. The front door window channel bracket may be disassembled from the window regulator electric drive as described in Steps 7 and 8 of Window Regulator, Removal.
  1. Install front door trim panel finish panel with preassembled glass bracket into vehicle. Set the regulator base plate to window regulator electric drive using base plate locator tab as a guide.
  1. Install three (manual) or four (power) rivets (385189-S100) to attach regulator to front door trim panel finish panel . Two 1/4-20 x 1-inch bolts and two 1/4-20 nut and washer assemblies may be used as alternates for glass retention. However, torque must not exceed 4-7 Nm (3-5 ft-lb). Equivalent metric retainers may be used.
  1. Install equalizer bracket.
  1. Install inside door belt weatherstrip and glass stabilizer.
  1. Lower regulator arms to access holes in front door trim panel finish panel . Install front door window glass as outlined.
  1. Adjust glass to ensure proper alignment with glass run. Cycle glass for smooth operation.
  1. Install front door trim panel and front door trim shield . Refer to Section 01-05B .

Apr 11, 2009 | 1994 Ford Explorer Limited

Not finding what you are looking for?
2006 Lexus RX400h Used Cars Logo

Related Topics:

146 people viewed this question

Ask a Question

Usually answered in minutes!

Top Lexus Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

ROBERT GARCIA
ROBERT GARCIA

Level 3 Expert

907 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Are you a Lexus Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...