Question about Saturn Ion

Open Question

How hard is it to replace the heater blend door actuator.Ours is knocking very loud.2007 saturn ion.Thanks

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 1 Answer

SOURCE: blend door actuator needs replacing does the

no it doesnt ... check out heatertreaters.net if you have to replace the blend doors .... but the actuator is directly behind the glove box...remove the glove box take out 3 screws and remove actuator and replace.....waa laa

Posted on Nov 25, 2009

ewashmidas
  • 362 Answers

SOURCE: Are my struts out on my 04 Saturn ION?

I agree. I see sway bar links go bad and make nosie much more often than struts on Ion's. Take it to a service center you trust.

Posted on Jan 25, 2009

  • 19 Answers

SOURCE: location of body control module on 2007 saturn ion

Bcm and fuse box are one piece, located in front of center console, just under the heater controls.  Remove side panels from console on both sides.

Posted on Aug 23, 2009

  • 236 Answers

SOURCE: Where is the blend door actuator located? Is it a

buried in the dash, about an 8 hour job.

Posted on Oct 13, 2009

  • 1 Answer

SOURCE: NO heat in front of 2001 windstar van. Thumping

where is the flaaper down located at in a windstar

Posted on Dec 04, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How do I replace the air blend door on a 2007 Saturn Aura xr. Thank you.


Temperature Valve Actuator Replacement
Remove the fuse labeled HVAC CTRL (BATT).
Completely open the instrument panel compartment door by pressing both tabs that support the stop bumpers. Refer to Instrument Panel Compartment Replacement .
Disconnect the air temperature actuator electrical connector.

1
Air Temperature Actuator Screw (Qty: 2)
Notice: Refer to Fastener Notice in the Preface section.
Tighten
1.5 N·m (13 lb in)
2
Air Temperature Actuator
Tip
Do not adjust any controls on the HVAC control assembly while the HVAC control assembly and actuators are calibrating. If interrupted improper HVAC performance will result.
Refer to Control Module References for programming and set up information.

Nov 20, 2016 | 2007 Saturn Aura XR

1 Answer

Blend door actuator is there a fuse or relay


No there is not a fuse that JUST runs the blend door actuator. You likely have a jammed blend door and that destroys the little gear drive in the actuator motor. Good luck.

May 17, 2016 | 2007 Ford Freestar Limited Minivan

2 Answers

How do I find the ac heat acuator on a 2001 Pontiac Bonneville sle.


How To Install Replace AC Heater Temperature Actuator ...

? 4:40
https://www.youtube.com/watch?v=mVP09M7hLB4
Jul 21, 2014 - Uploaded by 1A Auto Parts
http://www.1aauto.com/temperature-blend-door-actuator/i/1ahcx00293 ... How To Remove Install Door Chevy Monte Carlo Pontiac Grand Prix ...

GM Blend Door Actuator Repair (Saturn, Chevy, GMC, Buick ...

? 4:28
https://www.youtube.com/watch?v=fER3ZqnYLZg
Jul 11, 2014 - Uploaded by willmacneill
The procedure is the same for most GM blend door actuatorsfrom 1990-2013 (found in many vehicles made by Chevy, GMC, Buick, Pontiac, ...

Mode/Temperature Door Actuators May Fail : Pontiac ...




Jan 16, 2016 | Pontiac Cars & Trucks

1 Answer

Blend door on 2003 montr carlo


How To Install Replace AC Heater Temperature Actuator ...

? 4:40
https://www.youtube.com/watch?v=mVP09M7hLB4
Jul 21, 2014 - Uploaded by 1A Auto Parts
http://www.1aauto.com/temperature-blend-door-actuator/i/ ... To Install Replace AC Heater Temperature Actuator 2000-05 ChevyMonte Carlo.

2006 Monte Carlo: Blend Door Actuator Replacement ...

? 2:19
https://www.youtube.com/watch?v=_B17o-Ljhfs
Mar 31, 2015 - Uploaded by Adam Strojny
In this video I will show you guys how to replace the actuators behind the glove compartment that where causing ...

Chevy Blend Door Actuator Replacement - Part 3 - YouTube

? 12:26
https://www.youtube.com/watch?v=1q9ugwlqDoo
May 14, 2013 - Uploaded by Dan Abbott
My final step to replacing the blend door actuator. ... Thanks for the video, need to do this on my 04 monte carlo ss, went to use the heat today .... 2003 Chevy Suburban AC-heater air direction problem.mov - Duration: 1:36. by ...


Dec 26, 2015 | Chevrolet Monte Carlo Cars & Trucks

2 Answers

I have a 2001 saturn sl2. No heat. I have flushed heater core today and replaced thermostat. Heater lines are warm. No other problems or leaks. What is causing no heat? Its cold all the time.


If after running the engine for 5 min both heater hoses are hot, it could be a blend door problem where air is not flowing thru the heater core. You may need a shop manual to troubleshoot the control.

Nov 23, 2015 | Saturn Cars & Trucks

1 Answer

BLEND DOOR FLAP STUCK HEATER WONT BLOW HOT AIR


under the dash center of vehicle on the drivers side of the heater case.

Nov 10, 2013 | 2006 Saturn ION

1 Answer

Where is the blend door actuator located


The blend door is on the heater box, you will neeed to turn heater on with low air setting as you look around box to locate it, it is hard to say exactly where it is on the box due to its been a while since i replaced one, let me see if i can get a diagram. this is a 1999 ford taurus.

Okay the actuator on this car is located on the box on the passenger side, if you look from passenger side toward center of the dash you will see it bolted to box below radio area, you may need to remove the lower dash covers. here is a picture to help you.10_24_2012_11_35_10_am.gif

Oct 24, 2012 | 1999 Ford Taurus

1 Answer

We replaced the blend door actuator and heat control switch on a 2005 ford explorer now we get heat when you swith the contro from one side to the other then theres a loud boom like the blend door is


You should have replaced the blend door as well, they have an issue with warping and the noise is the door being broken free by the actuator, which will shortly fail working this hard to move the warped door. Have you ever heard of a kit to do this without removing the dash called "Heater Treater", google it.

Jan 20, 2012 | Cars & Trucks

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

751 people viewed this question

Ask a Question

Usually answered in minutes!

Top Saturn Experts

yadayada
yadayada

Level 3 Expert

75817 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8180 Answers

Are you a Saturn Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...