Question about 2004 Chevrolet TrailBlazer

2 Answers

Head light cover

I need to know how to remove the head light cover to 2004 Chevrolet Trail Blazer to replace the blub

Posted by on


2 Answers

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

Step1Your first stop should be to your local auto parts shop to get the bulbs you need. You'll need to pick up #9006 bulb, this one has a gray bas and is used for replacing the outside high beam. If you are looking to replace your inner low beams you'll need to pick up #9005 which has a black base. The bulbs should run you about $16.00 USD. Step2Alright once you have your bulb and are ready to replace it make sure you have popped the hood the release lever is on the inside of your vehicle. Step3While facing your car with the hood open, your going to remove the grill by pushing down on the two retainer clips which are on the top of the grill. You'll need a flathead screwdriver to help you with the rest of the retainer clips. There are two on the bottom ends of your grill one in the center and 2 on each side. Now you'll just pull up on the grill and it should come out easily. Step4On each side of the headlamp you should see a One inch long tab, when you pull up on the tabs it will release the headlamp so that you may pull the headlamp toward you. Pull the head lamp out. Step5There will be two round rubber caps at the rear of the headlamp. Remove the caps and then pull out the wire harness from the bulb.
Replace the bulb or bulbs and remember that #9006 has the gray base and is for the high beam and #9005 is for the low beam and has the black base. Reconnect the wire harness and replace everything to its original position and now you have a fixed headlamp! Congratulations!

Posted on Sep 17, 2008

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 594 Answers

To replace the bulb raise the hood look down to the back of the lens you should see a socket with wires going into your lens. grasp the socket and turn it. that should turn and come out of the lens. replace the bulb and insirt the new bulb and socket and turn the oppisite diection. you should be good to go from there.

Posted on Aug 01, 2008


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Removing headlight switch

Removal and replacing head light switch in a 2007 Chevy Trail Blazer

Jan 09, 2014 | Chevrolet Caprice Cars & Trucks

1 Answer

Hi there, I need help replacing head gasket on 2003 chevy trail blazer LT 6cyl 3rd row, if someone can tell me what to remove to get there? than you !

Unless you are familiar with working on overhead cam engines, this is not a DIY project. To get to the point of accessing the head gasket requires quite a bit of disassembly. Then you need to deal with the cam timing during reassembly.

Aug 12, 2011 | 2003 Chevrolet Trailblazer Ext

1 Answer

Need to change head light on 2003 chevrolet trail blazer

Headlight has a little metal tab on the top of the light that is pulled up, and one on the side that needs to be pulled out also.

Nov 03, 2010 | 2003 Chevrolet Trailblazer Ext

1 Answer

Where are the spark plugs located on a 2003 trail blazer

They are mounted down in the head, underneath each coil pack. You'll need to remove the top engine cover to gain access to them.

Oct 30, 2010 | 2003 Chevrolet TrailBlazer

1 Answer

How to replace head lightson 2002 trail blazer

open hood drivers side the rubber boots at the back of the lens low beam lower boot grasp and remove a little twist helps if not use a flat screw driver to pry back, pass side 3 screws on air cleaner remove and remove cover to get to the lower boot

Sep 24, 2009 | 2002 Chevrolet TrailBlazer

1 Answer

I want to know if the 2004 chevy trail blazer has head light that are on while the vehcile is on. Ignition is on

Yes. Theses are called DRL or daytime running lights.If you depress the emergency brake on it will disable them until the brake is released.

Aug 14, 2009 | 2004 Chevrolet TrailBlazer

1 Answer

Replace head light switch 1996 blazer

First you need to take the lower trim panel off under steering column the you will see the other screws that hold that trim around the head lamp switch, you may want to look for some screws that will go straight up towards top of dash that are in front of the instrument cluster (hard to see) and some may be on the sides of the same trim piece that covers that instrument cluster. let me know

Jan 11, 2009 | 1996 Chevrolet Blazer

Not finding what you are looking for?
2004 Chevrolet TrailBlazer Logo

107 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts


Level 3 Expert

77202 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22265 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides