Question about 2005 Chevrolet Uplander

1 Answer

Seatbelt is stuck, can't pull out - 2005 Chevrolet Uplander

Posted by on

  • Anonymous Feb 25, 2009

    seat belt wont pull out 1989 jeep

  • Anonymous Mar 13, 2009

    The driver's side seat belt on my 2007 Camry will not pull out. If I pull on it, it won't budge. It was working fine yesterday.

×

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Contributor
  • 25 Answers

Possibly the seat belt has been pulled out all the way and the locking mechanism has been activated, if this is the case seat belt must retract all the way back in to reset this function

Posted on Jan 07, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How do i remove plastic panal to remove seatbelt on a 2000 toyota tundra 2 door ?


most door pillar trim is placed under the trim edge for the pillar it should pull back and reveal the edge of the trim panel

Feb 17, 2015 | 2000 Toyota Tundra

1 Answer

How do i release the seatbelt in my 06 freeastar its stuck around the bucket seat


Go to junk yard or salvage yard take A flat head screw driver & A 10mm socket & wrench pop the molding remove both ends of the seat belt belt cost about $5.or 10. bucks change the belt booth ends

Jul 22, 2014 | 2006 Ford Freestar

1 Answer

Xc90 driver seatbelt stuck in pillar


Some cars have a belt release button in the door frame . When you open the door the button releases the seat belt. Check to see if your vehicle has one. Make sure it is not stuck or broken. Hope this helps.

Jan 10, 2014 | 2005 Volvo XC90 2.4

1 Answer

Driver seatbelt stuck, will not release.


in the door sill, there should be a lever or button at the lower portion of the door sill. Push on the lever/button while pulling on the seatbelt while allowing the slack to retract. It takes a few tries before the winding mechanism catches.

Sep 01, 2011 | 2000 Volvo S70

1 Answer

'06 Volvo V50 drivers seat belt is jammed, there is no play in the belt and the ratchet locks immediatly no matter how gently it's pulled. Same problem with passenger side the day before but it righted...


I solved this on my 95 volvo 850 glt as follows:

pull the seatbelt pilar cover off from the door jamb. this runs vertically up the pilar between the front an back door (beside the front seats. Once opened loosen the belt by gently pulling the belt upward toward the roof. You'll have to do this sometimes in small increments. Once the seatbelt is pulled out all the way, spray small amount of lubricant into the joint where at the top of the belt spool. Also use a screw driver to push spool upward while pulling the belt. At first it's only going to release a little but eventually the lubricant will work its way into the seam at the top of the belt spool and loosen up the stuck inertia catch. Until it completely loosens you might have to remove the pilar cover again and work the seatbelt out (also use the screw driver technique described above) in order to use the seatbelt. When parking, I would relatch the seatbelt and pull the slack up around the back of the head rest. After a day or so it worked normally.

good luck and don't give up.

Feb 07, 2010 | 2008 Volvo V50

2 Answers

How do you fix a stuck seatbelt in front seat passenger side? The seatbelt has retracted but will not release outwards to enable its use. We have pulled off interior cover of the seatbelt to get access to...


this is a simple repair many dont know. remove or pull off plastic pillar post cover, seatbelt probably twisted inside. twist it back around so it runs flat and lube slightly with a light lube spray on metal gearing. i had the same problem w mine pk

Jan 16, 2010 | 1998 Ford Taurus

3 Answers

Seat belt stuck on 1995 850 volvo


I solved this on my 95 volvo 850 glt as follows:

pull the seatbelt pilar cover off from the door jamb. this runs vertically up the pilar between the front an back door (beside the front seats. Once opened loosen the belt by gently pulling the belt upward toward the roof. You'll have to do this sometimes in small increments. Once the seatbelt is pulled out all the way, spray small amount of lubricant into the joint where at the top of the belt spool. Also use a screw driver to push spool upward while pulling the belt. At first it's only going to release a little but eventually the lubricant will work its way into the seam at the top of the belt spool and loosen up the stuck inertia catch. Until it completely loosens you might have to remove the pilar cover again and work the seatbelt out (also use the screw driver technique described above) in order to use the seatbelt. When parking, I would relatch the seatbelt and pull the slack up around the back of the head rest. After a day or so it worked normally.

Dec 31, 2009 | 1996 Volvo 850

2 Answers

Driver seat belt will not extend out from door pillar.


I solved this on my 95 volvo 850 glt as follows:

pull the seatbelt pilar cover off from the door jamb. this runs vertically up the pilar between the front an back door (beside the front seats. Once opened loosen the belt by gently pulling the belt upward toward the roof. You'll have to do this sometimes in small increments. Once the seatbelt is pulled out all the way, spray small amount of lubricant into the joint where at the top of the belt spool. Also use a screw driver to push spool upward while pulling the belt. At first it's only going to release a little but eventually the lubricant will work its way into the seam at the top of the belt spool and loosen up the stuck inertia catch. Until it completely loosens you might have to remove the pilar cover again and work the seatbelt out (also use the screw driver technique described above) in order to use the seatbelt. When parking, I would relatch the seatbelt and pull the slack up around the back of the head rest. After a day or so it worked normally.

Nov 05, 2009 | 2000 Volvo S80

1 Answer

99 maxima rear drivers side seatbelt does not retract.


Inertia reels get stuck permanantly if pulled out suddenly over time or after an accident. You may be able to remove it or pull lightly out with little tension and tap on it, if not you may need to replace the inertia reel.

Jan 06, 2009 | 2000 Nissan Maxima

Not finding what you are looking for?
2005 Chevrolet Uplander Logo

1,528 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

70374 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22041 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6878 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...