Question about 2004 Volkswagen Beetle

1 Answer

The alarm continues to chirp and a motor continues to run, its located at the front of the car near the fan, passenger side?

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Genius:

    An expert who has answered 1,000 questions.

  • Expert
  • 1,114 Answers

I would recommend that you make sure that all of the doors, trunk and hood are closing properly. If they are not fully closing, the alarm will let you know by chirping. If that is to no avail, then I would recommend that you disconnect the battery for 10 minutes and let the alarm reset itself. If that is to no avail, then you may need to change the battery in you key fob, and finally if that is to no avail, you may just have a problem with the system and need to either have it serviced, or replaced.

Posted on Mar 16, 2011

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Where is blower fan relay located


Doesn't it work in any speed ? Could have Blower Motor Control Processor if yours has automatic HVAC .
Or if manual it has blower motor resistor . Both are located under passenger side dash . Remove insulator panel under the dash if it has one !
ORO How to replace blower motor resistor in Chevrolet Silverado

2005 Chevrolet Tahoe Blower Not Working

Sep 28, 2016 | 2006 Chevrolet Silverado 1500

1 Answer

Heater fan or blower motor


The motor should be on the firewall near the passenger side strut tower.

Jan 30, 2014 | 1994 Buick Skylark

3 Answers

Heater motor does not run; check all fuses


The Blower Motor Relay is located:Front seating area, driver side, passenger side of steering column, mounted behind instrument panel

Dec 04, 2012 | 1995 Buick Regal

1 Answer

The fan is stuck blowing on high, the knob turns etc... but the fan and condenser run full blast


Check the connection at the heater blower motor resistor.Wiggle or pull connector off and look for a melted pigtail these get very hot and usally are the cause of fan motor problems.Its located on passenger side of heat duct mounted with 2 screws.

Feb 17, 2012 | 2003 Chrysler Town & Country

1 Answer

FAN MOTOR WONT RUN


common problm on this car. change the fan relay. located underthe rightside( passenger side) of engine compartment under or near the head lamp...

Nov 05, 2009 | 2003 Jeep Grand Cherokee

2 Answers

1996 dodge dakota heater fan not working


FIRST THING MAKE SURE YOU CHECK ALL FUSES UNDER DASH AND IN POWER DISTRIBUTOIN BOX UNDER HOOD LET ME KNOW TAKE TEST LIGHT SEE IF ANY VOLTAGE ON MOTOR IF SO BAD MOTOR IF NO VOLTAGE THEN LOCATE THE BLOWER MOTOR RESISTOR FOR SPEED CONTROL....COMMON PROBLEM... THIS COULD BE LOCATED UNDER DASH ON PASSENGER SIDE IN THE HEATER CORE BOX OR UNDER HOOD PASSENGER SIDE NEAR FIRE WALL...THEY ARE ALSO COMMON FOR BURNING OPEN CAUSING NO FAN

Sep 03, 2009 | 1996 Dodge Dakota

2 Answers

Where is the air coditioner fan andthe


One in the same, are usually up under dash on passenger side, or behind glove box.

Aug 14, 2009 | Dodge Caravan Cars & Trucks

1 Answer

Ai conditioner runs hot on cool setting


ac fan fuse should be in engine comprtment in a labled box near firewall passenger side

May 31, 2009 | 2003 Honda Odyssey

1 Answer

Int. fans keep running hours after eng. shutoff


the problem is not caused by the realy, it is caused by the fan speed control module, it is located near the fan motor on the passenger side under the dadsh behind the glove box, replace it.

Mar 20, 2009 | 1999 Buick LeSabre

2 Answers

The fan for the cooling system is not working and is brand new


There is a sensor on the radiator that controls a relay to turn the fan on. There is also a fuse in the fuse panel under the hood. Make sure the radiator is full.

Mar 13, 2009 | 2001 Jeep Grand Cherokee

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

48 people viewed this question

Ask a Question

Usually answered in minutes!

Top Volkswagen Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

yadayada
yadayada

Level 3 Expert

74945 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7697 Answers

Are you a Volkswagen Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...