Question about Subaru Forester

1 Answer

I have a 2003 subrua forester. i just replaced the cv axle. it still makes a clunking noise when you put it in drive or reverse and try to go.

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Champion:

    An expert who has answered 200 questions.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

  • Expert
  • 231 Answers

Hi the cv may not be pushed into the trans properly, or it could the centre diff getting sick

Posted on Apr 08, 2011

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get 2 Free calls (no credit card required) and instant help on almost anything you can think of (from cars to computers, appliances, handyman, and even pets).
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My car makes a clunk, clunk noise when I am backing up and have the wheel turned and when I am driving and have to make a sudden sharp stop.


You either have a suspension problem like a ball joint, or you may have a worn CV joint in either the left or right drive shaft. Does the noise seem dominant on one side or the other? If so, that is where you want to look. Check the rubber boots on both ends of the drive axles to see if there is any leaking or cracks.

May 28, 2015 | 2003 Hyundai Accent

1 Answer

Why does my 2001 malibu clunk when shift into reverse or drive


check ur cv axles one may be going bad also check steering and suspension system--struts worn, loose --ball joints goin --even tie rods can cause play

May 23, 2014 | 2001 Chevrolet Malibu

1 Answer

Chirping and cv/ clunking noise from rear tyres


be looking u8nder the vehicle at the rear drive axles see if one of the cv joints is possibly broken..if the vehicle is off the ground on a lift..you can rotate the wheels and see the broken axle..

Dec 27, 2013 | Cars & Trucks

1 Answer

Hi my Hyundai Accent makes a clunk noise sometimes when going round a corner. It's not every time. Any ideas? It has just passed it's MOT last month and it wasn't doing it before the MOT.


If it makes a clunk-clunk-clunk sound while turning, it's your front CV joint that's bad. Check to see if the front CV rubber boot is ripped/torn, on either side of the car. The CV boots are located inside/behind the wheels, where the drive axle hooks up to the wheel. If damaged, you will probably have to replace the entire CV axle.

Dec 14, 2010 | Hyundai Accent Cars & Trucks

1 Answer

2003 Chevy Malibu LS. The problem is an intermittent clunking noise that happens during turns, especially when going in reverse and at slow speeds. There is a single clunk during the turn, and another...


Most likely you have a bad drive axle, each drive axle has 2 universal joints and when they get worn they make a big clunk sound. Especially turning or going from forward to reverse.


Please take a moment and rate my answer.............Thanks

Dec 01, 2010 | Chevrolet Malibu Cars & Trucks

1 Answer

2003 Subaru Forester with manual transmission and 170K miles has clunking, jerking feeling when making sharp turns after vehicle is warm.


chances are the temp of the vehicle has nothing to do with it what your probly hearing is a bad cv-axle either turn the wheel all the way to either side and take a look under the car there is a rubber boot buy the wheel if its cracked or torn the grease inside will be thrown out when driving and eventually crack the inside cage.

Oct 22, 2010 | 2003 Subaru Forester

1 Answer

We have an aurora 95 that clunks into reverse


Make turn left noise will be on right, turn right noise will be on left this is CV joints.Make donuts.

Apr 20, 2017 | 1995 Oldsmobile Aurora

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

197 people viewed this question

Ask a Question

Usually answered in minutes!

Top Subaru Experts

yadayada
yadayada

Level 3 Expert

76649 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8518 Answers

Are you a Subaru Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...