Question about Pontiac Grand Prix

1 Answer

I replaced both bulbs and checked all fuses but both front turn signals are still out

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Pontiac Master
  • 5,763 Answers

Not sure what type of car this is but the next thing would be to check for power at the socket, you may have bad sockets or wire to sockets is bad, a good way to test is with a test light. if you have power and ground going into the bulb socket then the socket is bad if theres no power or no ground then you will be looking for a bad connection or broken wire, good luck.

Posted on Mar 15, 2011

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
Mikey108
  • 475 Answers

SOURCE: Replace front turn signal bulb on a 1998 Jeep Grand Cherokee

first remave the headlamp and then remove the marker lamp assy.

Posted on Oct 31, 2008

  • 12 Answers

SOURCE: replace the front turn signal light bulb

you should have two tongues holding the main headlamp assembly, they are towards the inside of the engine compartement, slide them off upwards and wiggle the assembly and should come off, once off you'll have access to you signal light, hope it helps

Posted on Dec 17, 2008

  • 7 Answers

SOURCE: left turn signal problem on06' chevy tahoe

check your left light fixture.make sure you have a good contact.sometimes they burnout

Posted on Feb 07, 2009

  • 2 Answers

SOURCE: rt front turn sighal burned out - how to access bulb to replace

There is a latch to the Van's outside just insert a flat blade screw driver and the turn light assembly will swing toward the middle of the van.

Once open the lamps twist out.

Posted on Feb 07, 2009

  • 4 Answers

SOURCE: Replacing front turn signal bulb on 2006 Cadillac SRX

WikiAnswers
http://wiki.answers.com/Q/How_to_change_the_Cadillac_SRX_Front_Tun_Signal_Bulb

Posted on Feb 17, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

69 turn signal problem left turn signal not working. right turn signal causes both to falsh


it's the grounds if they're both flashing fast it's definitely grounds take a test light and see if its got power goes through the test light grounded to the frame and if the light comes on then it's definitely your grounds

Jul 29, 2014 | 1969 Pontiac Firebird

2 Answers

The turn singnals don't flash on my 2004 chevy impala


It's time to replace the flasher relay.The signal flasher is located under the dash near the steering column.Also check for the indicator bulb.Replace them if damaged.
Front Turn Signal Light Bulb Size: 3457ALL
Rear Turn Signal Light Bulb Size: 3057
Hope this helps.Your valuable feedback would be appreciated.Thanks

Jun 11, 2011 | 2004 Chevrolet Impala

1 Answer

Turn signal dosent work


you need to check to see which bulbs don`t work both front and back lights for the signal on the side it`s not working,you don`t say if any signals work or not if no signals work then you need to check the fuses under the dash on the driver`s side.now if it`s just one side then check the lights as mentioned above.if one isn`t then replace the bulb.if neither bulb is working then it sounds like the signal flasher is not working.turn on the hazard flashers and check the lights front and back.if all bulbs work then leave the hazards on and look under the dash for the flasher that is making the noise,this will show what the signal flasher will look like,then find the signal flasher on the fuse panel under the dash it should be located on the fuse panel.and replace

Mar 15, 2011 | 1997 Dodge Ram 1500 Club Cab

1 Answer

Left turn signal lights but will not flash


Check and make sure both front and rear left turn signal bulb light up, if they do, replace the turn signal flasher, flasher sit under dash in fuse box, if one or both bulb don't light up, replace bulb.

Sep 20, 2010 | 1995 Buick Century

1 Answer

I have no signals and when brakes lights are on, lose brake light to either side turn signal is set on


Hi!!

If you activate the turn signal switch and you step on the brake pedal, the turn switch (on the steering column) deactivates the brake light to make the signal light more visible. The bulb for the stop and turn lights is the same.

Turn hazard lights ON. If they don't blink, replace turn/hazard flasher, If one or more lights don't come on, replace bulb.

Check fuse and circuit wiring for broken or loose connections. If all looks fine, check following:

If front turn lights work fine, check brake/turn bulbs.

If turn lights come on but don't blink, replace turn signal/hazard flasher.

If front and back turn lights don't come on, replace switch on column.

Let me know how it worked out, Good Luck

Mar 24, 2010 | 1991 Plymouth Acclaim

2 Answers

Tail lights work on both sides. turn signal and


Sounds like you need to replace the drivers brake/tail light.

Dec 14, 2009 | 1998 GMC Sierra

2 Answers

The front turn signals do not work. The rear turn signals do work. The left turn signal went out first, followed by the right turn signal two or three days later.


Sound like U just need to replace the burned out turn signal bulbs. Does your inside turn indicator blink faster than it use to, cause thats an indication that U have a bad bulb.

Hope U find this helpfull

Matt

Aug 14, 2009 | 1995 Nissan Altima

1 Answer

The turn signals do not work on 2000 nissan exterra.Fuse was blown. Replaced and blew again after a few seconds.


1.Remove front & Rear turn signal Bulbs.
2.Replace Fuse.
3.Signal on.
4.Fix rear Signal Bulb.
5.Fix Front Signal Bulb.
7.If your Fuse blown.
8.Defect is There.

Jun 11, 2009 | 2000 Nissan Xterra

2 Answers

Rear Turn siganls flash fast, both front signals will not flash


flasher relay(in fuse block)weak.also check for other burned out bulbs.

Dec 13, 2008 | 1998 Oldsmobile Intrigue

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

48 people viewed this question

Ask a Question

Usually answered in minutes!

Top Pontiac Experts

yadayada
yadayada

Level 3 Expert

76109 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8270 Answers

Are you a Pontiac Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...