Question about 2003 Honda Element

1 Answer

My manual 2003 element is making a loud ticking sound as if you were spining a bingo wheel, when you push in the clutch the sound goes away as if there is no problem at all. What could this be?

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Master
  • 3,400 Answers

Throw out bearing

Posted on Mar 17, 2011

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I get a whirring sound from the tranny when engaged put the clutch in and it goes away shifts easy and runs great but make sure a whir sound. 2007 Saturn Sky base model


The clutch release bearing is going bad due to incorrect clutch adjustment. Damage to clutch pressure plate will occur if not corrected

Jun 08, 2017 | Saturn Cars & Trucks

1 Answer

Ticking behind glovebox


Does it sound like the noise the turn signal makes? Does the noise change if you change the speed of the blower motor? Do all the function of the heater work (defrost, vent, floor, recirculate, fresh air, hot, cold)?

Nov 29, 2012 | 2003 Pontiac Sunfire

1 Answer

Loud sound coming from back of tiburon, gets louder at higher speeds


Run the car a few miles then Check all wheel bearings, this can be done by putting your hand on each wheel hub and if its hot that's the one that needs new wheel bearings. its a cinch of a job!

Feb 26, 2012 | Hyundai Tiburon Cars & Trucks

1 Answer

HI, I own a 1997 Toyota Rav 4 4 wheel drive 4 cyl, the other day it started to make this loud noise coming from the front sounds like a grinding noise, when you put the clutch in the sound goes away any...


it sounds like it is either your clutch or the throw out bearing. either way you more than likely need to have to install a complete clutch kit (pressure plate, clutch disc, throw out bearing, and have your flywheel resurfaced.

Nov 19, 2010 | 1997 Toyota RAV4

1 Answer

03 Suzuki Aerio Idles and runs rough and loud


Sounds like you first need to go to Auto Zone and have them scan the computer for the check engine light code and find out what is going on with that..it is probably a misfire code, they will print out the code and the cure, may need a good tune with wires.
As far as the wheel soot/?
You may have a leaking axle seal/worn brake pads/frozen,leaking brake line or disc caliper(check the brake fluid level in the master cylinder to confirm a brake fluid leak)

Jul 02, 2010 | 2003 Suzuki Aerio

1 Answer

Change clutch


Sounds like transfer case issue if 4 wheel drive works and 2 wd does not. Clutch slippage would be worse in 4 wheel drive more than 2 wheel drive, more to push.

May 16, 2010 | 2003 Toyota Tacoma

2 Answers

When i start my truck up theres a tticking sound coming from the right side of my motor when i start it up goes away when i drive but when idling or starting it up you can here it tick loud its not a...


The sound you are hearing is an exhaust leak. Sounds like a ticking noise, goes away when driving, but can be heard when sitting. You probably have a bad manifold gasket, or loose clamp or broken weld on exhaust. Best way to tell is start it up and listen as to find leak. Or take to a muffler shop and have them repair it.

Jul 26, 2009 | 1998 Chevrolet S-10 Pickup

1 Answer

2003 Pontiac Grande Am Gt 3400 engine


you can pull the valve covers and inspect the rocker arms, but you may have a bad main or rod bearing. im leaning toward the main bearing being spun, at least.

Mar 11, 2009 | 2001 Pontiac Grand Am SE

Not finding what you are looking for?
2003 Honda Element Logo

Related Topics:

84 people viewed this question

Ask a Question

Usually answered in minutes!

Top Honda Experts

yadayada
yadayada

Level 3 Expert

75817 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Kevin Daniels

Level 3 Expert

1455 Answers

Are you a Honda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...