Question about 2005 Mazda Millenia

1 Answer

Do u have a diagram of where the thermostat goes. Which hose do i take off?

Posted by on

  • elcee055 Oct 27, 2008

    A/C works, but engine will not produce heat (hot air). All blower outlets (defrost, cabin, foot) are clear. Cannot locate thermostat. Would appreciate a diagram/further instructions about replacement of same.

  • ikennygu Dec 30, 2008

    I don't have any heat for the cabin. I don't think it's the thermostat because the engine never over heats or under heats in 10 degree weather. Both hoses from the heater core gets hot so that's circulating fine. I have no idea.

×

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

The thermostat is located on the driver's side where the hose from the radiator attaches to the housing. The bolts (3) of the housing screw in from the bottom up.
The cabin heat problem is most likely an air blend door stuck in the "cold" position (you may have a defective actuator motor: electric or vacuum operated). Some older vehicles had a cable operated blend door.

Posted on Apr 22, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Engine Diagrams


Hello. Here a non-photo diagram. Hope this helps!!!

The thermostat is located on the side of the water pump, the water pump is located just above the a/c compressor, the thermostat is fed coolant from the radiators lower radiator hose.
Thermostat :
1. drain coolant and tighten drain plug ( easier method : remove radiator cap, get big drain pan, place drain pan under lower radiator hose to radiator connection, remove clamp, slowly remove hose, allow coolant to drain into pan, now is a good time to remove radiator hose and clamp from thermostat housing )
2. remove thermostat cover / cap ( easiest to get at this when front of car is supported by jack stands and right hand side lower cover is removed ).
3. thermostat cap is held on by 3 bolts / remove thermostat.

You will notice that the thermostat's air bleed hole is pointing up and lines up with notch in water pump housing,,

ATTENTION :failure to install new thermostat in the correct location will cause engine to overheat.

1. install new thermostat to water pump, make sure air bleed hole lines up with notch, install and tighten bolts, install a new lower radiator hose, fill cooling system.

thermostat # 17670-77E00
lower radiator hose #17854-65G20
hose clamp #09401-36403
upper radiator hose # 17852-65G20

Suzuki factory manual

Oct 21, 2013 | Cars & Trucks

1 Answer

Engine Diagram 2007 kia sportage


With conventional cooling system, the upper radiator hose goes to thermostat housing on the engine. You drain antifreeze down, a little, remove radiator hose from thermostat housing, remove thermostat housing, the thermostat should be inside the housing.
Some antifreeze is poisonous, dispose of properly.
Install new thermostat, hook everything back up. Add proper amount of antifreeze to the proper mark. Keep an eye on antifreeze level for a while till your sure all air worked out of the system.

Nov 04, 2011 | 2007 Kia Sportage 4x4 V6

1 Answer

How to change a thermostat


Hi.

  1. Locate the thermostat housing. The housing can be found following the radiator hose toward the engine. The housing is located on the engine.
  2. Remove the three screws that hold the thermostat housing.
  3. Replace the thermostat.

Note. The thermostat spring goes toward the engine, the other side toward the radiator.

Here a diagram:

ginko_296.gif

Regards.

Ginko

Aug 22, 2011 | 1999 Ford Taurus

2 Answers

I need the location of the thermostat on my 2006 chevy monte carlo 3.5 flex fuel engine


The thermostat is in the housing on the front of the engine where the radiator hose attaches. see diagram attached

ghaynes904_0.jpg

Jan 07, 2011 | 2006 Chevrolet Monte Carlo

1 Answer

Over heating, could you please tell me or show me in a diagram where the thermastat is.


the thermostat is in a small bellshaped housing which is attached to the engine block. the housing has a hose stuck on it which goes to the radiator. generally the hose which attaches near the top of the engine as opposed to the hose which attaches at the bottom. seldom does a thermostat simply plug up, but it is generally the easiest part to replace.

Sep 13, 2010 | 1984 Toyota Celica

1 Answer

Just need to know exactly where the thermostat is located... diagram pic would be nice


Most of the time a thermostat is located where the radiator hose goes into the engine block on top of thr engine not underneath the radiator.

Sep 01, 2010 | 1998 Saturn SL

1 Answer

Thermostat installation for nissan pick up 1996


Follow the top radiator hose. It goes right to the thermostat. Make sure that the little hole in the new thermostat it up when installing.

Aug 02, 2010 | 1996 Nissan Pickup

2 Answers

Where is the thermostat located in a 1999 chevy monte carlo 3.1 and is there a diagram I can see to see if I can fix the car my self. Thanks Shirley


the thermostant is behind the exhaust crossover pipe, this is the pipe that connects the front exhaust manifold to the rear, the housing is behind that, its a tight fit,also if you follow the upper radiator hose from the radiator to engine the housing that the hose goes to is where the thermostant goes,heres a diagram, hope this helps,

May 20, 2010 | 1999 Chevrolet Monte Carlo

1 Answer

Where is the thermostat in kia rio 2003.(diagram or pics)


the best way to find the themostat housing is to follow you upper radiator hose down to the engine and normally it is in the housing that you hose goes to on the engine!

Aug 07, 2009 | 2003 Kia Rio

2 Answers

I need a diagram of the location of the thermostat in a 1996 Dodge Caravan


Follow the top radiator hose to the engine. This is where the thermostat housing is located. Remove the bolts and take out the thermostat. When you get your new thermostat, get one from Autozone with a jiggle valve. The jiggle valve should be oriented near the top of the housing (the thermostat is not perfectly round, you'll have to play with it a little to get it to seat). Install with the spring side facing the engine and the gasket on the engine side of the housing. You can use some spray adhesive to keep the gasket in place while you install the thermostat.

Jul 18, 2009 | 1996 Dodge Caravan

Not finding what you are looking for?
Cars & Trucks Logo

522 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mazda Experts

yadayada
yadayada

Level 3 Expert

70365 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22041 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6878 Answers

Are you a Mazda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...