Question about 1988 Jaguar XJ6

1 Answer

1988 Jaguar XJ6 3.6L has severe and minor rusts the size of golf ball to grapefruit, how much would it cost?

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Jaguar Master
  • 17,130 Answers

It depends on the quality of work that needs to be done , so check with two opinions to confirm and decide. Also this can be done with a patch up using iron mesh and fillings. but the job will be only temporary as the cost will be minimal.

Posted on Mar 18, 2011

  • thefivepilla Mar 18, 2011

    Thanks for such a fast answer. I was thinkin of going to Maaco.

×

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Rust bubbles on roof


The cost will cover the removal of the old one, fitting of the new one and a colour matched paint job. (The most expensive part as it involves a lot of labour) If the rust has penetrated the roof then this is only one of the repair options. You could have it patch repaired but the paint job will still make it expensive. If the rust hasn't penetrated, you could rub it down, treat the rust and then paint ( Paint costs will be lower as it will be a chip repair paint job.)

Jul 15, 2013 | 2006 Pontiac Vibe

1 Answer

1990 jag xj6, 4.0 eng, 114k, plugs, wires,cap&roter, fuel pump, oil&filters changed. car runs fine but fails to start at times for several days then will start on first crank and run like a top;...


under the coil is mounted a bosch ignition module with seven connections on it ,renew this module thats all it needs ,if that doesnt work change the front crank sensor ,one 10mm headed bolt holds it it on ,either one of these could have a intermittant fault ,the front crank sensor is a jaguar only part and costs about 50 euros the ignition module is a standard type and is available from a auto factor if its in your hand as it doesnt show in the catalogue but its the same as a vw golf ,vw transporter and some citreons and peugeots as well ,should not cost more than 35 euros

Dec 07, 2010 | 1990 Jaguar XJ6

1 Answer

1988 BRONCOII has a minor shake at high speeds


Get your wheels balanced and front end aligned. If that doesnt do it its either the berrings or a suspension component like tie rods or ball joints... take it somewhere and have it checked out. Shouldn't be too much on a bronco II

Nov 09, 2010 | 1988 Ford Bronco II

1 Answer

I am currently looking to buy a 1998 volkswagen Golf, The front right suspension casing is rusted and has begun separating from the frame is this costly to fix?


Very costly and not really a good way to fix it,the car has no actual frame and relies on the structure of the metal for stability.

Aug 17, 2010 | 1998 Volkswagen Golf

1 Answer

Brakes worked fine when parked now pedal is on floor car has been parked for 5 months


When it was parked fluid may have run out of a wheel cylinder, a caliper, brake line or the master cylinder and created an air space in the brake lines.
Rust could also be a factor depending on where and how it was stored. Rust could have developed on all of these items as well.
I would suggest bleeding the air out of the system and look for leaks afterwards.

Nov 04, 2009 | 1988 Jaguar XJ6

1 Answer

1997 VW Golf GTI 2 Litre. The ABS light comes on


Hello, My 2000 2.0 Golf just recently had the same problem. I would feel the ABS pump working at certain times through the accelerator pedal. I found the right rear sensor failed the Bentley manual continuity test . After removing it I found it was pretty rusted. The sensor head is located inside the rear brake disc hub area and this probably explained this rust. The rust probably worked its way into the sensor body where you can't clean it and thus the resistance value went above specification. I ordered mine through Autohaus and cost me just over $50.00 for both rear sensors. Even though my drivers side was good I replaced it at the same time. The ABS light hasn't been on for 4 days now..

Nov 01, 2009 | 2001 Volkswagen Golf

1 Answer

1988 plymouth reliant shift cable keeps coming loose


Can only give you the british name which wont mean a thing in america .Automatic gear change cable .What i often do to keep old motors running like this till i can get the right parts ,is to use some thin wire and refit the connection then wire it together ,that will work for a while till the wire rusts through ,depending what bit has broke the gearbox or the cable end but if its the cable end then i should imagine its a new cable complete

Aug 29, 2009 | 1988 Plymouth Reliant

1 Answer

Water coolent


No. It is water (rust) staining caused by very minor erosion as the water ciculates through your engine block.It is normal.

Mar 17, 2009 | 2007 Jaguar XKR Convertible

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

87 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jaguar Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

yadayada
yadayada

Level 3 Expert

76649 Answers

SPEEDY CAR WORK SHOP...

Level 2 Expert

489 Answers

Are you a Jaguar Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...