Question about Mitsubishi Colt

Open Question

I have a colt czt 2007 and when i lock the car after a while the car alarm goes on with no reason

Posted by on

6 Suggested Answers

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017

SOURCE: central locking broke on ford focus c max 2004

Fuse No 64 on back of fuse box inside cabin behind glove compartment undo two bolt and turn fuse board around pull the wires gently apart to see fuse 20 amp

Posted on Nov 07, 2008

  • 65 Answers


the factory fit alarm is not voltage sensing .The best advice is to go to VW garage and get them to read the alarm causes,(they can check the last 4).this will give you a good idea where the fault door lock mechanism,interior monitor etc..You cannot start looking for problem until you know alarm cause..

Posted on Feb 10, 2009

  • 1 Answer

SOURCE: Engine Fault Code P1963

I have Mitsubishi colt space star gdi 1.8. which seems to stall either on sitting not moving after a few minutes stalls or if in first gear or when clutch is down and brake especially on hills going down. its a nightmare anyone know what i can do , i have had car serviced but didn't help?

Posted on Jul 21, 2009

  • 149 Answers

SOURCE: The car alarm goes off after I leave my car and

sounds like the hood alarm switch is not making proper contact with the hood, the alarm will not set properly, check the hood alignment

Posted on Oct 08, 2009

  • 1 Answer

SOURCE: my car alarm goes off for no reason

I have the same problem with my Z3 alarm going off, a local BMW specialist has traced it to the pitch sensor which has been damaged due to a water leak, the wires are also corroded. They have quoted £200 to fix it, but advise that the water leak is sealed first because it'll just get damaged again. I've had a look round and it appears the water is getting in by the off side light cluster via the boot gutter.

Posted on Oct 26, 2009

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Alarm will not turn off on uplander

Had the same problem Found out it was a Small break in the soldier joint in the Key holder control.

Simply the bob that goes on your key ring to open the door locks has a bad spot where the contact for the alarm set is bad. If it gets moved,(in your pocket . hanging on a key holder , etc) it will send a signal to the car to check the alarm.

Nov 14, 2013 | 2007 Chevrolet Uplander

1 Answer

What gear oil is used for colt czt 1.5 turbo 2007

If its for your manual transmission, use the standard manual transmission gear oil, available from any major auto parts store.

Aug 23, 2011 | 2006 Mitsubishi Colt

1 Answer

Alarm goes off for no reason. Message center shows hood is "ajar

Hi There isn`t much that can be done here, I would suggest you take the car to the dealership if the alarm is original, if it is after market then take it to any alarm shop, it needs to be reconfigured.
Good luck.

Mar 13, 2010 | 2007 Pontiac Grand Prix GXP Sedan

1 Answer

P code

P1936 is a Clutch Switch/ Sensor Signal problem.
Hope this helps you solve the problem. 

Apr 22, 2009 | 2006 Mitsubishi Colt

1 Answer

Car alarm not activating central locking

It means that the remote is not passing the signal to the car . The alarm has triggered because the system has detected an illegal entry. Replace the remote batteries

Sep 10, 2008 | 2006 Mitsubishi Colt

2 Answers

Theft alarm problem

Same problem here but with a Toyota Sienna '99. It took $600 in diagnostic work but the problem was a low voltage electrical short in a switch that was part of the passenger door lock. Specialty shop found it by placing voltage testing equipment on 4 to 6 wires at a time that ran into the cars computer. They recorded any voltage spikes over all these wires 24hrs/day over 3 days to find the bad switch. Snipping the wire to that switch meant the alarm would always go off if the locked car was opened with a key in the passenger door lock but we we're ok with it. Car was about 5yrs. old when this ocurred but we never had another problem of any kind with it for another 4 years. Thanks, Dan

Jul 08, 2008 | 2007 Hyundai Santa Fe Limited

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

102 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mitsubishi Experts


Level 3 Expert

75744 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8123 Answers

Are you a Mitsubishi Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides