Question about Daihatsu Rocky

Open Question

How do I remove the roof rack rails from a 1997 Daihatsu Terios SX. Not the racks that go from rail to rail, but the rails themselves?

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 840 Answers

SOURCE: Luggage rack cross rail installation

They have torx screw or allen wrench's they just unbolt look at the top and then look on the sides of these extensions as soon as you get them loose you should be able to pull them out/Please rate my response thank you very much

Posted on Jan 31, 2009

Ad
  • 1 Answer

SOURCE: Re-positioning crossbars on roof rack

Hi Its easy to do I did this last night. It is in the manual but light on detail

Remove the rubber and you will see a screw
Use a size 25 torx screw bit and a ratchet as it is in tight. Undo the screw and move the bars.

For some reason there is only one more locking point you can move forward to from there you are on your own but normally it is just the last bit you need.

I believe the logic is to do with a combination of wind noise and the position of the sun roof on some models.

Posted on Jun 30, 2009

SOURCE: Can't secure the front cross rail forward for bike rack

dear friend-the roof rack on a sante fe can not be moved.should you attempt that you will have constant rattles on your roof.i can surgest.that you modify your bike rack.

Posted on Jul 20, 2009

  • 1596 Answers

SOURCE: We have a Chrysler Pacifica

PLEASE EMAIL ME AT YOUR CONVENIENCE

Posted on Aug 01, 2009

  • 507 Answers

SOURCE: How do you remove the roof rails on a 92 Camry SW?

the rails are riveted or screwed to the roof screws are easy obviously,rivets need to be gently drilled out by a drill size that just is a tiny bit larger than the hole in the middle of the rivet and drill till the top of the rivet pops off(not much drilling required,then you need to block off all the holes otherwise the roof will rust through,you may need to clean and seal it carefully

Posted on Nov 18, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How do I install the cross rails on a 2008 suburban roof rack


but that's all you need to do is remove the end piece on both sides and slide the cross rails in and replace the ends

T-15 is the size...Its a good idea to check them regularly if you use the rack regularly...>
Cross rails retaining screws

Mar 07, 2015 | 2008 Chevrolet Suburban

1 Answer

How do I adjust the rails on the roof rack


you should see push in buttons on the rails to unlock them so you can slide the rails forward or back they might be stuck so get some wd40 or PB blaster to free them up

Aug 09, 2014 | Lincoln Navigator Cars & Trucks

1 Answer

How do you move the top rails on a roof rack to adjust for a cargo box ?


ROOF CARGO RAILS ARE WEATHER SEALED TO THE TOP BOLTED UNDERNEATH THE HEAD LINER.YOU HAVE TO GET A LITTLE SMALLER CARGO BOX.

Feb 21, 2011 | 2003 Saturn VUE

1 Answer

Trying to reinstall the roof cargo racks on the rails of a 01 jeep cherokee my son took off and cant remember to put on


That's usually easier to do if you remove one side rail.
There are usually six access holes in the rail that the screws go into. (pretty sure the screws are torx type) Once the rail is off, you can easily attach the cross bars and re-attach the rail to the roof. Ends of cross bars are held on with a screw that goes in from the bottom side. When replacing roof screws it is good to put a dab of silicone sealer on each screw hole to prevent rust or leaks.

Dec 29, 2009 | 2001 Jeep Cherokee

1 Answer

I need to remove the luggage racks from my 2007 Hummer h2 SUT


I have the same vehicle and was able to remove mine with the following steps: 1) remove light behind each rear of luggage rack rail using phillips screwdriver (one screw each side). 2) remove molding underneath each light using T20 torx driver (2 screws each side). 3) Loosen cross rails nobs. 4) Side cross rails off of roof.

Nov 27, 2009 | 2007 Hummer H2 SUT

1 Answer

How do you remove the roof rails on a 92 Camry SW? I was able to get the rack off but not the rails running the length of the roof. They appear to have rivets or some type of square drive screw heads on...


the rails are riveted or screwed to the roof screws are easy obviously,rivets need to be gently drilled out by a drill size that just is a tiny bit larger than the hole in the middle of the rivet and drill till the top of the rivet pops off(not much drilling required,then you need to block off all the holes otherwise the roof will rust through,you may need to clean and seal it carefully

Nov 03, 2009 | 1996 Toyota Camry

1 Answer

Can't secure the front cross rail forward for bike rack


dear friend-the roof rack on a sante fe can not be moved.should you attempt that you will have constant rattles on your roof.i can surgest.that you modify your bike rack.

Jul 19, 2009 | 2007 Hyundai Santa Fe Limited

1 Answer

2000 Rav4 roof rack rails need to be moved further apart.


Ebay for keys--utube video for adjustments

Sep 02, 2017 | 2000 Toyota RAV4

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

104 people viewed this question

Ask a Question

Usually answered in minutes!

Top Daihatsu Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22265 Answers

yadayada
yadayada

Level 3 Expert

77169 Answers

Donald DCruz
Donald DCruz

Level 3 Expert

17130 Answers

Are you a Daihatsu Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...