Question about 2004 Buick LeSabre

1 Answer

Cannot get rivets off that incase trunk lock. re:due to locking cable disconnectio

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points


    An expert that gotĀ 5 achievements.


    An expert whose answer gotĀ voted for 20 times.


    An expert who has answered 20 questions.

  • Expert
  • 151 Answers

They nee and work up.d to be drilled out. start with a 1/8" drill bit

Posted on Mar 17, 2011

1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

How to open steamer trunk lock. Have key, but it does not turn the lock inside. Any suggestions please?

Try squirting some lubricant into the key hole, it could be that it has some rust and is stuck. Put a wire in and see if you can move things after lubrication.

Jan 18, 2015 | Cars & Trucks

2 Answers

How remove and replace rear bumper cover in my 2012 nissan altima

In most cars I've seen the screws under your wheel well. Pop your trunk and look where your bumper meets your trunk. There are usually plastic screws holding it in place. The ones that attach to your wheel well are steel.

Dec 10, 2014 | Cars & Trucks

2 Answers

Locked keys trunk

are your doors open? if yes, just remove rear seat, there you can access the trunk.

Jun 10, 2013 | Saturn Cars & Trucks

1 Answer

Keys locked in trunk of 2007 eclipse spyder convertible

at trunk button override and jump switch if dont work have to make way to get through at back seat

Aug 05, 2012 | 2007 Mitsubishi Eclipse Spyder GT...

1 Answer

I cannot open the trunk. I tried from inside the car with trunk button, car key button. Nothing. Help!

Checked all the fuses? I assume your trunk has no key cylinder.
Can you fold down your rear seats? Many times there is a manual release inside the trunk, just incase you lock yourself in the trunk!
If there is no manual release lever or cable with handle to pull the latch itself may have a slot on it that when a flat screwdriver is inserted and twisted it will rotate the release.

Aug 24, 2011 | Mercedes-Benz E350 Cars & Trucks

1 Answer

I have a trunk locked on bmwzw - key will not open nor will remote work - need to get in to change broken battery cable

You did not mention the year, but I am guessing that you have an all-electric trunk release and the car is electrically dead due to the battery cable problem.
If this is the problem, attach another car via jumper cables to the jumper cable attachment point under the hood and a good engine ground to power the car so the lock will work.

Mar 13, 2011 | BMW Z3 Cars & Trucks

1 Answer

How to replace a back door latch switch

with the hatch open remove any panel near the inside of lock so you can get to the horse shoe clip to remove. You must on some models remove on the outside of the trunk a logo style medal piece that is usually pop riveted on-this can be drilled at the pop rivets -but you must replace by using new rivets when finishing, that will be the last step-always examine the lock before removal so you know how to reinstall.

Sep 24, 2009 | 2002 Lincoln Continental

2 Answers

Have the remote for lock & unlock But the thing locks w/o touching remote. When driving, when parked, etc. it just locks by itself.

hi there
there may be a few things here
1. there may be a sensor on the drivers dor that thinks that it has been locked so it locks all the doors. this happens after a few years my sisters carnival dose the same
the locking motor witch has the sensor in it may need to be replaced
2. in australia 2004 hyundai came out with a featur called "halo"
it was designd to stop perole hijacking cars the doors would lock them selfs after the car was started and incase or accedent the doors would unlock
this may be a feature or a fult due to age
either way its not expencive
hope this helps

Jul 04, 2009 | Hyundai Motor 2003 XG350

1 Answer

Power door lock switch replacement

Remove or Disconnect

Door handle trim plate.
  1. .Install or Connect

  2. Electrical connector and door lock cable.
  3. Trim panel by engaging hooks on backside of panel.
  4. Push pin fastener in defroster duct.
  5. Screw from behind lamp assembly.
  6. Courtesy lamp assembly.
  7. Two screws in arm rest.
  8. Arm rest cover plate.
  9. Door handle trim plate.
There May Be A Need to Drill Out RIVETS that Hold Motor in place,. Just Replace with>>MACHINED SCREWS & BOLT'S

Remove or Disconnect

  1. Trim panel. See: Doors, Hood and Trunk\Doors
  2. Four tabs retaining switch.
  3. Electrical connector.
Install or Connect

  1. Electrical connector.
  2. Snap switch into trim panel.
  3. Trim panel.

Mar 14, 2009 | 2000 Buick Park Avenue

1 Answer

97 Camry - trunk will not latch closed

Sparay lock assy with lubricant, and look where release cable attaches to lock assy, and push/pry it one way or the other to get it to move, opposite of where it is. Lube cable too.

Jan 09, 2009 | 1997 Toyota Camry

Not finding what you are looking for?
2004 Buick LeSabre Logo

Related Topics:

37 people viewed this question

Ask a Question

Usually answered in minutes!

Top Buick Experts


Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8210 Answers

Are you a Buick Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides