Question about 1992 Mercury Grand Marquis

2 Answers

How many amps does it take to turn over the engine on my car its a 92 merc.gran marquis 4.6l everything in side works but when i turn the key i hear one click fr the solinoid this started after i killed the battery on a cold nite

Posted by on

  • terrystarbla Mar 16, 2011

    ok i just tried a new battery fully charged and it did the same thing the soliniod clicked once not repeatedly so im gonna guess i have a loose wire from the solinoid to the starter or a bad sol. or bad starter but the starter worked fine before the old battery went dead eather way ill most likely have to crawl under the car to see about any loose wires right??

×

Ad

2 Answers

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that has over 10 points.

    Mayor:

    An expert whose answer got voted for 2 times.

  • Expert
  • 54 Answers

Generally it takes over 400 cca to turn over a V 8 engine . best thing to do would be charge the battery and then have it load tested at a parts store.

Posted on Mar 16, 2011

Ad
  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Master
  • 3,400 Answers

Try jump starting you car. If that works your battery is need of replacement. To verify jump start, take to any good parts store and have them test your charging system & load test your battery.

Posted on Mar 16, 2011

  • 2 more comments 
  • terrystarbla Mar 16, 2011

    can i use a better battery or do i just jump start it off of a running vehical

  • Mical Caterina
    Mical Caterina Mar 16, 2011

    Really doesn't matter, but I'd use another vehicle so you can get battery "in question" tested while in your car.

  • terrystarbla Mar 16, 2011

    sweet thanks for the input

  • terrystarbla Mar 16, 2011

    used a better battery same result one click from the solinoid im guessing a bad connection from the soliniod to the starter any other ideas ???

×

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2000 Merc gran Marquis randomly engine slows almost to an idle while driving t/c & abs fuse is out I have checked fuel pressure exhaust back pressure on can the t/c be causing this ?


Check engine light on ? Any DTC'S - diagnostic trouble codes ? With the Traction control and ABS fuse in are the ABS ,T/C light on . Check Codes ?

Jan 18, 2017 | Cars & Trucks

1 Answer

1987 Merc Grand Marquis, saving as "collector" car, last ran 6 months ago. Will start, run for 3-10 seconds, then runs out of gas and stalls. Will not start again unless sits for 15 miutes or so. It is...


You need to attach a pressure gauge to the schrader valve and measure the fuel pressure with the key on and also while running. You need to see about 40 lbs in both cases.

Mar 06, 2017 | 1987 Mercury Grand Marquis

2 Answers

Where is the starter located on a 1992 grand marquis?


Look for a sticker on the driver side door jam.

if your car was made up to 2/92 the starter is on the passenger side of the engine above the oil pan on side of engine block, two bolt's hold starter in place into the transmission housing.

if your car was made after 2/92 the starter is on the driver side also next to the engine block with three bolt's into the transmission housing.

Hope this was very helpful.

Mar 31, 2010 | 1992 Mercury Grand Marquis

1 Answer

92 gran marquis shakeing and engine light comes on


you'll need to find out what cylinder is missing ,try tuning it up with plugs and wires.

Jan 23, 2010 | Mercury Marquis Cars & Trucks

1 Answer

1996 merc grand marquis Coil conversion


check out " strutmasters.com " They have what you are looking for. They are on the east coast and have the spring kit. The car will ride just as well and never have a suspension problem again. Trust me on this.

Nov 19, 2009 | 1996 Mercury Grand Marquis

1 Answer

Front side passenger power window not going up or down. All other 3 windows are working fine. 1996 Merc Gran Marquis.


take the door card off see if ther is power to the window motor wen u press the switch, if not my be the switch , if the is window cud be stuck or motor my have had it good luck .

Oct 07, 2009 | 1996 Mercury Grand Marquis

1 Answer

1999 Merc Gran Marquis Need to replace blend door motor. I found a site that said i had to remove dash. I think if i can get the passinger airbag out, including it's cover i can get to it from there. how...


The air bag is bolted in from the back, remove the glove box door and the liner/compartment, I used to get at the motor from there without removing the airbag, it is hard but do-able.

Dec 02, 2008 | 1999 Mercury Grand Marquis

Not finding what you are looking for?
1992 Mercury Grand Marquis Logo

261 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mercury Experts

yadayada
yadayada

Level 3 Expert

76673 Answers

fordexpert

Level 3 Expert

5537 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Are you a Mercury Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...