Question about Mitsubishi Colt

Open Question

Start car & EPS warning light came on and had no power steeering in colt plus turn wheel when engine runing then started to work again

Posted by on

5 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 76 Answers

SOURCE: engine warning light has come on

you need to have the trouble codes checked with a obd2 code reader.
it could be the throttle postion sensor if the car would not accelerate but there is no way to tell for sure until you see what trouble code the vehicle is throwing. most auto parts stores will check them for free. hope this helps

Posted on Mar 21, 2009

  • 22 Answers

SOURCE: Power steeering started makin a noise & noise

belts were put on too tight or have gotten too loose after they were replaced. the nuts that hold the parts in place may not have been tight enough causing the parts to move , which loosens the belt. maybe the belts were stretched too tight when replaced,....... either will cause squealing...good luck

Posted on Feb 13, 2010

  • 1 Answer

SOURCE: EPS warning light on on my Mitsubishi Colt (2006).

My EPS on my mitsubishi colt 2006 stopped working about 8 months now, I changed the electronic box,but it started to work for ten minutes and then stopped.I carried it by some electricians and they put the computer on it, but it is not getting through.Could someone lend some assistance!!!!!!!!!!!!!!!!!!!!!!!!1

Posted on Jul 08, 2010

luke_bradfor
  • 662 Answers

SOURCE: My car I10 magna 1.1 irde, when engine starts

Ok, with the battery, oil etc lights are governed by simple circuits, and therfore, as soon as they receive power, and earth, they turn off right away.

With the other lights, the malfunction and EPS lights, these go through a self-test function where they check a number of sensors, not just one, and they do this very quickly......the malfunction light checks out 20-35 different sensors, and in less than 1-2 seconds, thats fast.........

However, if they STAY on, then this is where it detects a problem and you should come back and see us again.

If you liked this response, please vote !!!!!!

Posted on Jul 14, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How can i fix my 2003 holden barina `eps warning light from coming on


It'll pay to have the crank sensor checked. They're known for heating up and stalling the car when they're no longer any good. Usually once it has cooled down the car will start but as soon as the sensor gets hot it'll stall again

Aug 28, 2016 | Holden Cars & Trucks

2 Answers

What does eps warning light mean


You have a problem with your engine. Engine Power control System. This is telling you to check your engine. Go to Autozone and have them put a code checker on it and maybe rhey can tell you whar ir needs.

May 10, 2014 | Volkswagen Jetta Cars & Trucks

1 Answer

EPS light


any vehicle of that age will have power steering so a few basic checks to start with ,the power steeering is powered by a pump which is belt driven so check all the drive belts are in good condition/not loose etc ,next check the power steering fluid level, there will be a small resovoir ,usually opaque, with a black screw off top, with pipes leading back to the pump, there will be min/max mark on side of this so make sure the fluid is in that range other than that you will have to take to a repair shop as other causes require expertise

May 02, 2014 | Hyundai Elantra Cars & Trucks

1 Answer

Eps light coming on


1. disconnect the battery both terminals.
2.Look for EPS control module on front passanger deck below dashboard,disconnect the cable connector
3, spray both EPS and cable connector with contact cleaner aerosol.immediately plug in back.
4. Right above EPS module there are Air Con piping make sure the condensate water do not dripped onto EPS module by covering it with plastic sheet.
5. Spray all cables to battery terminal with contact cleaner and connect it back.
6. Start your engine .
In case it still dont work ,you have to look further into EPS motor.
Hope it will solve your problem at least it work for me.

Oct 29, 2013 | 2006 Mitsubishi Colt

2 Answers

Eps warning light is comes on my mitsubishi clot 2005 and the stereeng is getting heavey


Have you checked your power steering fluid? That is most likely the problem.

Jul 30, 2011 | 2006 Mitsubishi Colt

1 Answer

When driving the EPS light on the dash board come on and the sterring become stiff. when i turn off the ignition and start the engine again the EPS light come on and off normally and the every thing return...


EPS stands for Electric Power Steering. Hyundais have electric power steering instead of belt driven pumps. But they still require power steering fluid, Check the fluid to see if it is low. That would trigger the signal to come on.

Dec 22, 2010 | Hyundai Accent Cars & Trucks

1 Answer

My car I10 magna 1.1 irde, when engine starts battery, oil etc warning lights shut off immediately but malfaction light & EPS light shut off one after one. Is this any problem pls clarify.


Ok, with the battery, oil etc lights are governed by simple circuits, and therfore, as soon as they receive power, and earth, they turn off right away.

With the other lights, the malfunction and EPS lights, these go through a self-test function where they check a number of sensors, not just one, and they do this very quickly......the malfunction light checks out 20-35 different sensors, and in less than 1-2 seconds, thats fast.........

However, if they STAY on, then this is where it detects a problem and you should come back and see us again.

If you liked this response, please vote !!!!!!

Jul 14, 2010 | 2007 Hyundai Accent GS Hatchback

2 Answers

The eps light came on and the power steering stopped working. i turned off the engine, turned it back on and then it was fine...what happened?


I have a 2006 Accent and also to me sometimes the eps light turn on while I'm driving. I turn off the car and wait few seconds before to turn on again. But how to repair this problem?

Nov 27, 2009 | 2006 Hyundai Accent

2 Answers

Eps light is on and steering is stiff


EPS is activated only when the driver steers the steering wheel, thus reducing energy loss compared with the hydraulics. Its modular design allows for easy assembly. EPS consists of motor, electronic control unit (ECU), torque sensor and steering gear.
bar.gif Our unique control algorithm allows for improved handling. bar.gif Compact, light weight. bar.gif Capable of controlling motors from 25 to 80A. bar.gif Standardized column integrated or stand alone ECU.Basically its a electrically power steering to assist the driver to turn the steering wheel. Check the electronic control unit(ECU) for any short/burnout and the wiring should be pliable. If not then proper amount of current is not reaching the motor.
The light can light up if there a failure of the motor or any sensor is activated when this circuit has any problem.
Get i checked & repaired from their authorized Dealer and also get a service warranty for the part replaced as per norms out there.
However repair immediately otherwse you might find the steering wheel turning in haphazard manner or it could get locked while driving! .........................................sodeep

Sep 25, 2009 | 2006 Mitsubishi Colt

5 Answers

EPS warning light on on my Mitsubishi Colt (2006).


My EPS on my mitsubishi colt 2006 stopped working about 8 months now, I changed the electronic box,but it started to work for ten minutes and then stopped.I carried it by some electricians and they put the computer on it, but it is not getting through.Could someone lend some assistance!!!!!!!!!!!!!!!!!!!!!!!!1

Feb 01, 2009 | 2006 Mitsubishi Colt

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

30 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mitsubishi Experts

yadayada
yadayada

Level 3 Expert

74896 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7688 Answers

Are you a Mitsubishi Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...