Question about 2007 Saturn ION-2 Quad Coupe

1 Answer

Key stuck in the ingition , will only turn back as far as ACC. had to stall the car to shut it off and then disconnect the battery to keep it from draining dead.now how can i get the key out ?

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

I had a similar problem--I'd try to turn off the car & pull out the key & it would get stuck, like it was locked in. The problem that caused this for me was that I had not put the car fully in park--I had to shift out of park & re-shift to get it to stay in park. Once it was fully in park, the key would unlock. Hope this helps!

Posted on May 27, 2011

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

The ignition switch will not turn back to the off position


is your battery dead certain gm vehicles wont completely turn off if battery is dead try jumping car if battery is dead ======if not problem make sure shift select lever is in park if not all the way seated will not release the key also a damaged tumble will do the same also the following link shows how to remove key when stuck in certain vehicles
How To Remove Stuck Ingition Key Yahoo Video Search Results

Aug 22, 2015 | Cars & Trucks

1 Answer

My key is stuck in the ingition switch of my 2003 isuzu axiom it will start the car and turn off to pass the acc point but won' t go to ock and come out


behind key switch youll find a cable just pull on it about 1/2 " it is connected to the button on the shifter easy to fix 1 screw must have fallen out

Oct 26, 2011 | 2002 Isuzu Axiom

2 Answers

1999 jeep shuts off after 10 seconds it is cranked, the security code is p1686. Do not have a key hole on passager side or back of jeep to try to reset it. What can i try?


P1686. The engine controller recieved a invalid key.from the SKIM. It recieve information as the key is in the ignition,key hole on passenger or back will not matter.make sure you can open the vehicle with the key or keep a window down. Try this, 1. Disconnect the battery. and put terminal together(This drains capacitor in PCM and BCM) leave disconnected for 5 minutes. 2. Connect the battery. 3. Put key in ignition and turn to ACC(without cranking it) for 1 minute. Then try to start it. By doing this proceedure disconnection of the battery and reinserting it the the ignition it forces the BCM to relearn its data from the PROM. Like any computer a reboot is all it takes or restart clears the confusion on computers.

Apr 24, 2011 | Jeep Grand Cherokee Cars & Trucks

3 Answers

Key is locked in ignition


Make sure the vehical is in park. If it is not, the key will not release. If you did not turn the key down far enough, or turned it too far, the key is in auxillery and needs to be switched to the off position.

Apr 17, 2011 | 2003 Hummer H2

2 Answers

The key for my 99 mazda 626 is stuck in the ignition in the acc position. The car will start and run, but the battery does not stay charged because of it being stuck. What could cause it to be stuck like...


To unlock and take off the key, try disconnecting the battery; about the charge problem, its possiblke that you have any loss wires from alternator, or the alternator self go to bad.

Keep us updated.

Jan 07, 2011 | 1999 Mazda 626

3 Answers

2002 mazda mpv, key stuck in ingition and it is in park , but the key wont turn all the way to lock, it will only go as far as acc?


Mazda MPV have problems with failing gear shift change assembly ( includes park sensor micro switch)

Pull the fuse for the hazard lights ( 10amp) - if the key comes out, then the switch is defective.

Fix the problem by installing a new change lever assembly - part number for 2000 and 2001 MPV's is LC62-46-10XE with MSRP of $246.90. 2002-2004 would be a LD47-46-10XB with MSRP of $250.40.

May 23, 2010 | 2000 Mazda MPV

2 Answers

Key stuck in ignition


make sure you are pushing in on the key while turning it to the off position

Jun 06, 2009 | 1994 Lexus GS 300

1 Answer

Truck stuck on acc


something is wrong with the shifter going into park or the actual ign. lock assy is faulty

Nov 16, 2008 | Chevrolet Tahoe Cars & Trucks

Not finding what you are looking for?
2007 Saturn ION-2 Quad Coupe Logo

288 people viewed this question

Ask a Question

Usually answered in minutes!

Top Saturn Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8215 Answers

Are you a Saturn Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...