Question about 2009 Chrysler Sebring

1 Answer

How to reset change oil warning - 2009 Chrysler Sebring

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Chrysler Master
  • 3,018 Answers

1. Get into your car and shut the door. 2. Put the key into the ignition and turn it on but DON'T start it. 3. Push the gas petal to the floor (all the way to the floor) three time in fairly rapid succession. 4. Wait 5 seconds. 5. Turn the key back and remove it. 6. Now pout the key into the ignition and start it. The light will either be off or go off in a few seconds.

Posted on Mar 17, 2011

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Where is the oil change reset button. What oil is best preferred?


To reset the oil change warning light:

1. Turn on the ignition (not the engine).

2. Hold down the brake and accelerator for twenty seconds until the warning light goes off.

Mar 03, 2015 | Cars & Trucks

1 Answer

How do i reset oil change warning light on my dodge dart


I would contact the dealer . Be careful because some warranties are strict and only allow for the dealer to change the oil while it is covered check it out before you get into a problem that could cost you much $$$$.

Sep 03, 2014 | Cars & Trucks

2 Answers

Check engine oil light flashes after oil change


Do you mean oil change warning light or oil pressure warning light?

Feb 04, 2013 | 1999 Volkswagen Jetta

1 Answer

How do i reset the oil change light? 99 grand am se 6cyl


That light should reset itself after you changed the oil .If you have changed the oil and it doesn't reset ,try disconnecting the batter for about 5 mins. check your milage, see how many miles you normally drive before that light normally comes on. That is so, if that light dosen't come on ,you will know its time to change the oil. If that light doesn't come on at the right amount of miles,have your oil changed at the dealer and ask them to check the oil change warning light .If they find nothing wrong ,no charge . This warning light is fairly new ,in the old days people just guessed ,its about time to change the oil !

Jan 05, 2011 | Pontiac Grand Am Cars & Trucks

1 Answer

2007 ford 500 oil warning light comes on and just had the oil and filter changed 700 miles ago,62000 mile on car .light comes on when started ,push reset and it goes off and stays off until the next start...


When they changed the oil they did not reset the light. The car needs to be told when the oil is changed.

when the warning comes on press the setup button. it should say press reset if new. Press the reset button. It should say if new oil hold reset. Press and hold the reset button until the display changes to oil life set to 100%.

Oct 12, 2010 | 2007 Ford Five Hundred Limited Sedan

1 Answer

2005 Colorado: how to reset change oil warning on dash...


while change oil is flashing hold the reset stem on the cluster(where you would switch between odometer and trip) hold until you hear a beep

May 16, 2010 | 2005 Chevrolet Colorado

2 Answers

For the last several days that I have started my car, I have gotten the warning chim for Oil Change Required, Contact Dealer. I have put approximately 1,500 miles since my last oil change. I have 5,600...


If the oil change warning was not reset at the previous oil change it's letting you know about the 5,000 required change, and it will continue to chime until reset. See your manual or dealer for reset instructions.

Jan 08, 2010 | 2009 Dodge Challenger

1 Answer

I changed my oil on my LX and the change oil warning is not reset


RESETTING THE ENGINE OIL LIFE INDICATOR
On LX and EX models

If maintenance is done by someone other than your dealer, reset the maintenance minder as follows:

1. Turn the ignition switch to ON ( II ).

2. Press the SELECT/RESET knob until the engine oil life indicator
is displayed.

3. Press the SELECT/RESET knob for about 10 seconds. The engine oil life indicator and the maintenance item code (s) will blink.

4. Press the SELECT/RESET knob for more than 5 seconds. The maintenance items code (s) will disappear, and the engine oil life indicator will reset to "100".

Jan 01, 2009 | 2004 Honda Odyssey

3 Answers

Oil warning light is still on after having the oil change, how do i reset the oil warning light ? /


The oil warning light indicates no oil pressure, changing the oil would not affect the light. You should not drive the car if this light is on, because if it is operating correctly, you will ruin your engine. The car should be checked immediately, and not driven until the cause of the light being on is determined.
good luck, and let me know the outcome. countrycurt0

Oct 03, 2008 | 2005 Chevrolet Impala

Not finding what you are looking for?
2009 Chrysler Sebring Logo

186 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts

yadayada
yadayada

Level 3 Expert

74945 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7697 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...