Question about GMC C3500

Open Question

Gmc c5500 the brake ligt is on and a beeping sound dont stop

Posted by on

2 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

shocktroop40
  • 155 Answers

SOURCE: 1981 gmc

My 87 GMC did the same thing. Check the ground wires that screw into the radiator support on each side. The right side ground wires were close to the battery on my truck and over the years corroded the ground wires.

Posted on Jan 21, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How to stop beeping


Sound sleek you have two problems. Check your brake fluid level immediately for the beeping and brake light on!
The check engine light is a completely different story.
I recommend you take it to a shop.

Aug 23, 2014 | 1998 Mercedes-Benz C-Class

1 Answer

05 c5500 gmc duramax


run fault codes and check for throttle position sensor.

Jan 06, 2014 | Cars & Trucks

1 Answer

Jurking in the wheel motor completly shut down and all ligts on dash came on when restarted ligts go out and very hard to steer.


Could be alot of things and sounds very serious and dangerous...Need to have mechanic look at it....I would not fill comfortable giving suggestion as to what it could be....PLEASE have mechanic look at it.....good luck and hope info helps...

Aug 16, 2012 | 1997 Chevrolet Cavalier

1 Answer

It pulsates and some times it dont stop and then pedal gets hard


sounds just like me --- its known as old age ,or do you mean the brakes ?? check the brake servo vacumn feed pipe it runs from inlet manifold to the brake servo unit

May 08, 2011 | GMC Sierra 1500 Cars & Trucks

1 Answer

No tail ligt or brake light to trailer hitch plug.


Check the "T" plug where harness is hooked up. Sometimes dust and dirt will get in and cause you to lose connection. I use Electronic silicone grease in the connection to reduce dust accumulation and keep water out.

Apr 10, 2011 | 2003 GMC Sierra

1 Answer

1981 gmc 4 x4 keeps blowing fuze park ligts dont work? grounding out but be nice to have a schematic It takes a 20 amp fuze put a 25 in it the front park ligts came on for only a few seconds then blew....


My 87 GMC did the same thing. Check the ground wires that screw into the radiator support on each side. The right side ground wires were close to the battery on my truck and over the years corroded the ground wires.

Jan 21, 2010 | 1983 GMC C3500

1 Answer

No turn ligth and no stops ligt


gmc had a recall for that problem. It is the switch under the break pedel was installed wrong during manufacturing. Took mine in and they replaced switch.

Aug 09, 2009 | 1994 GMC Sierra

1 Answer

Brakes sound like airbrakes and dont stop right 2001 blazor


You may have damaged your Master Cylinder or have a leaky Caliper Piston.

Jul 13, 2009 | 2001 GMC Savana

1 Answer

The rear ligt stop is not work


brake lite is probably burnt out / had same problem / chnge bulb

Aug 06, 2008 | 2000 Ford Windstar

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

46 people viewed this question

Ask a Question

Usually answered in minutes!

Top GMC Experts

yadayada
yadayada

Level 3 Expert

75051 Answers

Freddy

Level 3 Expert

1311 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Are you a GMC Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...