Question about 1995 Jeep Grand Cherokee

1 Answer

Replaced dist cap and have foregotten how the wires go?

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Jeep Master
  • 17,970 Answers

1995 Jeep Grand Cherokee 5.2 liter V-8 VIN "Y"

replaced dist cap and have foregotten how the - zjlimited_248.gif



1995 Jeep Grand Cherokee 4.0 liter L6 VIN "S"

zjlimited_249.gif


Hope helps (remember to rate this answer). Good luck.

Posted on Mar 16, 2011

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Engine won't start. Getting no spark.


Have you check to see if the timing on the car is right?

Nov 08, 2013 | Cars & Trucks

1 Answer

I have a 92 wrangler 4.0it has NO spark!changed coil,dist,wire,crank sensor and finally replaced wiring harness.still no spark.this has been going on for 4frigin mnths.ive replaced all i can think of


take the dist. cap off and make sure it is turning when the motor turns over if not the dist. drive is bad also I think not for sure it has a cam sensor also

Jan 09, 2012 | 1992 Jeep Wrangler

1 Answer

Crv shut down oil cap lefted off and oil all over engine and truck shutn down checked and found oil fill the spark channel and boots so replace the gasket and plugs and cleaned off the wires and now have...


have you put a new set of plug wires on it. use a spark plug tester, and put it between plug wire and dist, cap. if it is sparking you will see it. if yes and not to plugs put on new plug wires. good-day ! if above checks out. remove dist, cap and see if shaft of dist, is turning. some of the hondas have a plastic type drive gear on bottom of dist, shaft. that goes bad.

Sep 21, 2011 | 2000 Honda CR-V

1 Answer

Multiple missfires on 2000 blazer just off idle. seems better with the map sensor disconnected.4.3


first off, just take distributor cap off and check the cap for corrosion and pitting. turn the dist. shaft by hand. if it turns a lot then the gear on bottom of dist, shaft is worn. you can either replace dist. or replace gear on shaft. check all wires and plugs. hard to say, but i would start at distributor to see if it is ok.

Apr 20, 2011 | 2000 Chevrolet Blazer

1 Answer

Not getting fire to plug wires. I have replaced coil pack, module, dist pickup,and cap. I have tested and have fire to dist but nothing coming out. This is an 86 2.8 comanche 4x4 w/ 4 barrel Holley carb...


You have spark on the coil wire but not coming from the cap. You replaced the cap right. Did you replace the rotor too. Sometimes the rotor burn in the center and the spark goes right thru it in to the distributor shaft.

Aug 11, 2010 | 1986 Jeep Comanche

1 Answer

94 royal begis to cut out, chugs at about 55


Replace the spark plugs and wires along with a distributor cap and rotor. Be careful to leave the old wires and plug wires connected to dist.cap, just remove dist. cap from the distributor and lay aside with plug wires on it then install rotor then new cap and proceed to replace each wire for cap and spark plug one at a time so you don't mix up the spark plug wire firing order. Cap laying to the side is used for reference purpose.

Feb 26, 2010 | 1994 Oldsmobile 88

1 Answer

1993 ecilpse 1.8 eng no spark. there is 12v at the dist


So you have voltage at the distributor and the rotor is turning. Check for voltage at the end of each plug wire. If you do not have voltage there you are loosing it in the wire or the cap. Is the cap new? Are cap and rotor new?
Just be sure you have voltage at every point between the distributor and the plugs.
Good luck!

Trevor Marsh

Jul 02, 2009 | 1993 Mitsubishi Eclipse

1 Answer

1990 Celica GT #4 cylinder is misfiring intermittently


shaft seal in dist is bad may be able to replace might have to replace dist

Feb 18, 2009 | 1990 Toyota Celica

Not finding what you are looking for?
1995 Jeep Grand Cherokee Logo

Related Topics:

118 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Kevin Daniels

Level 3 Expert

1455 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...