Question about Chevrolet Uplander LS

Open Question

HOW TO SIPHON GAS OUT OF THE TANK ON A 2006 CHEVY UPLANDER, TO REPLACE THE FUEL PUMP ? JUST FILLED UP THE TANK ?

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 236 Answers

SOURCE: I need to siphon the

as you are pushing the hose in the tank twist the hose so it rolls over and it should go in, the hose will probably need to be three feet long, you may have to go to lowes or home depot and get a longer hose that will also fit the siphon pump

Posted on Jan 15, 2011

Ad
  • 124 Answers

SOURCE: 2002 chevy blazer fuel pump (4 door)

yes you have to drop the tank. you will also need a fuel line tool to unhook the fuel lines. before you drop the tank see if tou can reach and wiggle the electrical connection on the top of the tank. these pumps have a pigtail issue. please rate

Posted on Dec 08, 2008

  • 491 Answers

SOURCE: Accidentally put diesel in gas tank on 2009 Chevy Silverado

LOCATE FUEL SUPPLY HOSE , FIND A HOSE GARDEN ONE WOULD DO , GET A HALF INCH COPPER PIPE YOU WILL ONLY NEED A TWO INCH LONG ONE AND TWO JUBILEE CLIPS , NOW CONNECT A HALF INCH OF THE COPPER PIPE TO THE GARDEN HOSE WITH JUBILEE THE OTHER HALF INCH TO THE FUEL SUPPLY HOSE WITH THE OTHER JUBILEE CLIP MAKE SURE THE CONNECTIONS ARE NOT LEEKING , NOW START ENGINE AND YOUR PUMP SHOULD EMPTY YOUR TANK INTO CONTAINER .

Posted on Oct 30, 2009

  • 246 Answers

SOURCE: 2006 Chevy Trailblazer fuel level sensor

You have to drive your car up on metal ramps. Chock your wheel's, have your pressure relived, remove your negative battery terminal, have your fuel pumped out using drill powered pump or drive your vehicle to the reserve point. Loose your tank straps, and lower the tank. Unplug your electrical connectors and pull your tank out under vehicle so you can remove locking flange on top of the tank to remove fuel pump and sending unit out.Replace fuel level sending unit and reinstall it back.

Posted on Dec 30, 2009

ftw1952
  • 10319 Answers

SOURCE: 1988 chevy celebrity No fuel to the carberator.

without starting the engine position the key to the on position.
you can hear the fuel pump operationing for 4 to 6 seconds upon having the key on.
if not heard running check the fuel pump fuse, the fuel pump relay, and the engines oil pressure switch.
they all work the pump you see
the engine oil pressure switch runs the pump untill the engine reaches normal pressure
once the pressure is reached to the normal range the computer shuts that circuit off and turns the fuel pump relay on

Posted on May 22, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How to drain my 2006 Dodge Durango fuel tank


If the pump will still run, you can open a fuel line, maybe use hose on line to aim down into a container and drain that way. Don't take any lines loose unless your sure no pressure on the system. Sometimes you can get under vehicle remove fill hose from gas tank, then use a siphon hose in the gas tank. Your local auto store probably has a plastic siphon hose, that has a squeeze bulb on it to create a siphon, so you don't have to use your mouth. I don't know if that will reach down the fill tube? In my younger years, they called a siphon hose an okla credit card. I'm almost 70 now, don't like getting gas in my mouth.lol

Oct 17, 2016 | 2006 Dodge Durango

2 Answers

Can u easily siphon gas from a 98 montana? We cant get the rear bolt off thermostat housing to change the thermostat and just filled the tank


Cars and trucks manufactured since the late 70's have anti-siphoning screens at the bottom of the fill tube to the tank. So, sorry to say, no you can't siphon this new gas. I can truly commiserate with you as it's happened more than once. I've just filled my tank and the vehicle bites the big one. The only way to get to that gas is to drop the tank.

Oct 09, 2014 | Pontiac Montana Cars & Trucks

1 Answer

Chevy uplander will not start


Have someone turn the ignition on and you listen to verify that the fuel pump did start up.It's inside the gas tank so you have to be quite close to hear it.A sure way to verify if it's the fuel pump is to squirt some quick start fluid into the system through the intake and if turns over you need a fuel pump

Oct 20, 2012 | 2006 Chevrolet Uplander LT

1 Answer

How do you remove the fuel pump on a 1990 Chevy Lumina APV?


The fuel pump is in the gas tank. Drive off or siphon out as much gas as you can. You will need to remove the filler hose. Drop the tank and remove the fuel lines on the top of the tank, Turn the ring counter clock wise that holds the siphon and pump in. Once the ring is loose, lift the the siphon and pump assembly out of the tank. The pump is on the bottom of the siphon. Replace, then reverse the process.

Jun 10, 2012 | 1990 Chevrolet Lumina APV

1 Answer

I need to change the fuel filter in my 2006 chevy uplander i wanted to know if the fuel filter is in the tank or on the out side


Unfortunately it's inside the tank. It's about a 3 hour job to replace so if you go that rout you might as well replace the fuel pump at the same time Sorry for the bad news...;)

Aug 25, 2011 | 2006 Chevrolet Uplander

1 Answer

Looking for the location of the fuel filter on a 2006 chevy uplander 3.5 6cyl.


there is no external filter in the fuel line, filter is in the tank, doesn't need to be changed unless you have a pump failure

Nov 11, 2010 | 2006 Chevrolet Uplander

1 Answer

Chevy uplander 2006 hesitation and loss of power


Check air filter, valve on hose leading to engine, and electrical connection on air intake hose.... vacuum in gas tank loosen gas cap and reseal...bad gas can do this to fill with known good gas and run a tank...spark plugs need replacing @ 100,000 Ks or 60,000 Ms the manual recommends 100,000 but many mechanics have reported that the lower mileage is the actual.....

Sep 09, 2010 | 2006 Chevrolet Uplander

3 Answers

Change fuel filter in a 2006 Chevrolet Uplander


prev.gif next.gif Fuel Filter The fuel filter is part of the fuel tank module. (in the fuel tank)

It's kind of difficult to drop a fuel tank and replace the fuel tank module due to the weight and danger of gasoline catching fire or exploding.

Jul 19, 2010 | 2006 Chevrolet Uplander

1 Answer

1994 chevy pickup won't start


no,you will need to siphon the gas out of the tank.before you do,remove the gas cap,have someone turn the ignition on,while you stand by the tank.the fuel pump should run for a second or two. if it does ,I doubt it is the fuel pump,if it does't,it probably is

Oct 01, 2017 | 1994 Chevrolet S-10 Blazer

1 Answer

I have a 2006 Chevy Uplander. When I fill up the


i had a similar problem and it was the fuel pump

Mar 28, 2009 | 2006 Chevrolet Uplander

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

469 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

76848 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...