Question about 1999 Dodge Durango

2 Answers

The ABS and brake warning lights flash on and off, why?

Posted by on

  • Anonymous Nov 20, 2008

    My ABS and emergency brake lights on my 1996 Dodge Dakota stay on except when I run the truck almost completely out of gas. As soon as I fill up the gas tank, the lights come back on and stay on. Kookie.

×

2 Answers

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 10 Answers

Could possibly be the rear wheel/brake cylander dodge had a problem with them blowing out and leaking all the fluid out

Posted on Aug 02, 2008

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

No brake fluid getting to rear brakes

Posted on Nov 29, 2008

6 Suggested Answers

shocktroop40
  • 155 Answers

SOURCE: 2001 Jimmy ABS and brakes lights came on

I hate to say it, but the abs control module might have died on you. Thats the boxy looking thing under the hood that has a lot of brake lines and wire connectors going into it. I have seen this happen before and it ended up being one of the speed sensors on the wheels but usually its the module. Take the truck somewhere to get the light scanned, and that will give you a better idea of what it is.

Posted on May 24, 2009

emissionwiz
  • 64286 Answers

SOURCE: abs warning light stays on no problems with brakes

The brakes will feel fine until u need the ABS, when the light is on the ABS is disabled. You need to have the ABS system tested for trouble codes, if the light is on there will be a code or codes.

Posted on Nov 14, 2008

  • 1 Answer

SOURCE: abs brake warning light comes on and rear brakes remain stuck on

I would bypass abs contraption with new line.(87 dually) abs located under drivers side cab looks very susceptible and is known to fail.I would trust my foot before that old thing.Im rippin it out of my truck & replacing it with new line all the way back.Old lines rusted pretty bad.Better safe than sorry.unplug light bulb or just leave it in .Jersey cant say anything if its 94 or older at inspection.that goes for all the lights.For me,older is better.I dont know what setup you have or if you sold it, you could try replacing it for about 160 at advanced.I hope its not the computer screwin up,thats probably a dealer item.Try unpluging hydraulic unit for shits & giggles.Go over rear brakes again before you start cutting.

Posted on Dec 26, 2008

mechanicm639
  • 253 Answers

SOURCE: my abs light is always on and now my brake warning light is on but brakes seem to be working fine

The ABS light is a warning that you have an issue with the ABS system. The red brake warning lamp is serious. It is telling you that there is an issue with the base brakes. Your car will be ok with an ABS light, but the red warning lamp could be really dangerous. You should have them checked ASAP. It could be from many causes. A park brake switch, low fluid, the causes are too numerous to list. Please for your safty have it checked. Good Luck

Posted on May 29, 2009

  • 12 Answers

SOURCE: fit new indicator stalk to VW passat esp , abs light on now

the stalk should have no interference with the abs or esp set up what i would look at doing is checking your abs sensors they can go all of a flash...goodluck

Posted on Jun 19, 2009

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Resetting abs warning light


Changing brake pads and rotors will not solve this problem. Go to Auto Zone and have them read your computer for ABS codes and then you can zero in on the problem.

Aug 17, 2014 | 2010 Chevrolet Impala

1 Answer

Abs light flashing


Please check the following:
1. ABS warning light circuit.
2. Sort circuit in wiring.
2. Brake actuator (skid control ECU)

Mar 25, 2014 | 1998 Toyota Corolla

1 Answer

1995 Chevy Cavalier


The amber ABS warning light is telling you that there is a problem with the ABS system. When the antilock brakes don't work you just have good old fashion non antilock brakes. When the red brake warning light is on it could be a couple of things. (unless you are talking about the brake light on the back of the car is stuck on) the red brake warning light on the dash tells you when the parking brake is on and it also tells you when there is a problem with the hydraulic system. Some cars will also turn this light on when the brake fluid is low, (not sure if the Cavalier does this)

The ABS system is computer controlled and needs to be scanned for trouble codes to diagnose the problem.

I can't say I have ever heard of a "brights" indicator flashing, Do the headlights go bright and dim as it is flashing? Is it a slow on and off like a turn signal or faster than that?

Jan 26, 2014 | 1995 Chevrolet Cavalier

2 Answers

Abs light stays on and a yellow triangle warnng light


On occasion an ABS light will come on when a brake light is out. So check your brake lights first. Your ABS light is on because there is a malfunction in the ABS system. Is your brake warning light and your ABS warning light both on? This would be an indicator of a major malfunction in the ABS system. Stop driving the vehicle and fix this immemorially. If only your ABS light warning light is on this will not effect normal braking but the ABS system is disabled while the ABS warning light is on. You still need to have it repaired but you still have brakes for the moment. Now the code for this fault will be stored inside the ABS memory module. So you pinpoint this with scanner. Hope this helps

Mar 22, 2011 | Volkswagen New Passat Cars & Trucks

1 Answer

1996 Ford Windstar 3.8L, Brake light is on-brakes work fine


Abs light on means the ABS sytem has a fault.
You can determine what is wrong by counting the flashes (they say) and then put the data in on the web.

IE abs, windstar, failure, 3 flashes.

The brake light on is most likely picking up on uneven brake pressure, or a failing master cylinder/
You may not feel any difference yet, give it a little time, feel for a pedal fade at a light.

Jan 23, 2010 | 1996 Ford Windstar

1 Answer

Mk1 A4 ABS warning light


I have a 2000 Audi A4 and the break wear sensor warning light come on for me too. It does not flash and is orange in color. I have asked the Audi dealer twice about it and they told me it's because the previous owner put aftermarket break pads on it, thus messing up the sensors. I don't know about the ABS warning and other than that I wish you luck on it.

Dec 21, 2009 | 2000 Audi A4

1 Answer

The ABS warning light on my BMW 316ti is flashing.


The flash may be a faulty brake light switch located on the rear of the brake pedal

Aug 20, 2009 | BMW 3 Series Cars & Trucks

1 Answer

ABS light


It is picking up a signal from one of the wheel sensors probably.

Go here to read files on ABS issues

http://autos.groups.yahoo.com/group/villagerquest/

  • Anti-Lock Brake Warning Indicator Always On
  • Fuse(s).
  • Circuit.
  • Hydraulic solenoid relay.
  • Hydraulic pump motor relay.
  • Brake anti-lock sensor(s).
  • Hydraulic anti-lock actuator assembly.
  • Anti-lock brake control module.
  • GO to ABS Quick Test .

QT5 PERFORM ABS TROUBLE CODE RETRIEVAL
  • Key OFF.
  • Jump Pin 4 of the data link connector to ground.

    5939e8a.gif

  • Key ON.
  • Observe the anti-lock brake warning indicator.
NOTE: The first code to flash will be the start code (12). Also, each code is repeated three times before proceeding to the next trouble code.

Does the anti-lock brake warning indicator flash codes? Yes No RECORD code(s). GO to the following ABS Trouble Code Identification Chart in this section and PERFORM Pinpoint Test specified for first code retrieved. If indicator is illuminated constantly, GO to Pinpoint Test D1 . If indicator is not illuminated, GO to Pinpoint Test A1 .


df42bc3.gif

Jan 02, 2009 | 1993 Mercury Villager

1 Answer

Abs system fault


when the abs is activated it will cause the brake pedal to jump in and out rapidly, and the ABS light will flash at the same time, is this what u are asking? is this normal? yes.

Dec 22, 2008 | 1996 Land Rover Range Rover

Not finding what you are looking for?
1999 Dodge Durango Logo

301 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

64286 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21990 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6812 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...