Question about Kia Sportage

Open Question

What dose the btn2 fuse run on 2000 kia sportage its the parisitic load on battery

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 350 Answers

SOURCE: 2000 kia sportage charging.

hi check the main alternator charigng wire the comes out of your alternator see if it is sending a 14v no less reading on a multimeter if not replace the alternator if so go to your battery see if the multimeter readings are the same as the alternator if so do a battery discharge test if not trace the path of the main wire which comes from the alternator to the battery for breaks and all connections yates210456

Posted on Oct 06, 2008

  • 1 Answer

SOURCE: 2000 kia sportage ex, 4 cyl.

For that many codes I would refer you to a bulletin covering the 123 and 124 connectors. This bulletin has instructions on how to upgrade these 2 connectors which connect the engine to the ECM. The connectors are located under the intake manifold towards the firewall. You need to remove the battery, pull the connectors apart, give the male side a slight twist, then you add Stabulent 22 to the connectors and reconnect. The dealerships also add some clips to hold the connectors together better. This task is not an easy one due to the location of the connector. I have done it many times in the past and this helped many of my costomers. Anither thing to check is the continuity to ground at the MAF. This also can indicate bad connection throughout the engine harness. to upgrade this connection, clean the ground connections at the battery and under the battery tray. these simple uperations should have been made into normal maintenance for the 95 - 99 Sportages.

Posted on Mar 22, 2009

Molson02536
  • 3854 Answers

SOURCE: code for kia sportage tape and cd player

You can go to the dealer and have them help you get the code for the radio, if there going to charge you a crazy amount you can try www.radio-code.com. There cost is cheaper and can help you reprogram the code in your KIA. befor you go through all that, check for the code in the glove box, there might be a sticker in there or in your back pages to your manuel.
Good luck and hope this helps yougte your radio wokring again, keep me posted oh and try 0000 first. 

Posted on Jun 07, 2009

  • 1071 Answers

SOURCE: 2000 kia sportage pump is working relays have been

there is a splice for fuel injectors at the front of the fuel rail conduit and electric tape will need to be removed to see if it is ok then clean up all engine grounds and ecm grounds on passenger side kick panel if this doesnt help check coils and crank sensor

Posted on Jul 22, 2009

c17hydro
  • 2984 Answers

SOURCE: the easiest way to pull the heater core from a kia sportage-2000

There is no real easy way to do it....not like the older cars..

  1. Disconnect the negative battery cable.

    CAUTION After disconnecting the negative battery cable, wait for at least 10 minutes for the air bag module to deplete its stored energy.

    1. Remove the driver’s side air bag and steering wheel by performing the following procedure:
    2. Position the front wheels in the straight-ahead position.
  2. Remove the 4 steering wheel-to-air bag module bolts.
  3. Carefully, lift the air bag module and disconnect the electrical connector.

    CAUTION Place the air bag module in a safe location with the front facing upward.

  4. Remove the steering wheel-to-steering column nut.

    NOTE If may be necessary to mark the steering wheel to steering column alignment.

  5. Using a steering wheel puller, press the steering wheel from the steering column.
  6. Drain the cooling system into a clean container for reuse.
  7. Discharge and recover the air conditioning system refrigerant.
    1. Remove the instrument panel by performing the following procedure:
    2. Remove both the rear and front consoles.
    3. Remove the knee bolster assembly.
    4. Remove the “T” bar section.
    5. Remove the relay bracket.
    6. Remove the turn signal assembly and the upper/lower steering column covers.
    7. Remove the hood release handle lockscrew, the hood release handle and the cable assembly nut.
    8. Remove the left side front pillar trim and the lower left side cover.
    9. Remove the 2 left side of the “T” bar-to-chassis bolts.
    10. At the left side of the instrument panel, remove the 3 instrument panel-to-chassis bolts.
    11. Remove the ashtray.
    12. Remove the center panel trim.
    13. Remove the ventilation control panel.
    14. At the center of the windshield next to the windshield, remove the cap and the mounting bolt.
    15. " Remove the right side front pillar trim and the lower right side cover.
    16. Remove the 2 right side of the “T” bar-to-chassis bolts.
    17. At the right side of the instrument panel, remove the 3 instrument panel-to-chassis bolts.
    18. Remove the steering column-to-instrument panel bolts and lower the steering column.
    19. Disconnect the instrument panel electrical connectors.
    20. Remove the instrument panel.
    1. Remove the blower/evaporator housing by performing the following procedure:
    2. Disconnect the air conditioning refrigerant lines from the evaporator core and discard the gaskets. Plug the openings to prevent contamination.
  8. Disconnect the fresh air control cable from the blower/evaporator housing inlet duct.
  9. Disconnect the 5 connectors from the bottom of the blower/evaporator housing.
  10. Move the carpeting from the bulkhead to gain access to the hole cover plate.
  11. Remove the 4 hole cover plate nuts and the plate.
  12. Remove the 2 upper blower/evaporator housing bolts.
  13. Remove the 2 lower blower/evaporator housing-to-bulkhead nuts.
  14. Remove the blower/evaporator housing.
  15. Disconnect the heater hoses from the heater core.
  16. Remove the temperature control cable from the heater housing.
  17. Remove the 2 lower heater housing nuts and the upper heater housing-to-bulkhead nut.
  18. Remove the heater housing.
    1. Disassemble the heater housing by performing the following procedure:
    2. Remove the seal from the heater core tube connections.
    • Remove the vent seal.
    • Remove the 2 wiring harness-to-heater servo screws.
    • Remove the 8 heater housing clips located on the servo side (left side).
    • Remove the left side of the heater housing.
    • Remove the 6 heater housing assembly clips.
    • Remove the 4 heater core tube mounting bracket screws and the bracket.
    • Remove the 8 remaining heater housing clips and disassemble the housings.
    • Remove the heater core from the housing.

  • f277857.gif
    Exploded view of the heater core and heater housing assembly—Kia Sportage


    THIS IS JUST TO REMOVE IT!

    Posted on Oct 18, 2009

    Add Your Answer

    Uploading: 0%

    my-video-file.mp4

    Complete. Click "Add" to insert your video. Add

    ×

    Loading...
    Loading...

    Related Questions:

    1 Answer

    2000 kia sportage the meter fuse intermittingly breaks ,cant figure it out


    My experience with a kia sportage is that the big fuses are simply inserted to the fuse box located in front of the battery at the engine bay. The plastic holders gets brittle over a span of time and due to the heat inside the engine bay. Most often the fuse loosens up and causes fuse blow out. I had 4 successive fuse blows in 2 months time that i decided to change the whole fuse holder with a new one. It Worked

    Oct 02, 2014 | 2000 Kia Sportage

    1 Answer

    2000 Kia Sportage Fuse Problem.


    a wire has wore through somewhere perhaps where t goes through a fender panel a 30 amp fuse is huge so you have a dead short. look front fenders grab wires look for where they may be rubbing from vibration while driving {sharp edge of opening] should be easie to find from a burn mark. dont keep replaceing fuse untill you find the burn spot.[short]

    Nov 21, 2013 | 2000 Kia Sportage

    2 Answers

    2000 Kia Sportage ECM ECU Bad?


    Check the pcm ground pins to make sure they are grounded. 6, 28, 34, and 55.


    0996b43f80250ba5-l15fcbeisfileg1jtnhunp3x-3-0.gif

    Jul 23, 2017 | 2000 Kia Sportage

    1 Answer

    It doesn't start turns over very slowly. replaced starter and fuse. this is a 2000 kia sportage


    go get battery tested and alternator . advance autoparts autozonen free of charge

    Jul 02, 2010 | 2000 Kia Sportage

    1 Answer

    Need to know which fuse contols the air condition in a 2000 kia sportage, dont have the cover inside the hood


    The fuse/relay is a blue 30amp, and may be marked
    ADD. It should be beside the blk/red 30amp fuel inj
    fuse/relay. In the junction block under the hood on the right side, near the battery. Hope this helps.

    Apr 02, 2010 | 2000 Kia Sportage

    1 Answer

    Fuel delivery problem - 2000 Kia Sportage 2WD - fuel not reaching fuel filter, pump is working, relays by fuses are ok, other fuses ok. looking for colored wiring diagrams


    If the pump is running but not putting out any fuel the strainer in the tank could be clogged causing it not to pick up fuel. Also check the fuel pressure regulator and make sure it is working correctly.

    Oct 06, 2009 | 2000 Kia Sportage

    1 Answer

    2000 kia sportage charging.


    hi check the main alternator charigng wire the comes out of your alternator see if it is sending a 14v no less reading on a multimeter if not replace the alternator if so go to your battery see if the multimeter readings are the same as the alternator if so do a battery discharge test if not trace the path of the main wire which comes from the alternator to the battery for breaks and all connections yates210456

    Sep 24, 2008 | 2000 Kia Sportage

    5 Answers

    No Fuel 2001 Kia Sportage


    dosee a KIA Sportage have fule pump reset and if so were is it ?

    May 20, 2008 | 2001 Kia Sportage

    Not finding what you are looking for?
    Cars & Trucks Logo

    Related Topics:

    52 people viewed this question

    Ask a Question

    Usually answered in minutes!

    Top Kia Experts

    Colin Stickland
    Colin Stickland

    Level 3 Expert

    22156 Answers

    yadayada
    yadayada

    Level 3 Expert

    75822 Answers

    Jeff Turcotte
    Jeff Turcotte

    Level 3 Expert

    8210 Answers

    Are you a Kia Expert? Answer questions, earn points and help others

    Answer questions

    Manuals & User Guides

    Loading...