Question about Ford Ranger

1 Answer

I hit a pot hole with my truck and when i try to start it the truck engine shakes violently and turns off

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

You broke the motor mounts.

Posted on Mar 18, 2011

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get 2 Free calls (no credit card required) and instant help on almost anything you can think of (from cars to computers, appliances, handyman, and even pets).
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

After hitting a pot hole my dodge 2000 caravan died and wont start


If it hit real hard it might have shut off the fuel there should be a fuel shut off reset button try pushing it then cycle your key a few times then try to start it

Aug 07, 2012 | 2000 Dodge Caravan

1 Answer

My 2003 Dodge neon shakes pretty violently while in idle. The acceleration is also off, yesterday I tried to pull out of a gas station and it wouldn't accelerate past 10mph until i hit the brake a


Before you start checking and touching sesitive parts such as map sensors, and 02sensors, or even think of buying $40.00 - $100.00 parts, I'd suggest you scan over all of your vacume lines(hoses), just in case one of them has a hole,cut, or torn. That's what I experienced. My 84 GMC pick-up didn't pass inspection because the check engine light on, and idle was rough and shaking. Everyone was suggesting same parts as here, on my expense. I was a little sceptical on guessing $40.00-$100.00 parts. So the next day I was looking at my engine, and heard a small hissing noise. I followed the noise, and low and behold! A torn 1/2"x 3"-90 digree, $5.00 vacume hose, that was resting above the hot valve cover. Had a small burnt hole. I replaced it,disconnected battery,drove the truck about 45 miles. No ckeck eng. light,smooth idle, and past inspection. Good luck, Frank.

May 12, 2012 | 2003 Dodge Neon

1 Answer

Dodge flatbed gas truck shakes violently


Sounds like bad fuel, dirty fuel, water in the gas tank or a fuel filter problem.

Apr 22, 2012 | Dodge Ram 3500 Cars & Trucks

2 Answers

Front end shakes when hitting pot holes. 2003 avalanche chevrolet


This usually means worn steering parts. These vehicles are known for pitman arm and idler arm wear issues. Best to take it to an alighnment shop for an assessment.

Aug 17, 2011 | 2003 Chevrolet Avalanche

1 Answer

A couple of weeks ago I hit a pot hole that was covered in water and couldn't tell it was there until to late and my Lincoln Navigator 98' started shaking badly right after I hit the pot hole. Now every...


It is most likely a coil electrical connection,or a coil that is shorted out,but you will have to have some one check the vehicle to see if that is the problem,from what you have said,this is the best solution .

Aug 08, 2010 | 1998 Lincoln Navigator

1 Answer

Vehicle violently vibrates when hitting a small bump or hole at times. Trying to slow down the car only makes it worse during these episodes and steering is very difficult. What can cause this


Check out the 'front end' at a garage to do a thorough shake down of components such as springs, tie rod ends, ball joints, shock absorbers, steering rods, bearings, etc.

Jul 05, 2010 | 1996 Jeep Grand Cherokee

2 Answers

Steering wheel violently shakes.


that is usually caused by bad engine mount this condition usually changes the distance of the cv joint and the differential which cause the cv joint to shake. also check your ball joints.

Aug 21, 2009 | 2002 Chrysler PT Cruiser

1 Answer

The front end and steering wheel shakes when i hit a hole or bump


This usually indicates a problem with the suspension components. Check for play in front end suspension, 1st thing I would check would be the steering damper, it's often overlooked, and could be the cause. If that checks out ok, jack up and check for play in wheels, which could be caused by worn ball joints, tie rod ends, wheel bearings. A lot of possibilities, generally play in any components can trigger the shaking you're experiencing when hitting a pot hole or bump. Good luck!

May 09, 2009 | 1988 Ford F 150

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

74 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

76630 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

fordexpert

Level 3 Expert

5537 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...