Question about 2003 Nissan 350Z

1 Answer

How do I get to the reverse lights on my 2003 350z. I need to replace my right side reverse light

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Nissan Master
  • 3,018 Answers

Open your trunk and you will see some twist off caps holding the light assembly in. Unscrew them and gently slide the bulb assembly right out. Revers to resemble.

Posted on Mar 15, 2011

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2001 nissan sentra (released in the phils) reverse or back lights dont work..This car has 4 reverse lights. Left, right and two in the middle (near the plate number).When i put the car in reverse, only the...


sounds like you have a bad ground wire or the wire going to the sides is broken. you may have to check the connections till you find where the wires are connected. if you can test the two side lights with a battery to confirm they do work and are not bad bulbs. or switch them with working light bulbs to confirm they work. then if they work they you need to start looking for a section of wire that may be broken or is corroded and will need to reconnected to make work again.

Sep 17, 2017 | 2001 Nissan Sentra

1 Answer

Only right side reverse light does not work.


There is not any left or right reverse Light switch. It is only one switch for reversing light and it is fitted on the Transmission. If you do have the one working and the other not,first check the bulb if is ok,if not change it. If the bulbs are ok, check for any broken wiring.

May 07, 2013 | 1995 Jeep Grand Cherokee

1 Answer

I have a 1991 Mercury Cougar LS. Intermittently the left brake light will fail to work. The right one works, as does all the rest of the lights,: reverse, park, turn signal, etc, even when the brake


Replace the bulb first, if it still does this replace the socket and make sure the ground for the light is clean and tight and that the connectors for the tail lights are fully clipped together.

Oct 25, 2012 | 1991 Mercury Cougar

1 Answer

Relpaceing reverse light saturn outlook 2008


To replace the reverse light, you have to remove at least partially the inside trim of the rear hatch/lift gate. There's video of doing this on the Chevy Traverse here, which is basically the same vehicle. If you need to work on the right-hand/passenger side, you'll need to remove the plastic cover over the door handle (the inside handle used to pull the lift gate down). The plastic cover snaps on and off, then there are two screws you need to remove. I used the tip from the video link above along with removing the screws under the handle (7mm worked, may not be an exact fit) to replace my passenger side reverse light unit since it was cracked. This was a very easy repair which cost me about $50 for the part, the dealer wanted almost $300 for the full job--shame on you dealers! Hope this helps.

Mar 07, 2012 | 2008 Saturn Outlook

1 Answer

Brake light, reverse light and turn signal issues


Hello. The symptoms you are describing are likely due to a poor ground. Temporarily install a new ground wire by securing a piece of copper wire to the frame with a self tapping screw. Use this ground wire along with the hot wire to see if each of these lights works. If it does, trace the ground wire back to the frame, unscrew it and clean up the metal with emery cloth so you reestablish a good ground.

Jan 28, 2010 | 2003 Ford Windstar

2 Answers

My reverse lights dont work and i need to no where at on trans.


On the side of your transmission will be a switch with several wires coming out of it. This is your reverse switch that turns on your reverse lights and most likely needs to be replaced

Sep 30, 2009 | 2004 Dodge Ram 1500

1 Answer

Replace side marker light on lexus rx300


Remove 3 - 4 screws on fender cover close to side marker light. Pull fender cover out a bit for you to use your other hand to reach side marker light. By twisting on one direction and here you go the light out. Replace new bulb and replace everything on reverse order.

Jul 25, 2009 | 2000 Lexus RX 300

1 Answer

2005 Pathfinder no reverse lights


On the side of your transmission will be a switch with several wires coming out of it. This is your reverse switch that turns on your reverse lights and most likely needs to be replaced

Apr 20, 2009 | 2005 Nissan Pathfinder

1 Answer

1995 Jeep Grand Cherokee Reverse Lights do not work bulbs are fin


If this is an Auto trans, on the left side of the tranny just above the tranny pan is a switch. This is the reverse light switch, replace it.
The switch screws into the side and has a 3 wire connector to it.

Feb 03, 2009 | 1995 Jeep Grand Cherokee

Not finding what you are looking for?
2003 Nissan 350Z Logo

Related Topics:

264 people viewed this question

Ask a Question

Usually answered in minutes!

Top Nissan Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Phil Lovisek
Phil Lovisek

Level 3 Expert

726 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...