Question about 2004 Mitsubishi Endeavor

Open Question

My power windows on my 04 mitsi endeavor dont work. fuse is good,, got relay , but not sure where to find it.could this be a relay or switch. and where is the relay located .

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get 2 Free calls (no credit card required) and instant help on almost anything you can think of (from cars to computers, appliances, handyman, and even pets).
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
Mikey108
  • 475 Answers

SOURCE: 05 Jeep Wrangler High Beams Work, Low Beams dont

There are no relays for the headlights. Your problem could be from the headlight switch. You would have to check and see if you have power coming out of the switch on the low beam side. Check with a test light.

Posted on Dec 15, 2008

Ad
  • 3 Answers

SOURCE: Cabin Air Filter - 2004 Mitsubishi Endeavor (Where?)

IT IS IN BEHIND THE GLOVE COMPARTMENT YOU HAVE TO TAKE IT OUT BY UNSREWING AND START FROM YOUR RIGHT SIDE

Posted on Jun 10, 2009

  • 6 Answers

SOURCE: precise location of fuel pump relay switch in 94 mitsi galant

I found the two relays that run the fuel pump to be located (under the kick plate on the drivers side of the center console on a bracket just below the radio but on the driver outer side of the center console.) note: I also found the reason for two relays ( the fist Fuel relay- only provides power when the key is cranking over the engine.. the MFI relay take's over the fuel pump when the Galant is running.) All my info is from chasing the wires back too it.. the dealership either don't know, or just don't want to tell you! this is said to be good for 94-00 years but i was working on a 97

Posted on Jun 11, 2009

  • 1 Answer

SOURCE: 04 G35 Cooling Fan Relay Location

The Relays (3 of them) are located behind the Battery... between Battery and Fender, inside a Box call Inteligent Power Distribution Module (IPDM). And, as far as I know, the Relays are not sold separetly.

Posted on Sep 25, 2009

roniecon
  • 6826 Answers

SOURCE: My Blinkers dont work

See if the e flasher is engaged,if it is,this would cause the problem.Also,pull the flasher,and activate the turn signals,and see if there is voltage to where the flasher plugs in,if there is not,then you still have a defective multifunction switch.

Posted on Jan 31, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Where in the asd relay or switch on the endeavor 2007.


The ASD relay is underhood in the fuse and relay center (AKA power distribution box)

Jun 19, 2016 | 2007 Mitsubishi Endeavor

1 Answer

Were is the fuse location for the the fan for a 2006 pt cruise limited ed


fuse location for the the fan Mitsy, Check the attached links,instruction and guides, Good luck
"I hope this helped you out, if so let me know by pressing the helpful button. Check out some of my other posts if you need more tips and info."
Engine cooling fan, 50 amp fuse,at the power distribution center or relay box at engine compartment.
Heat/ Defrost fan fuse number 7 inside drivers dash fuse box.

How To Install Replace AC Heater Fan Speed Resistor Chrysler Pacifica 04...

2008 PT Cruiser Fan Relay Location

Mar 24, 2016 | Cars & Trucks

1 Answer

The passenger side windows on my 2004 mitsubishi endeavor ls will not work. problem is, the front window is currently down and I can't get it closed.


Check Fuse

Check Switches

Check Motor

Check Regulator


In that order

If you have Retained Accy Relay or
A Window Module,then you need
a repair shop to diagnose

Check means you need electrical
knowledge & a volt meter

May 29, 2011 | 2004 Mitsubishi Endeavor

2 Answers

Doorlocks dont work except from passenger side. mirrors dont work. windows dont work from anywhere


First, check all fuses to make sure that none are blown.

If the door lock switch works on the passenger side, then the drivers side door lock switch is probably faulty. Use a multi-meter to test the Drivers Side Door Lock Switch (Black and Pink/Light Green wires unlock the vehicle, and the Black and Pink/Yellow wires lock the vehicle)
If the switch is tested and found to be operating properly, you may have a faulty Body Security Module or Drivers Side Door Lock Actuator.

If neither of your Power Mirrors are working, you probably have a faulty Exterior Rear View Mirror Switch, Power Mirror Module, or blown Central Junction Box Fuse.

If none of your Power Windows are working, you probably have a faulty Accessory Delay Relay or a blown fuse in your Central Junction Box or a faulty Master Window Adjust Switch (all of the Power Window Switches feed through this Master Window Switch). If the Power Windows didn't stop working at the same time, you may have faulty Window Adjust Switches, or faulty Power Window Motors, this is very unlikely though. It would also be a good idea to inspect the wiring for any obvious damage.

Mar 15, 2011 | 2005 Ford F-150

1 Answer

Rear power windows wont work


First check the fuses for power with ignition on and a test light...if you dont have a test light locate power window fuse section and remove fuse carefully...some are hard to remove so you will need a plastic fuse puller or use small needle nose plyers...CAREFULLY..also check owners manual for relay.If they are not burnt you will have to check power at switch on the door panel...keep ignition on or have an assistant so you will not kill the battery by just leaving it on and possibly forgetting...You will have to remove door panel armrest assembly..some will become loose at connection and cause problem make sure it is connected good...you will have to have a test light to check power at connection...If power is at the switch check power from switch to window motor connection... check here for loose connection also...If power is good here and all connections are tight and clean the window motor has failed..
This is normal to go bad...but not both at the same time....check for a relay when checking for fuse
If you find a relay mail me back and I will instruct you how to check it...you will need a multimeter But if you dont have a multimeter it is best to take the old one with you to a parts store and get one like it....It will save you time and they are cheap.
I will be standing by............................hope this helps..............................

Mar 01, 2011 | 1995 Buick LeSabre

2 Answers

2005 mitsubishi endeavor has power windows. driver side window won't go down and none of the switches on the drivers side will work the other windows in the car but all other windows roll down from their...


I had the same issue on my '04. The wiring harness inside the door had worn through exposing all the wiring. Eventually that gave out. I had to replace the harness. Cost about $300.

Dec 01, 2010 | 2005 Mitsubishi Endeavor

1 Answer

The horn on my 04 mitsubishi endeavor went out and also noticed at the same time the alarm on my lock n unlock remote doesn't work. How do i fix the problem?


Standing out side the car, reach in and push the horn pad. Do you hear a click under the hood?

If not, check your fuse. If the fuse is good, check the relay.

If you do hear the click, your horns have likely failed. You can check for 12 volts with a multimeter or test light on the horn wire when the pad is depressed to verify.
If the relay and fuse check out OK and you still do not have power at the horn wires, your pad may have failed or the wire has come loose from it. This is an airbag component and should not be disassembled without familiarity with airbag systems..

If you do have 12 volts at the wire with the pad depressed, replace your horns.

One horn is located below the drivers headlight.
The other horn is near the firewall on the passenger side.


Sep 15, 2009 | 2004 Mitsubishi Endeavor

1 Answer

Electric windows and tempeture on dash are not working


IF ALL WINDOWS ARE NOT WORKING IT LOOKS LIKE.THE POWER WINDOW CIRCUIT BREAKER IS BLOWN.CHECK THE HEATER AND AC IGNITION FUSE.MAKE SURE POWER IS AT THE SWITCH.IF ALL IS GOOD.CHECK BLOWER MOTOR FUSE AND RELAY.IF THEY ARE GOOD.HOT WIRE BLOWER MOTOR IF IT WORK YOU HAVE A BAD BLOWER MOTOR SWITCH AND RESISTOR.IF BLOWER MOTOR DONT WORK.REPLACE BLOWER MOTOR.

Aug 26, 2009 | 2007 Ford Focus (3 Door) Hatchback

4 Answers

2005 saturn ion power windows


dont know, but im having the same problem. my pass. side front wont work, and the driver rear wont work. its a 2005 ion 2 i suspect its the motors in both of them. i will let you know in a day or two, as soon as i check the parts yard to get a couple.

May 22, 2009 | 2005 Saturn ION

2 Answers

Windows dont work


First I would check the fuse, if it is burned then it means there is a short in the system. It must be found and repaired before you can continue to check the rest of the power window system. If the fuse is burned, I would first suspect the power window switch,the power window relay, and last but not the least, the electric. motor. 1 time out of 100,000 or more times a wire if chafed or rubbing causing a short.

Most likely this is the case from what you tell me. Get yourself if you don't have a voltmeter or, just a 12 volt test lamp. First remove the door cover screws, door handle, locks etc., also remove the screws in the door switch drivers side. Then on the bottom of the door using a wide flat head screw driver gently pop the plastic tabs out so it don't look hacked. If your using a test light, connect one end, most of the time it's an alligator clip, connect it to a good ground, the door cross brace itself is a good ground and make sure it does not have paint on it. Touch the end of the light to the positive side of the battery to make sure the test light works OK. Connect the the light/lamp end to all the connections on the bottom of the power window switch ( drivers side ), one switch at a time, pushing the switch on and off to make sure all switches have power to both sides when button is pushed, if the test light lights while pressed on, then the switch's are good. If the switch tests good then I would have no problem buying a power window relay. Your Drivers side switch controls all windows that's why you check the power to that switch only. I would change the relay first if the fuse is OK because it's common to be the relay but, one never knows. I hope this is not too confusing but, it beats paying $$$$$$$$ to a dealer or repair shop if you can fix it yourself. And I have a feeling this is a easy fix. Good luck with your repair....tommyjg

May 22, 2009 | 2005 Dodge Stratus

Not finding what you are looking for?
2004 Mitsubishi Endeavor Logo

Related Topics:

328 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mitsubishi Experts

yadayada
yadayada

Level 3 Expert

76649 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8518 Answers

Are you a Mitsubishi Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...