Question about AMC CJ7

Open Question

Diagram for AMC 20 two piece axle replacemnet.

Need diagram for replacement for AMC 20 two piece axle replacement.

Posted by on

6 Suggested Answers

keemo68
  • 1263 Answers

SOURCE: WIRING DIAGRAM FOR 1984 AMC EAGLE

well you have several options you can go to a dealship and have them copy the diagram for you(i do this all the time) or you can purchase a repair manual at Napa or Oreilly's for around 20 bucks. it has diagrams and schematics in it. it also has alot of instructions in it so you can do repairs yourself. By the way i'm surprised that the mechanic doesn't have these diagrams himself. I was wandering why it won't start after you changed the plugs and wires could it be that maybe the firing order is wrong. i've done that myself a time or 2. double check the the plug wires to make sure they are in the right spot. if the problem is it won't crank. chances are you have a loose ground. please rate this..thanks

Posted on Sep 05, 2008

  • 2 Answers

SOURCE: brake light wiring diagram 1972 Gremlin

I have a 72 amx, the two wire conector at the brake light switch down on the brake pedal is light green and pink and the plastic connector is brown and plugs into the switch at the top of the brake pedal.

Posted on Jan 10, 2009

polarcycle
  • 1392 Answers

SOURCE: 2005 ford escape assembly diagram for the front axle

If they are sealed bearings, you will need a press to get them out. If they are bolt in, just remove the brake pads/rotors, then the axle nut, then the bolts holding the wheel bearing in. Install in reverse order.

Posted on Mar 07, 2009

  • 5 Answers

SOURCE: I need an AMC Eagle 1981 Belt Diagram.

Hi there,
The Gates Corporation,s website;
http://www.gates.com/index.cfm
will help you identify which belts & hoses fit your vehicle, or any vehicle as long as you know what engine is in it!
Cheers, Stevie-RayG

Posted on Aug 26, 2009

  • 3600 Answers

SOURCE: can i get a diagram on how to disassemble my amc

Only place i know of is not free and it's http://www.alldatadiy.com and it will have all your tork information there, you will have to buy a crush sleeve oil seal and other parts to put it back together, and yo will need to know how to set up the gears as well. If you need more information plese post here.
Avid101

Posted on Aug 28, 2009

mcdevito75
  • 1970 Answers

SOURCE: need diagram for 1986 amc eagle

mcdevito75 here, The proper rebuilding kit for your carb. will contain all the info you need. NOW! if you can still get the re-building kit as many have stopped produceing these kits.

Posted on Jul 06, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Interchangeable rear amc eagle


Rear axles on all AMC Eagles interchange with each other, regardless of year. Jeep Cherokee (compact XJ models) will interchange, but the shock mounts are different - Jeep mounts must be cut and welded, at least on one side. Make sure the axle ratio is the same as the front axle ratio, or the same as the axle you're replacing.

Jan 11, 2014 | 1984 AMC American Motors Eagle

1 Answer

Fuel line routing diagram


Back in those days there was no return line. Just had to have a vented gas cap.

Oct 04, 2013 | AMC Cars & Trucks

1 Answer

I need vacuum line diagram for 1974 amc javelin with 304 engine


That diagram was placed on a tag/sticker on the front of the radiator core support.

Jun 04, 2012 | AMC Matador Cars & Trucks

2 Answers

Need diagram for 1986 amc eagle


mcdevito75 here, The proper rebuilding kit for your carb. will contain all the info you need. NOW! if you can still get the re-building kit as many have stopped produceing these kits.

May 26, 2010 | 1986 AMC American Motors Eagle

1 Answer

Can i get a diagram on how to disassemble my amc 20 rear axle for my 77 jeep cj5


Only place i know of is not free and it's http://www.alldatadiy.com and it will have all your tork information there, you will have to buy a crush sleeve oil seal and other parts to put it back together, and yo will need to know how to set up the gears as well. If you need more information plese post here.
Avid101

Aug 28, 2009 | Jeep CJ5 Cars & Trucks

1 Answer

I need an AMC Eagle 1981 Belt Diagram.


Hi there,
The Gates Corporation,s website;
http://www.gates.com/index.cfm
will help you identify which belts & hoses fit your vehicle, or any vehicle as long as you know what engine is in it!
Cheers, Stevie-RayG

Aug 26, 2009 | 1983 AMC American Motors Eagle

2 Answers

Cj7 rear


Jeep Axle: AMC 20
amc20_.jpg
Front Axles
Dana 44
Dana 30
Dana 27
Dana 25


Rear Axles
Chrysler 8.25"
Dana 35c
AMC 20
Dana 30
Dana 60
Dana 53
Dana 44
Timken
Dana 41
Dana 23


Jeep Axles
Upgrades
Factory Options
General


-->All AMC 20s have a 8 7/8" R&P and use a 29 spline shafts. The AMC 20 R&P is 3/8" bigger than the Dana 44, but it uses smaller shafts, smaller axle tubes, and the CJ version comes with weaker two piece shafts. The AMC20 uses a 29 spline shaft where as the later Dana 44 uses a 30 spline shaft. The AMC 20 housing tends to flex a lot which can cause breakage. This can be remedied by welding the tubes and/or adding gussets. The reason the AMC 20 flexes more than the Dana 44 is the shorter differential housing and smaller axle tubes. It's other flaw is the CJ version uses the two piece axle made up of a hub and a shaft. The hub end tends to break off under load which has created the market for one piece AMC 20 axle shafts. Unfortunately, the shafts are expensive ($350+ USD) and in some cases a special bearing must be used.
amc20co_.gif -->Identifying the gear ratio of an AMC 20 is a bit tricky. Dana axles normally have a tag on the left of the diff cover with the gear ratio at the time of build. The AMC axles have a code that has to be looked up in a table. The code is stamped on the housing boss to the left of the diff cover right near the axle tube. Good part about the stamp is it tends to stay readable longer than the tag, but you have to know the code. Since there are conflicts between what a code means for a narrow track and what it means for a wide track, don't count solely on the code to identify an axle. Bring a tape measure or know the source of the part. Specs Narrow Track AMC 20 Code Gear Ratio Diff Type AA 2.73 Open DD 2.73 Trac-Lok BB 3.31 Open CC 3.31 Trac-Lok A 3.54 Open N 3.54 Trac-Lok GG 3.73 Open Q 3.73 Trac-Lok L 4.10 Open M 4.10 Trac-Lok Wide Track AMC 20 Code Gear Ratio Diff Type D 2.73 Open DD 2.73 Trac-Lok B 3.31 Open BB 3.31 Trac-Lok A 3.54 Open AA 3.54 Trac-Lok H 3.73 Open HH 3.73 Trac-Lok C 4.10 Open CC 4.10 Trac-LokThe Trac-Lok is a limited slip differential. You may have to scrape away a lot of mud, paint, and rust to uncover the code. If you can't find the code on the rear, check the tag on the front axle. Both axles should be geared the same. The R&P ratio ranges supported by the carriers are 2.73 and 3.31-5.13. The 5.13 gear ratio is not available for the Dana 30 though, so it is rare to see it. 4.56s are the lowest common ratio between the Dana 30 and AMC 20. 5.13s are available for the Dana 44.
CJ AMC 20 The CJs used two versions of the AMC 20, the narrow track from '76-'81 and the wide track from '82-'86. Both versions use keyed, two piece shaft/hub design and 5 on 5.5" wheel bolt pattern. Supplies of AMC 20s were exhausted in 1986 and some Dana 44s were used instead in the last of the CJ-7s.
From 1976-1978 a larger 11x2" drum brakes was used on the AMC 20. After 1978, a 10x1.75" drum was used.
SJ AMC 20 The Wagoneer and full size Cherokee also used a narrow and wide track version of the AMC 20. Both SJ versions used once piece shafts and 6 on 5.5" wheel bolt pattern. Since the length and bolt pattern is different from the CJ version, the SJ shafts are not compatible without resplining and redrilling. I've never heard of anyone going to the trouble.
Model/Version Spring Pads Wheel to Wheel Years AMC 20/CJ Narrow Track 36" 50.5" '76-'81 AMC 20/CJ Wide Track 36" 54.5" '82-'86 AMC 20/SJ Narrow Track AMC 20/SJ Wide Track Last modified Friday, 03-Dec-1999 21:48:34 MST
[ Jeep Tech Main Page | Terry's Jeep Page ]

Copyright © 2001, 2000, 1999, 1998 JEEPTECH.COM
All Rights Reserved, All content with exception of private works and
corporate trademarked logos are property of Jeeptech.com

Jun 06, 2009 | 1985 Jeep CJ7

1 Answer

WIRING DIAGRAM FOR 1984 AMC EAGLE


well you have several options you can go to a dealship and have them copy the diagram for you(i do this all the time) or you can purchase a repair manual at Napa or Oreilly's for around 20 bucks. it has diagrams and schematics in it. it also has alot of instructions in it so you can do repairs yourself. By the way i'm surprised that the mechanic doesn't have these diagrams himself. I was wandering why it won't start after you changed the plugs and wires could it be that maybe the firing order is wrong. i've done that myself a time or 2. double check the the plug wires to make sure they are in the right spot. if the problem is it won't crank. chances are you have a loose ground. please rate this..thanks

Sep 05, 2008 | 1984 AMC American Motors Eagle

1 Answer

Brake light wiring diagram 1972 Gremlin


I have a 72 amx, the two wire conector at the brake light switch down on the brake pedal is light green and pink and the plastic connector is brown and plugs into the switch at the top of the brake pedal.

May 21, 2008 | 1983 AMC American Motors Concord

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

802 people viewed this question

Ask a Question

Usually answered in minutes!

Top AMC Experts

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

yadayada
yadayada

Level 3 Expert

60971 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

4477 Answers

Are you an AMC Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...