Question about GMC Yukon XL

1 Answer

When driving and going over 30mph my truk starts to shake and vibrate.

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 5 Answers

Bad u joint on the driveshaft or it may be out of balance. they put counter weights on them like they do a tire sometimes they come off you can find a driveshaft co. that will rebalance it for you

Posted on Mar 16, 2011

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Vibration in transmission


I do not know if this vehicle has a torque converter lockup or not, but sounds like it. Does the transmission stop shaking when you go over 65? Some vehicles have a torque converter lockup, which means when the vehicle is traveling at a certain speed in high gear the torque converter "locks" and there is no slippage to the transmission resulting in better fuel economy. if the torque converter doesn't "unlock" when you slow down to say 45 then the engine will "lug" causing vibration. If this is the case you are not hurting anything by driving, just shift to 3 when it shakes then upshift under lighter load, or take it to a shop that replaces transmission sensors.

Jul 22, 2014 | 2004 Toyota Highlander

1 Answer

Altima engine shaking


AC compressor put load on engine causing engine shake vibrate.but check make sure AC compressor mounting bolts tight and drive belt correct tension.now if AC compressor very old most time bad compressor cause more load on engine causing shaking real bad.

May 23, 2013 | Cars & Trucks

1 Answer

While driving something made a popping noise and truck started shaking


sounds like a bad u joint or swing bearing or just something loose in thr drive train

Nov 22, 2011 | 1992 Dodge Dakota

1 Answer

My 2002 CRV steering wheel vibrates-shakes when I brake when I'm going faster than 30mph.


You need to have your front rotors machined or replaced with new brakes.

Jun 08, 2011 | 2002 Honda CR-V

2 Answers

I have a 2003 Spyder, automatic with a 4 cyl engine. The steering wheel shakes at low speeds--below 30 mph, like a bent wheel, but it does not do it all the time or at higher speeds. Also, during moderate...


check your upper control arms, does it happen when you step on the brakes or just when driving, you might need a balance of all your wheels or the tires you have could be bad.

Oct 22, 2009 | 2003 Mitsubishi Eclipse Spyder

1 Answer

Ive just had a new clutch put in, but when ive driven out of the garage ive noticed that the cars steeringwheel vibrates an shakes when i come off the accelerator mainly happens in third at around 25/30mph...


I would suspect that the fly wheel was not balanced when it was machined. If this is something it has done ever since you had the clutch installed I suspect something is amiss in way it was installed. If this vibration gets worse, immediately stop driving this car and have it towed to the shop.

Jun 08, 2009 | 2001 Volkswagen Golf

1 Answer

1998 mustang squeaking wheel bearing


The wheel bearing need to change.
Grease will only cover the problem for a little while.
If you jack the wheel up a little off the pavement.Then try to shake the wheel back and froward. If it shake then the wheeling bearing is getting bad. There suppose to be no shake on the wheel.

Mar 19, 2009 | 1998 Ford Mustang

2 Answers

Engine vibration in drive or reverse


Wow..thats not good..first have motor mounts checked, maybe the tranny mount or possibly if ur car has it is the driveshaft bearings...good luck on the oil leak...maybe tranny fluid..make sure if ur losing fluid that ur checking them incl. the tranny fluid...u might find ur leak first of all by rechecking the oil cap where it is supposed to be ...same with all fluid caps.

Feb 27, 2009 | 1997 Acura TL Series

1 Answer

Break pedal vibrates when braking


Does the steering wheel also shake when you put on the brakes if so it sounds like you're rotors are warped and you will need a brake job

Jan 10, 2009 | 2001 Ford Focus

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

91 people viewed this question

Ask a Question

Usually answered in minutes!

Top GMC Experts

yadayada
yadayada

Level 3 Expert

76132 Answers

Freddy

Level 3 Expert

1311 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Are you a GMC Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...