Question about 1994 Chevrolet S-10 Blazer

1 Answer

My s10 is hard starting and running it smells like fuel its dumping in the top of intake by the spider injectors i changed the fuel regulater it stil ideld rough but ran ok after 1200rpm then started bogging after an hour of running then the cat was glowing red so i cut it out then ranit again then it startd to bog again then it ran out of fuel so i put 5 gallonsin the truck then it died again 10mins after running then i was starting to smell fuel again its in the oil and coming out of the tail pipe so should i be suspecting the spider injectors or wat i just dont know were to look any more. thanks larry

Posted by on

Ad

1 Answer

Sounds as though the poppets or spider injectors need
replacing
The Converter is shot also, with the red glowing as well
as all the O2 Sensors

Posted on Mar 17, 2011

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Good luck!

6ya.com

6ya - Get Instant Help

6ya.com

Need repair answers fast Use 6ya to...

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

1996 gmc 1500 vortech 5.7 stars then suts off
The spider is made of plastic. Heat kills with time. Replace the spider.

Feb 21, 2014 | Cars & Trucks

1 Answer

1995 S10 4,3l runs too rich. What can be faulty?
That truck was known for the spider injector under the intake. Not hard to replace. Upper Intake comes out as 1 assembly. You usually get a smell of rotten eggs when it fails. After replacement run SEAFOAM in gas ( and oil ) to clean out Carbon, fuel system and CAT

Nov 20, 2013 | Chevrolet Blazer Cars & Trucks

1 Answer

I have a 1997 chevy s10 4.3 v6 4 wheel drive the fuel pump whent bad I replaced it I had the truck running good. but now it wont start when i dump gas in the top of the flap thing on top of the intake...
You might want to put a fuel pressure gauge on it. I'd change the filter too. Check the condition of all rubber vacuum lines. These are notorious for getting brittle.

May 12, 2017 | 1997 Chevrolet S-10 Pickup

1 Answer

My 2000 Chevy S-10 with a 4.3 vortec is hard to start since I changed the intake gasket. Once started it runs great. Whats the problem.
which one did you change? upper or lower? or both?
the spider injection sys. is a piece of you know what. and I hate it as much as you do. it takes 55-65 psi of fuel pressure to fire those injector popets. If you have to take off the upper intake again, replace the regulater on the spider assy. since your in there. and look for strong spark at the plug, the type of spark that jumps at ya and bites you when your not lookin.

Sep 12, 2010 | 2000 Chevrolet S-10

1 Answer

1994 S-12 V-6 Vortec Dumping Gas into the Oil Pan
If it's a "W" VIN (8th Digit) check the spider injector on the intake manifold. Throttle body will come off with the intake cover, ten 10mm bolts, and two 8mm holding the fuel lines in place. Once you move a few things and lift it off. (and unplug the big plug in the top that actually goes into the spider injector, about 12 prongs on it). Gently pry the spider out of the cradle on each side and squeeze the tabs and pull out each of the 6 injectors. If you take your time a novice can do it in about an hour.

Mar 08, 2010 | 1994 Chevrolet S-10 Blazer

2 Answers

1999 chevy astro wont start has spark and fuel preasure someone looked at and said they think a injector might be bad under the plentum does this sound right before i start tearing apart motor
if you vehicle has a Vortec engine it's possible for and injector poppet to spring a leak , My $$'s on the fuel pressure regulator . it's underneath the plenum (under throttle plate) and to the rear of the injector spider . most times it leaks fuel into the rear cylinders

Jan 17, 2010 | 1999 Chevrolet Astro

1 Answer

I have a 95 s10 4.3 which starts nd runs fines
spider injection is a common problem with these vehicles, is it consuming gas more than usual, is the oil smelling like gas? The spider is located under the upper intake plenem. There is also a fuel pressure regulator connected to the spider assembly that may be faulty.

Dec 31, 2009 | 2000 Chevrolet S-10

2 Answers

Replacing the o rings on a 95 chevy s10 2.2
The Injectors are right there in opening of the throttle body. There are not individual injectors for each cylinder.
There 2 or 4 injectors that spray the gas right on top the throttle plate. The entire manifold is filled with the gas/air mixture.

Oct 04, 2009 | 1995 Chevrolet S-10 CA Edition

1 Answer

95 S10 blazer won't start
check the EGR valve. it might be dirty in side with carbon. DONT GRINE OFF GASKET SCRAP IT OFF.

Apr 12, 2009 | 1994 Chevrolet S-10 Blazer

3 Answers

4-3 vortec gas in my oil 1994 s10 blazer . vehicle was running
95% chance its the fuel injector (spider). Take the upper intake manifold off and turn the key on and off a few times and you will see fuel leaking from the spider.

Jan 28, 2009 | 1994 Chevrolet S-10 Blazer

Not finding what you are looking for?

View Most Popular

1994 S-10 Blazer

  • Cars & Trucks

Related Question

1996 gmc 1500 vortech 5.7 stars then suts off

  • Cars & Trucks

Open Questions:

0 Answers

Chevy 4 wheel drive 94 S10 activator switch on dash will not go into high

Feb 03, 2018 | 1994 Chevrolet S-10 Blazer

0 Answers

Can't get wire to electric switch to make connections when plugged it back up on 94s10, 4 wheel, this plug is on transfer case, 4 wheel not working

May 13, 2017 | 1994 Chevrolet S-10 Blazer

0 Answers

1994 chevy s10 blazer new spider valve new fuel lines ..still runs rough ?? any ideas??

Mar 24, 2017 | 1994 Chevrolet S-10 Blazer

0 Answers

How can I get the dimmer switch actuator to work?

Feb 12, 2016 | 1994 Chevrolet S-10 Blazer

See all 1994 Chevrolet S-10 Blazer Questions

Related Topics

1994 Chevrolet S-10 Blazer Logo

254 people viewed this question

Ask a Question

Usually answered in minutes!

Popular Questions

2000 Chevrolet Blazer

2006 Chevrolet Blazer

1993 Chevrolet S-10 Blazer

2001 Chevrolet Blazer

2002 Chevrolet Blazer

Check Out the Latest Top Trucks Report!
Check Out the Latest Top Trucks Report!

View all Fixya Reports

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

78238 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

PDF Manual
. 1994 S-10 Blazer Manual

1994 S-10 Blazer

Loading...