Question about 1991 Ford Thunderbird

Open Question

91 t bird auto seat belt drivers side. no power


sstbird
Original seat belt system stripped the belting that the motor gear drives. old motor had elec. and ran . when I replaced with a salvage yard replacment no power. I ran a test light on the wires going to the motor could not get a pos. indicator for elec. tried the old motor and still nothing.??? Passenger side operates correctly.

Posted by on

6 Suggested Answers

phil140701
  • 52 Answers

SOURCE: Reasonable to convert 6 passenger to 7 passenger?

yes you should be able to, just check the measurements of the anchorage points first tho, most parts are interchangable between the same model

Posted on Jan 09, 2009

MrScary66613
  • 1990 Answers

SOURCE: Front seat passenger side backrest will not recline

More than Likely Stripped out. This is a Dealer only Repair. You could get the Parts from the Parts Counter at the Dealership and repair this yourself But, It is not Easy!

Posted on Jan 22, 2009

  • 43 Answers

SOURCE: 04 taurus Power Windows, passanger side goes down, not up, new mo

It is most likely the switch itself. since the down works that means that there is power going to the switch. So, the up position switch is probably worn out.

Posted on Jul 23, 2009

  • 1382 Answers

SOURCE: Seat belt stuck

Open small plastic access panel located between front and rear doors a few inches above floor. Disconnect the two wire connector (usually attached to car frame) and locate the male pin connector, usually 1 red and 1 blue wires. Run two long wires from a car battery negative post and positive post (battery on the car or separate.) Hold one wire against one pin of the connector and quickly touch the other wire against the remaining pin. This will cause the motor to turn in one direction. If motor turns in wrong direction simply reverse the wires until motor brings belt to desired position then quickly remove the wires. Reattach connectors to resume 'normal' operation after 'CAUSE' has been repaired.

Posted on Aug 27, 2009

csmock132
  • 4669 Answers

SOURCE: ford tempo auto seat belts not working

You will need to replace the trac and motor. Try a salvage yard to save money.

Posted on Apr 03, 2010

  • 8404 Answers

SOURCE: passenger side front wheel bearing

You can but I think you are getting in over your head. There is nothing telling you the condition of the CV joint you will be removing (Constant Volecity) (Knuckles?). This is a big job requiring special tools. If it is your bearing that requires replacement, the CV joint is not really involved in this. If you do remove and replace the CV joint, it will still have to be adjusted and the front of your vehicle will require realignment. I doubt you have the capability or skill needed for a wheel alignment in your garage.

My free advice is pay the $100.00 or so to get new bearings done professionally.

Thank you for your question @ FixYa.com

Posted on Mar 25, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Air bag code 33 for a 2005 lincoln town car


2005 Towncar SRS Code 33 (3 flash + 3 flash, repeat this set for twice. then Beep 5 times pause x 5 = 25 beeps every 30min).

This means you have problem with left (Driver) side pretentioner (Seat belt retract system).
It doesn't mean physical belt or retract mechanism.It is just bomb wiring which is part of airbag system.
When airbag deploy, passenger must stay tight in seat otherwise body lean to front then slam back to seat by airbag.
if belt is loose or delay to lock, passenger's body rocks back and forth.So, system use small bomb (Fire power) to lock and retract seat belt when airbag deploy.There is small bomb and igniter in part of Seat belt retractor.
Code 33 is warning for this part on 2005 Towncar.(older model is different meaning in Ford/Lincoln, it's possibly passenger side airbag system for earlier model)
Before you work for any part of Airbag system and touch any "Yellow connector", * *Disconnect battery (negative side is good enough) and wait at least 5 min to clear all power in system**.(Airbag store back up power for few minutes to be able to deploy even in case if power disconnected)
by the way, you should move your driver seat most forwarded position before you disconnect battery to make it easy to work with seat belt.
locate driver side seat belt retractor (in center pillar between front and rear door, you may have to fight with weather strip)

Locate Yellow connector on bottom of Seat belt retractor (it's called "Pretensioner")it is located on very bottom of rear side of retractor.
only one yellow connector. (make sure your battery is disconnected)
Check its physical connection or looseness.if connection looks fine, you may have to replace whole seat belt ($180-$200 in Lincoln dealer)
You can check if pretensionor is good or bad by regular tester, but unless you know how, I won't tell (because I don't wan't you to blow out pretentionor).








Jul 19, 2012 | 2005 Lincoln Town Car

1 Answer

91 honda ex, passenger front seat belt is not working and the light in the dash board keeps lit, I have check the fuses for it, and all the connection to the belt and it seems all intact...any advise?


Your 1991 model Accord has automatic front retracting shoulder belts and, more than likely, the power retractor motor has gone bad on the passenger side front. If the shoulder seat belt is not in the retracted position, up close against the seat, when the car is running, the seat belt light will stay lit on your dash. Have the seat belt motor inspected and replaced if necessary.

Oct 18, 2010 | 1990 Honda Accord

1 Answer

The motor for the front seatbelt wont stop. Is there a fuse to stop it?


There is a connector that provides power to the seat belt motor/sensor in the doorpost (passenger side) or behind the LH wall molding (driver side).
Not sure where the stop sensor is, but I think part of the drive track assembly.

I chose to replace the drive track assembly on my driver side when it was sticking / cutting out in cold weather.
Seat belt drive track

Sep 18, 2010 | 1995 Mercury Villager

3 Answers

Power seats wont move forward


it souns like the switch on the seat has stopped working or the motor itself has gone bad I would check the switch first

Aug 01, 2010 | 2006 Nissan Murano

1 Answer

Automatic Seat Belt. in Honda Accord 91 EX


check fuses or see if something might have got jamed in the track and also try movin the part where the seat belt moves back and forth to see if the motor is dying

Dec 12, 2009 | 1990 Honda Accord

1 Answer

Automatic seat belt drivers side quit working


motor and drive system is bad for the auto belt very simple to change

Jul 21, 2009 | 1990 Ford Tempo

1 Answer

Cant find a fuse!


There Is NOT a FUSE for the Seat Motor I Have Checked The Manual EXTENSIVELY and for seat Fuse AND "RELAY" the Only fuse is for Auto Seat-belt & Warning Light. I Do Believe there Should be A Relay Under the seat This is Where Most Forgen Vehicle Seat Relays are. AlData Shows NO Power Seat FUSE Or Relay though. Seat "BELT" Motor Module is Under Consel At Park Brake Lever Area----------Hope this Helps

May 30, 2009 | 1987 Toyota Camry

2 Answers

1991 CIVIC LX AUTOMATIC SEATBELTS NOT WORKING.


I had a problem on a 91 Civic DX where the drivers auto seat belt wouldnt move and the beeper would not stop.Had a blown seat belt fuse.Replaced the fuse no more problem. The Seat belt fuses are located under the red cover that covers the positive battery terminal. On mine the fuse closest to the font of the car was for the drivers side auto seat belt the one closest to the windshield is for the passager seat belt. They are green and rated at 30A.

Nov 08, 2008 | 1991 Honda Civic

1 Answer

Electical


Original seat belt system stripped the belting that the motor gear drives. old motor had elec. and ran . when I replaced with a salvage yard replacment no power. I ran a test light on the wires going to the motor could not get a pos. indicator for elec. tried the old motor and still nothing.??? Passenger side operates correctly.

Aug 01, 2008 | 1991 Ford Thunderbird

Not finding what you are looking for?
1991 Ford Thunderbird Logo

Related Topics:

107 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

61168 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Fordexpert

Level 3 Expert

5331 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...