Question about 1999 BMW 318 ti

1 Answer

PARCEL SHELF TRIM E36 COMPACT

ITS THE TRIM WITH THE CLIP THAT HOLDS THE PARCEL SHELF,HOW DO I GET AT THE FIXINGS TO PUT A NEW ONE ON?

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Genius:

    An expert who has answered 1,000 questions.

  • Master
  • 2,035 Answers

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My back shelf don't go down on my Renault so I can't see behind me


it sounds like the reed switch that activates the parcel shelf is faulty
if the car belonged to me i would go to a renault dealers workshop
they have the knowledge of that roof mechanism and will be able to diagnose and repair

Aug 19, 2016 | 2005 Renault Megane 1.6

1 Answer

Where is the parcel shelf on a 2007 Mini Cooper


The parcel shelf is that flat area behind you head of the rear seat. Normally has speakers or junk on it. On hatch back cars it lifts up as you open the hatch.

Mar 28, 2013 | 2007 Mini Cooper S Convertible

1 Answer

How to replace the third brake light bulb on 2005 ford five hundred


9_5_2012_9_14_11_pm.gif

  1. Remove the parcel shelf.
  2. Remove the 4 high mounted stoplamp mounting screws.
  3. Remove the high mounted stoplamp.
  4. To install, reverse the removal procedure.
Parcel Shelf Removal and Installation


9_5_2012_9_15_32_pm.gif

Sep 05, 2012 | Ford Five Hundred Cars & Trucks

1 Answer

How do you remove the rear speakers from a 2004 chevy impala?


Remove the rear seat. On later models remove the rear upper quarter panel by pulling down & out to disengage the retainer clips, then sliding the roof leg out from under the trim panel over the door. Detach the rear seat belts through the slot in the rear parcel shelf. Pry up the plastic clips securing the rear parcel shelf. Then lift up & out to remove it from the vehicle. Remove the speaker retaining screws or tabs. If the speaker seal has bonded with the metal shelf, hold the tabs & pry the housing away from the metal. Disconnect the electical connector & remove the speaker. Install in reverse order. Good luck!

Feb 22, 2011 | 2007 Chevrolet Impala LS Sedan New Cars

1 Answer

Replacing brake light above trunk on 2006 chrysler


This is quite a process....

Removal
1) Disconnect and isolate the negative battery cable.
2) Remove the rear shelf trim panel.

3ca61c4.jpg
3) Disconnect the CHMSL electrical connector (1).

7bde5c5.jpg

4) Remove the two mounting fasteners (3) to the CHMSL (2).

6793725.jpg

Installation is opposite of removal.

Rear shelf trim panel

Removal

1) Disconnect and isolate the battery negative cable.
2) Remover the right and left lower and upper C-pillar trim.
3) Remove the nut that secures the center rear seat belt lower anchor to the stud on the floor panel and feed the seat belt webbing back through the opening in the top of the rear shelf panel trim (2) to the retractor.
4) Remove the push-pin fastener (1) that secures the trim (2) to the rear shelf panel.
5) Slide the trim forward to disengage the S-clip that secures the underside of the trim to the to the center of the shelf panel.
6) Remove the trim from the rear shelf panel.

24614b2.jpg

Installation

1) Position the trim (2) onto the rear shelf panel(3).
2) Slide the rear edge of the trim rearward to engage the lens bezel of the center high-mounted stop lamp and far enough to engage the S-clip that secures the underside of the trim to the center of the shelf panel.
3) Install the push-pin fastener (1) that secures the trim to the rear shelf panel.
4) Pull the center rear seat belt lower anchor and belt webbing from the retractor through the opening the the top of the rear shelf panel trim and back down to the stud on the floor panel.
5) Install and tighten the nut that secures the seat belt lower anchor to the stud on the floor panel. Tighten the nut to 34 N m (25 ft. lbs.).
6) Reinstall the right and left upper and lower C-pillar trim.
7) Connect the battery negative cable.

841a5de.jpg

C-pillar trim removal

1a140ec.jpg

5ad047d.jpg

b674bd4.jpg
cf360b2.jpg

cd4ac09.jpg
2e5b4da.jpg

Seat removal

d276bae.jpg
60b3895.jpg

469e099.jpg

087d2a6.jpg

3ad2dc9.jpg


a09baad.jpg
4981771.jpg


Hope this all gets it done for you........

Feb 23, 2010 | 2006 Chrysler 300

1 Answer

Roof opens but parcel shelf does not on audi 80 convertible 1998


audi 80 cabriolet 1998. roof open but parcel shelf does not.

Feb 17, 2010 | 1998 Audi Cabriolet

1 Answer

How to remove the rear speaker panel for a 1997 dodge neon


Remove entire rear seat assembly
Pry out the rear portion of the seat belt trim bezel.
Partialy remove the rear parcel shelf trim panel, slide it down and out of the way.
Remove the screws and detach the speakers.
Installation is reverse of removal, making sure that wire connectors face toward the center of the vehicle

Dec 30, 2009 | 1997 Dodge Neon

1 Answer

How do i get the back parcel shelf out of my bmw 530d so i can tint the rear window? and also the back seats to get the parcel shelf out ?


Why do you need to remove the parcel shelf and the seats just to tint the window?
If you are using film tint lay it on the outside of the window cut it a little larger than you need it. Clean the inside rear window then use a squirt bottle with soapy water in it spray the window roll out you tint using a squeegee to remove air pockets. Finally trim the edge with a razor blade window tinted.

Aug 31, 2009 | 2002 BMW 5 Series

1 Answer

Honda Accord brake light removal


It's a lot of work for just cleaning.
Fold the rear seat down and remove the two 12mm bolts on the bottom corners of the seat back, pull the seat out.
Between the seat bottom and the carpet you will find two tabs you need to pull and then pull the seat bottom up and out of the car.
Remove the two 10mm bolts securing the seat bolsters to the area the seat bottom was covering. Pull the seat bolsters up and out of the car.
Pop the "C" pillar trim off of the car (above the parcel shelf and beside the rear glass) (side airbag vehicles have a slightly different procedure.)
Pull up on the parcel shelf carefully and evenly. Remove clean and put everything back together.

Aug 16, 2008 | 2005 Honda Accord

1 Answer

Changing Rear Speakers in a 1996 a4.


First remove the rear seat bottom cushion (grab the front edge roughly in the center of each seat position and pull up firmly, and it'll unclip and come out). Then fold down the rear seatbacks. Now, the side bolsters for the seats (between the seatbacks and the doors) have to come off. First, pull down strongly near the bottom (there's an upward-facing hook there that clips onto a ring and holds the bottom in place). Pull down and forward and it'll come off. Then slide your hand about 75% of the way up, and pop the bolster straight forward to pop out a retaining clip. Finally, you can remove the top of it from its mount, and you'll have the bolster out. Repeat for the other side.

Go into the trunk and look up at the bottom of the rear shelf. The harness plug for the third brake light is there - unplug it.

Now, back in the rear seat area, just grab the front edge of the parcel shelf and lift upward to pop it loose, and the whole thing will slide forward. Then you can remove your speakers.

Install is the reverse of disassembly.

Jul 30, 2008 | 1996 Audi A4

Not finding what you are looking for?
1999 BMW 318 ti Logo

Related Topics:

409 people viewed this question

Ask a Question

Usually answered in minutes!

Top BMW Experts

Fred Sops

Level 2 Expert

271 Answers

Al Clark

Level 2 Expert

290 Answers

Doberman

Level 2 Expert

246 Answers

Are you a BMW Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...