Question about Chevrolet Suburban 2500

1 Answer

Parking break won't latch when pushing on the foot pedal

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Master
  • 10,319 Answers

If it does not latch or catch in place the part you press on with your foot needs replacing
You can purchase one at any general motors dealership

Posted on Mar 15, 2011

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I I have a Lincoln LS V8 2006 the part break doesn't set and it doesn't appear on the dash keep giving a reading check part break. will not go into gear it doesn't have any brake lights ABS stays on


Hi,I have a 2004 Lincoln LS,start it up,then release parking brake in center console,then push brake pedal with foot,then put in gear and drive.This usually happens when the battery cable has been disconnected,does mine.

Jul 06, 2017 | Lincoln Cars & Trucks

1 Answer

My car only starts when i put my foot on the break


this is normal. The car must also be in park or reverse. If you had a manual trans, you would have to push in the clutch pedal.

Feb 23, 2015 | 1997 Nissan Pathfinder

1 Answer

Brake pedal


Are you talking about the parking break? If the release won't work, gently press on the pedal with your foot will pulling on the release. At some point it should release.

Jan 05, 2014 | Cars & Trucks

1 Answer

I have a 2000 Chrysler 300 and my tire went flat I changed the tire and turned on the parking brake for the first time now the parking brake light won't go off can you help


If this has a foot pedal type brake try pulling the pedal up with your foot as you release it.If not you need to find the light actuator on the e-brake assembly mayby a wire fell off or switch fell out.ive seen this before on other vehicles

Jun 04, 2012 | 2004 Chrysler 300

1 Answer

Hummer H3 airbag light wont go off


Airbag light on in a Hummer H3 Dashboard???Here is the fix...
Start the engine of your car, set the parking brake, hold the regular brake pedal down with your right foot. Push down the parking brakepedal to its fully-applied position with your left foot. Now while you are still holding the regular brake pedal down. Quickly release the parking brake, Pull the bottom edge of the lever, located above the parking brake pedal, with the parking brake
symbol, directly rearward to release the parking brake. Make sure pedal snaps hard all the way back releasing the parking brake... If this doesn't work the first try, try it 3-5 times and it shall work... The airbag light will go off...


NOTE: The parking brake pedal is located to the left of the regular brake pedal, near the driver's door.
&

The parking brake lever is located above the parking brake pedal, with the parking brake symbol.

May 28, 2012 | 2006 Hummer H3

1 Answer

I Have a 1991 Nissan pickup automatic It gets stuck in park and cannot move it to drive sometimes I am putting my foot on the break pedal first


Look under the dash, on the brake pedal arm. There are one or two switches that activate brake lights and/or shift unlock. Check for loose mounting nut or a missing rubber nubber. Is the brake pedal coming all the way back up? Look on the floor for something not usually found there. These switches are adjustable and it may be as simple as adjusting them. Have a helper look for brake lights on and shift lever unlocked while you push and release the switches with your finger. Depress the brake pedal to get it out of the way. Remember to set the park brake first. Could just be a bad switch or loose connector. Check fuses and the bulbs. Is shifter fully in Park? Also try jiggling the turn signal lever.

Aug 29, 2011 | Nissan Pickup Cars & Trucks

1 Answer

Ignition switch will not turn on. Battery is good. Steering wheel is locked, What should we do?


Quite often that will happen when vehicle parked with wheels turned, and/or vehicle on a slope, so try to avoid that in future.If nothing else, when parked on a slope, stop, keep foot on brake pedal, apply parking brake, put transmission in neutral, then take foot off brake pedal and wait for parking brake to stop vehicle rolling, then shift it into park. When leaving, put foot on brake pedal, shift to drive or reverse whatever direction your going, then release parking brake. Sounds like a lot to remember but you won't have to pull hard on shifter as before, and it could save a lot of money on transmission repairs down the road. Always try to park with wheels straight as well.
Now, with that said, if you parked with wheels turned, try hard to turn steering wheel in same direction wheels are turning, just slightly, as you try to turn key. Sometimes a quick yank in that direction will do it. Also make sure shifter is all the way in park before you try it. If your on a slope try rocking vehicle slightly up slope as you push/pull shift lever in to park and try to turn key at same time. If no luck, try pushing brake pedal real hard and try to turn key. Let me know how it goes.

Nov 06, 2010 | 1999 Dodge Caravan

2 Answers

2001 jaguar stype won't shift from park, what do I do?


The brake switch may be bad on the pedal. Brake lights may still work but signal to trans is lost somewhere. First make sure all fuses are ok. Then test the switch. Voltage should be present on one wire then with the pedal depressed the other wires should have voltage.

Nov 11, 2009 | 2001 Jaguar S-Type

2 Answers

2006 chevy uplander/ will crank but can not take out of park


the brake pedal controls a solenoid to release the shifter.
if you do not hear the click when putting on the brake,could be the problem.,,,there is an shift lock override to release it.pop out the little tab and push a key down to release the shifter.

Jul 04, 2009 | 2006 Chevrolet Uplander

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

18 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

77499 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22306 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...