Question about 2006 Ford Crown Victoria

2 Answers

Fule pump is brand new and is not geting power to it i tested with lighttester to plug and i get red glow

Posted by on

2 Answers

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

There is a circuit breaker in the trunk on the left. Its purpose is to reduce the possibility of a fire in a crash. It is common for them to trip. Try resetting it.

Posted on Aug 07, 2008

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Master
  • 1,586 Answers

Check the fuse panel(s) first and be sure there are no blown fuses. After that, look into the fuel pump relay - if it dies, you'll get no power to the pump. You can replace it for a few dollars with a new one.

Posted on Aug 02, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

90 cutlas, won't go over 25 hase new wires fule filter wire fule pump and fule senser


What engine size? The 2.8 had a problem with the torque converter clutch solenoid sticking and causing a stall but no trouble with it once vehicle in motion. You may have a plugged catalytic converter in the exhaust system causing lack of power/speed during acceleration. An exhaust back pressure test will determine if this is your problem. You can remove the oxygen sensor and drive the car ( it will be loud ) to see if the vehicle runs any better. If it does, the exhaust could be plugged

Jul 01, 2015 | Cars & Trucks

1 Answer

I have a 1998 ford wind star new fule pump but still not geting fule , wont crank engine turns ove but won;t start


INSTALL PRESSURE GUAGE THEN CK, VOLTAGE TO PUMP PCM TURNS ON PUMP RELAY FOR 2 SECONDS WHEN KEY CYCLED ON ,, IF NO POWER CK INERTIA SWITCH ( MAY BE TRIPPED ) IF NO POWER TO INERTIA SWITCH CK FUEL PUMP RELAY IF NO VOLTAGE AT PUMP RELAY THEN CHECK FOR SPARK AT PLUGS IF NO SPARK CK PCM POWER RELAY IT SUPPLIES VOLTAGE TO PCM THAT INTURN POWERS FUEL PUMP RELAY

HOPE THIS HELPS

Aug 08, 2010 | 1998 Ford Windstar

1 Answer

After cool down motor only engages after prolonged starting;proceeds with rough ilde eventually runs normal 2005 f 350 deseil


test glow plugs if 6 liter on the side of the head test for electricity geting to them during glow plug cycle then test each one for continuity carfull study the plugs they are a little ****

Jul 12, 2010 | 2005 Ford F 350 Super Duty

1 Answer

I have a 1996 K2500 chevy surburban 6.5 turbo diesel that I had to replace the PMD, Intake, and Fule injection pump on and still won't star checked all the usual can you please help?


I have worked on one of a friend of mines,his was hard to start about half of his glow plugs were bad,you can test by takeing a test light with a long cord on it hook the alligator clip to the hot post on the batt unplug glowplugs one at a time touch test light to glow plug were the wire pluged in it should light up if not it is bad,you can buy a/c delco glowplugs at autozone for less than $10.00 a piece.His glow plug controlbox also went out and someone put a selnoid and a manual swich on his.

Mar 20, 2010 | 1996 Chevrolet K2500

4 Answers

I am facing starting problem in Fiat Palio 1.9 D


propably there is a pblm with the diesel injection mechanism(sensor maybe)

Mar 07, 2010 | Fiat 124 Cars & Trucks

1 Answer

Just cranks over geting fule has spark plugs wet 1/2 tank of gas


test to see if you have spark with a dry plug if so you may need to dry your cyl out due to you may be dumping to much fuel. a soaked plug will not spark.

Jan 23, 2010 | 1994 Chevrolet S-10 Blazer

1 Answer

2002 chevy duramax fuel gauge stopped working and makes vibrating noise sometimes around back fuel tank is this a simple fix and how thanks


Well I have a 2002. I have had this prob from the day I drove it home from the dealer. Evry time I'd put fule in the rear tank the guage stopped working. The transfer pump stopped working. It was back at chevy (3) times, and still no fix. They keep puting in new rear transfer pumps in it but that is not doing it.
It is an Electrical Problem, I keep geting rear transfer pump codes. So I was just unhooking the bat's but it's a pain.
So I just stopped puting fuel in the rear tank. And now if it stops working I just us the scanner to clear the codes and it will start to work... I am so done with this truck.
This truck also had ( whater pump, (2) Glow plugs, Injectors, fan cluch,) all go out in the first (5) years. GM, Is trash...

Jan 18, 2010 | 2002 Chevrolet Silverado

1 Answer

Car will not start has spark and fule


try removing the coil pack and see if its cracked ,it might not be throwing out enough power to spark under compression .

Feb 16, 2009 | 2004 Mazda 3

2 Answers

The fule pump was not workin well we fix it but the car still ant geting fule


Have checked the fuel pump fuse how about the main relay. Have you tried checking and testing that? If you need instructions on how to test it let me know.

When you turn the key to access. II You hear the fuel pump run if you listen through the gas cap.

If the fuel pump is working I wouldnt assume it is a has problem yet.
I would start by checking spark make sure you are getting spark. Then make sure you are getting air. I would undo the intake pipe at the throttle body.

Once you done this let me know what happens.

Dec 13, 2008 | 1987 Honda Accord

Not finding what you are looking for?
2006 Ford Crown Victoria Logo

106 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

60769 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Fordexpert

Level 3 Expert

5331 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...